Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 235 litres — The flow rate at t = 10 is the gradient of the tangent: change in volume ÷ change in time = (190 − 130) ÷ (12 − 8) = 60 ÷ 4 = 15 litres per minute. Treating this rate as roughly constant for a short interval, the volume 5 minutes after t = 10 is estimated as 160 + 5 × 15 = 235 litres. Using the tangent's own point spacing — 2 minutes, from t = 10 to t = 12 — instead of the 5 minutes actually asked for gives 160 + 2 × 15 = 190, which is just the volume already given at one of the tangent's own points, not an answer to the question asked. Multiplying the gradient by the time WITHOUT adding the starting volume, 5 × 15 = 75, forgets that a rate estimates a CHANGE, which must be added to the starting volume, not given as the answer on its own. Subtracting instead of adding, 160 − 5 × 15 = 85, extrapolates backward in time rather than forward.
- (b) x² + y² = 169 — Method: a circle centred on the origin has equation x² + y² = r², and every point on it satisfies that equation, so substituting the coordinates of a point that lies on the circle gives r² directly. Working: substituting x = 5 and y = 12 gives 5² + 12² = 25 + 144 = 169, so r² = 169 and the circle is x² + y² = 169. Answer: x² + y² = 169. The distractors: x² + y² = 13 uses the radius, √169 = 13, where r² belongs, which is the confusion between r and r² made in the other direction; x² + y² = 17 adds the two coordinates, 5 + 12, instead of adding their squares; x² + y² = 119 subtracts the squares, 144 − 25, treating 12 as the hypotenuse of the right-angled triangle rather than as one of the shorter sides.
- (d) −2 — y = f(x) − 6 is f(x) shifted down by 6, so every y-value on the graph decreases by 6. At x = 0, f(0) = 4, so the new y-value is 4 − 6 = −2. Adding 6 instead of subtracting gives 10; writing down the shift itself, −6, or leaving the original value 4 unchanged both skip the translation altogether.
- (c) every value of x except x = −3 — Method: factorise the quadratic, then use the fact that a squared bracket is never negative to decide where the expression is strictly greater than zero. Working: x² + 6x + 9 factorises as (x + 3)², and a square is greater than or equal to 0 for every value of x; (x + 3)² is equal to 0 only when x + 3 = 0, that is when x = −3, so it is strictly greater than 0 at every other value. Answer: every value of x except x = −3. The distractors: 'every value of x, with no exceptions' comes from remembering that a square cannot be negative but forgetting that it can be zero, which a strict > rules out; 'x > −3 only' comes from taking the square root of both sides to get x + 3 > 0 and keeping only that branch; 'x < −3 only' comes from the same square-rooting followed by turning the sign round, as though the step had been a division by a negative number.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (a) y = 2 — Method: make x the subject of the simpler equation, substitute it into the other equation and then read off the letter the question asks for. Working: x − y = 1 gives x = y + 1, so 2x + 3y = 12 becomes 2(y + 1) + 3y = 12, that is 2y + 2 + 3y = 12, so 5y = 10 and y = 2. Answer: y = 2, and the matching value x = 3 checks in 2 × 3 + 3 × 2 = 12. The distractors: y = 3 comes from solving the pair correctly and then writing down the value of x; y = 2.2 comes from expanding 2(y + 1) as 2y + 1, which leaves 5y = 11; y = 10 comes from rearranging x − y = 1 as x = 1 − y, which turns the first equation into 2 + y = 12.
- (d) 6 — Method: rearrange the formula to make d the subject, then substitute C = 133. Working: C = 25 + 18d, so subtracting 25 from both sides gives C − 25 = 18d, then dividing by 18 gives d = (C − 25) / 18. Substituting C = 133: d = (133 − 25) / 18 = 108 / 18 = 6. The value 7.4 comes from dividing 133 by 18 without subtracting the fixed £25 first (133 / 18 ≈ 7.4). The value 4.6 comes from pairing the numbers the wrong way round, working out (133 − 18) / 25 = 4.6. The value 90 comes from subtracting both 25 and 18 from 133 instead of dividing by 18.
- (a) 4 — Rectangle 1: P = 2(9 + 4) = 2 × 13 = 26 cm. Rectangle 2: P = 2(6 + 5) = 2 × 11 = 22 cm. Difference = 26 − 22 = 4 cm. 2 comes from finding the difference between (l + w) for each rectangle, 13 − 11 = 2, but forgetting to double it. 26 comes from giving rectangle 1's whole perimeter instead of the difference between the two. 6 comes from doubling only the change in length, 2 × (9 − 6), and ignoring that the width also changed.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (b) y = 2x − 1 — Method: in a rule that multiplies and then adds, the multiplier is the step in the outputs for each step of 1 in the input, and the number added on is the output when the input is 0. Working: the inputs 0, 1, 2 rise in ones while the outputs −1, 1, 3 rise by 2 each time, so the input is multiplied by 2; an input of 0 gives 2 × 0 = 0 and the output must be −1, so 1 is subtracted. Answer: y = 2x − 1, checked against the last pair by 2 × 2 − 1 = 3. The distractors: y = 2x + 1 comes from finding the multiplier 2 correctly and then reading the output at an input of 0 as +1 instead of −1; y = x − 1 comes from taking the multiplier as 1 because the inputs go up in ones, instead of using the step in the outputs; y = 3x − 1 comes from reading the largest output, 3, as the multiplier.
- (b) (2, 6) — y = f(x − 3) translates y = f(x) horizontally by 3 units to the RIGHT — inside the brackets, subtracting moves the graph in the positive x-direction. Turning point (−1, 6) → (−1 + 3, 6) = (2, 6). The common slip is to move LEFT instead, since the sign inside the bracket is negative — that gives (−4, 6). Changing the y-coordinate instead of the x-coordinate, as in (−1, 3) or (−1, 9), treats this as a vertical shift, which y = f(x − 3) is not.
- (d) 7n − 2 — Method: find how much the total cost rises each month, then find the constant that fits the cost for one month. Working: the cost rises by £7 for each extra month (12 − 5 = 7, 19 − 12 = 7, 26 − 19 = 7), so the cost has the form 7n + c. Substituting n = 1: 7(1) + c = 5, so c = −2. Answer: the total cost in pounds is 7n − 2. The value 7n comes from leaving out the constant. The value 7n + 5 comes from using the cost of one month as the constant directly, without subtracting the monthly rise first. The value 5n + 7 comes from swapping the roles of the cost of one month, £5, and the monthly rise, £7 — using the cost of one month as the coefficient of n and the rise as the constant.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (d) n/2 + 5 — Half of n is n ÷ 2, which is written as the fraction n/2. 'More than' means add, and the addition happens after the halving, so the expression is n/2 + 5. Writing (n + 5)/2 halves the 5 as well, because everything inside a bracket is divided; writing 2n + 5 doubles n instead of halving it; writing 5n/2 multiplies half of n by 5 instead of adding 5 to it.
- (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
Build your own mix at the worksheet builder.