Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 3 — y = f(x + 2) is f(x) translated 2 units to the LEFT (inside the bracket, adding moves the graph in the negative x-direction). The root moves with the whole graph: 5 − 2 = 3. Moving right instead of left gives 7; assuming a bracket shift leaves the root unchanged gives 5; writing down the shift amount 2 itself skips the translation altogether.
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (b) 25 — The tangent at (9, 12) is 9x + 12y = 225. Setting y = 0 (the x-axis): 9x = 225, so x = 25. Choosing 18.75 comes from swapping the coefficients in the tangent equation (using 12x + 9y = 225) before setting y = 0. Choosing 15 is where the circle itself meets the x-axis (from x² = 225), not where the tangent does. Choosing 9 is just the x-coordinate of the original point (9, 12), not the point P.
- (b) 3 — Method: a term is any part of an expression separated from the rest by a + or − sign, including a number on its own. Working: 8 − 3x + 5x² splits at the + and − signs into 8, −3x and 5x² — that is three separate terms. Answer: 3. Ryan's answer of 2 comes from wrongly excluding the number 8, thinking a term must contain a letter. 5 comes from miscounting by treating the coefficients and powers as separate terms as well as the letters. 1 comes from treating the whole expression as a single term because it is written without brackets.
- (b) (0, −2) — Method: a translation acts on the two coordinates separately: moving right or left changes the x-coordinate only, moving up or down changes the y-coordinate only, and right and up add while left and down subtract. Working: the point starts at (−4, 7); moving 4 units to the right gives an x-coordinate of −4 + 4 = 0; moving 9 units down gives a y-coordinate of 7 − 9 = −2. Answer: (0, −2). The distractors: (5, 3) comes from pairing each number with the wrong coordinate, adding 9 to −4 and taking 4 from 7; (0, 16) comes from treating 'down' as an addition, giving 7 + 9 = 16 for the second coordinate; (−8, −2) comes from treating 'to the right' as a subtraction, giving −4 − 4 = −8 for the first coordinate.
- (b) (x − 3)/(x + 2) — Factorise both: x² − 9 = (x − 3)(x + 3) (difference of two squares), and x² + 5x + 6 = (x + 2)(x + 3) (two numbers multiplying to 6 and adding to 5, namely 2 and 3). The factor (x + 3) is common to both, so it cancels, leaving (x − 3)/(x + 2). Choosing −9/(5x + 6) comes from cancelling the x² terms directly without factorising first — x² is not a common factor of the whole numerator or denominator. Choosing (x + 3)/(x + 2) cancels the (x − 3) factor instead of the shared (x + 3) factor, and (x − 3) does not appear in the denominator to cancel with. Choosing x − 3 cancels the whole denominator (x + 2) as though it were equal to 1.
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
- (a) x > 4 — Subtract 2x from both sides: 3x − 3 > 9. Add 3 to both sides: 3x > 12. Divide both sides by 3: x > 4. A candidate who subtracts 3 from 9 instead of adding gets 3x > 6, so x > 2. A candidate who divides correctly but wrongly flips the inequality (as if dividing by a negative) gets x < 4. A candidate who multiplies by 3 instead of dividing gets x > 36.
- (d) Below y = x + 1, below x + y = 5, above y = 0 — For y ≤ x + 1, R lies on or below the line y = x + 1. For x + y ≤ 5 (that is, y ≤ 5 − x), R lies on or below that line too. For y ≥ 0, R lies on or above the x-axis. Combining all three: R is below y = x + 1, below x + y = 5, and above y = 0. Distractor routes: "Above y = x + 1" flips the first inequality, describing the wrong side of that line. "Above x + y = 5" flips the second inequality, describing the wrong side of that line. "Below y = 0" flips the third inequality, describing the wrong side of the x-axis.
- (a) y = −3x − 5 — Gradient = (−8 − 4) ÷ (1 − (−3)) = −12 ÷ 4 = −3. Using the point (1, −8): −8 = −3(1) + c, so c = −5, giving y = −3x − 5. A candidate who drops the negative sign on the gradient, using m = 3 instead, would then solve −8 = 3(1) + c to get c = −11, writing y = 3x − 11. A candidate who makes a sign error isolating c, writing c = 5 instead of −5, would write y = −3x + 5. A candidate who mixes up both mistakes — keeping the correct gradient but the wrong, positive value of c from the flipped-gradient calculation — would write y = −3x + 11.
- (a) 27 — Method: let the smaller number be n, so the larger number is n + 9. Form the equation n + (n + 9) = 45. Working: simplify: 2n + 9 = 45, so 2n = 36, giving n = 18. The larger number is 18 + 9 = 27. Answer: 27. 18 is the smaller number, found correctly, but given as the answer to the question asking for the larger number. 22.5 comes from ignoring the "9 more" part and simply halving the total, 45 ÷ 2. 36 comes from a sign error when isolating the constant, treating the equation as 2n = 45 + 9 instead of 2n = 45 − 9.
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (d) 11 — f⁻¹(x) = 5 means x = f(5), since applying f to both sides undoes the inverse. f(5) = 2 × 5 + 1 = 11. Writing 2 comes from confusing f⁻¹(x) = 5 with f(x) = 5, and solving 2x + 1 = 5 instead: 2x = 4, x = 2. Writing 9 comes from finding f⁻¹(x) with a sign error, f⁻¹(x) = (x + 1)/2 instead of (x − 1)/2, then setting this equal to 5: x + 1 = 10, x = 9. Writing 6 comes from finding f⁻¹(x) without dividing by 2 at all, f⁻¹(x) = x − 1, then setting this equal to 5: x = 6.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
Build your own mix at the worksheet builder.