Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (a) Underestimate: the chord lies below the curve — For a curve that is concave down (bending downward), the straight line joining any two points on the curve lies BELOW the curve. The trapezium's top edge is this straight line, so the trapezium's area is smaller than the true area under the curve — the trapezium rule UNDERESTIMATES the distance in this case. This is because a curve whose gradient keeps decreasing bends away from any chord joining two of its points, dropping the chord below every point of the curve in between. The reverse, a chord lying above the curve, is the rule for a concave-up curve, not this one — check which way the curve bends before deciding. The trapezium rule does not always overestimate or underestimate, and it is not exact except when the graph really is a straight line.
- (c) 15 and 9 — Method: write the two facts as two equations in the same pair of letters and add them, because the letter with opposite signs cancels. Working: with x the larger number and y the smaller, x + y = 24 and x − y = 6; adding gives 2x = 30, so x = 15, and substituting into x + y = 24 gives y = 9. Answer: 15 and 9, which add to 24 and differ by 6. The distractors: 18 and 6 come from halving 24 to 12 and then adding and subtracting the whole difference of 6 instead of half of it, which leaves a difference of 12; 15 and 21 come from finding the larger number correctly and then adding 6 to it instead of subtracting; 15 and 6 come from finding the larger number and then taking the 6 in the question to be the smaller number itself.
- (b) −2, −1, 0, 1, 2, 3, 4 — Factorise x² − 2x − 8 = (x − 4)(x + 2), giving roots x = 4 and x = −2. Since the coefficient of x² is positive and the inequality is ≤ 0, the solution is the closed interval between the roots, −2 ≤ x ≤ 4, with the roots included because the inequality is not strict. The integers in this interval are −2, −1, 0, 1, 2, 3, 4. Distractor routes: −1, 0, 1, 2, 3 drops both endpoints, treating ≤ as if it were the strict inequality <. −2, −1, 0, 1, 2, 3, 4, 5 comes from mis-factorising as (x − 5)(x + 2), giving an upper root of 5 instead of 4. −3, −2, −1, 0, 1, 2, 3 comes from mis-factorising as (x − 4)(x + 3), giving a lower root of −3 instead of −2.
- (b) (0, −2) — Method: a translation acts on the two coordinates separately: moving right or left changes the x-coordinate only, moving up or down changes the y-coordinate only, and right and up add while left and down subtract. Working: the point starts at (−4, 7); moving 4 units to the right gives an x-coordinate of −4 + 4 = 0; moving 9 units down gives a y-coordinate of 7 − 9 = −2. Answer: (0, −2). The distractors: (5, 3) comes from pairing each number with the wrong coordinate, adding 9 to −4 and taking 4 from 7; (0, 16) comes from treating 'down' as an addition, giving 7 + 9 = 16 for the second coordinate; (−8, −2) comes from treating 'to the right' as a subtraction, giving −4 − 4 = −8 for the first coordinate.
- (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
- (b) Translate +5 in x, then reflect in the x-axis. — Translating y = x² by 5 units in the positive x-direction gives y = (x − 5)². Reflecting this in the x-axis, which replaces y with −y, gives y = −(x − 5)², matching the target. Using a translation of −5 in x instead gives y = (x + 5)², and reflecting that in the x-axis gives y = −(x + 5)² — the sign inside the bracket is wrong. Reflecting in the y-axis first does nothing to y = x², since (−x)² = x², so translating afterwards only reaches y = (x − 5)² with no negative sign at all. Translating by 5 units in y instead of x gives y = x² + 5, and reflecting that in the x-axis gives y = −x² − 5, a different curve altogether — a vertical shift does not create the (x − 5)² term the target equation needs.
- (d) 2x² − 4x + 3 — fg(x) means f(g(x)): substitute g(x) into f in place of x. g(x) = x − 1, so fg(x) = f(x − 1) = 2(x − 1)² + 1. Expanding (x − 1)² = x² − 2x + 1, so fg(x) = 2(x² − 2x + 1) + 1 = 2x² − 4x + 2 + 1 = 2x² − 4x + 3. Writing 2x² comes from working out gf(x) instead — g(f(x)) = f(x) − 1 = (2x² + 1) − 1 = 2x², which applies the functions in the wrong order. Writing 2x² − 1 comes from expanding (x − 1)² as x² − 1, dropping the middle term, so f(x − 1) becomes 2(x² − 1) + 1 = 2x² − 2 + 1 = 2x² − 1. Writing 2x² − 4x + 2 comes from expanding correctly but forgetting the final + 1 from f, stopping at 2(x² − 2x + 1) = 2x² − 4x + 2.
- (d) a = 4 — Expand the left-hand side: (2x + 3)(x + a) = 2x² + 2ax + 3x + 3a = 2x² + (2a + 3)x + 3a. For this to match 2x² + 11x + 12 for every value of x, the x-coefficients must be equal and the constants must be equal: 2a + 3 = 11 and 3a = 12. Both give a = 4, so a = 4. Writing a = 12 comes from the constant-term equation 3a = 12: reading it as saying a itself is 12, rather than dividing both sides by 3. Writing a = 8 comes from the x-coefficient equation 2a + 3 = 11: working out 11 − 3 = 8 correctly but then stopping, without dividing by the 2 in front of a. Writing a = −4 comes from rearranging 2a + 3 = 11 the wrong way round, as 2a = 3 − 11 = −8, which gives a = −4 instead of a = 4.
- (d) (6, 6) — y = f(x − 4) + 1 combines two translations: the −4 inside the brackets moves the graph 4 units to the RIGHT, and the +1 outside the brackets moves it 1 unit UP. Applying both to (2, 5): add 4 to the x-coordinate 2, and add 1 to the y-coordinate 5, giving (6, 6). Moving left instead of right, as the minus sign inside the bracket might suggest, gives (−2, 6) or (−2, 4); forgetting the horizontal shift altogether and only applying the vertical one gives (2, 6).
- (c) {x : x ≤ −4} ∪ {x : x ≥ 4} — Rearrange so one side is zero: x² − 16 ≥ 0, then factorise: (x − 4)(x + 4) ≥ 0. The critical values are x = −4 and x = 4. Since the coefficient of x² is positive, the graph is a U-shape that is on or above the x-axis outside its roots, so the solution is x ≤ −4 or x ≥ 4, written as {x : x ≤ −4} ∪ {x : x ≥ 4}. Distractor routes: {x : −4 ≤ x ≤ 4} takes the region BETWEEN the roots, which is where x² − 16 is negative, the opposite region. {x : x ≥ 4} keeps only the positive square root and drops the negative branch entirely. {x : x ≤ 4} comes from a sign error, treating the inequality as if it were x² ≤ 16.
- (c) Second and fourth — If x + y = 0 then y = −x, so x and y always have opposite signs, one positive and one negative. A point with a negative x and a positive y lies in the second quadrant, and a point with a positive x and a negative y lies in the fourth quadrant, so the point lies in the second or the fourth. A candidate who reads x + y = 0 as meaning x and y have the same sign picks First and third, which is where x × y is positive, not where x + y = 0. A candidate who decides that y must be the positive coordinate picks the two quadrants above the x-axis, First and second. A candidate who decides that y must be the negative coordinate picks the two quadrants below the x-axis, Third and fourth.
- (c) 1 — At x = 0, f(0) = 4. Applying the transformations in order — reflect in the x-axis first, then translate up by 5 — gives −f(0) + 5 = −4 + 5 = 1. Applying the translation but forgetting the reflection gives f(0) + 5 = 9. Applying the reflection to the whole expression, including the +5, gives −f(0) − 5 = −9. Applying the reflection but forgetting the translation gives −f(0) = −4.
- (b) 3n + 1 — Method: find how many more tiles each pattern uses, then find the constant by adjusting pattern 1's total. Working: each pattern uses 3 more tiles than the last, so the coefficient of n is 3. The constant is pattern 1's total minus the common difference: 4 − 3 = 1. Answer: the nth term is 3n + 1. 3n + 4 comes from using pattern 1's total, 4, as the constant without subtracting the common difference. 3n − 2 comes from a slip in working out the constant, subtracting the common difference twice (4 − 3 − 3 = −2) instead of once. n + 3 comes from swapping the common difference and the constant.
- (b) 2x + 3 — fg(x) means f(g(x)): apply g first, then apply f to the result. g(x) = 2x, so f(g(x)) = f(2x) = 2x + 3. Writing 2x + 6 comes from working out gf(x) instead — g(f(x)) = g(x + 3) = 2(x + 3) = 2x + 6 — which applies the functions in the wrong order. Writing 3x + 3 comes from adding f(x) and g(x) together, (x + 3) + 2x = 3x + 3, instead of composing them. Writing 2x² + 6x comes from multiplying f(x) and g(x) together, (x + 3)(2x) = 2x² + 6x, instead of substituting one into the other.
Build your own mix at the worksheet builder.