Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) y = 84 − 14x — Method: the distance still to go is the whole route minus the distance already covered, and at a steady speed the distance covered after x hours is the speed multiplied by x. Working: after x hours Freya has cycled 14x km, so the distance remaining is the 84 km route take away 14x, giving y = 84 − 14x, a straight line with intercept 84 and gradient −14. Answer: y = 84 − 14x. The distractors: y = 84 + 14x comes from adding the distance cycled to the length of the route rather than taking it away, so the ride would grow longer the further she goes; y = 14x − 84 comes from carrying out the subtraction the wrong way round, which is negative for the whole of the ride; y = 14 − 84x comes from swapping the two numbers over, treating 84 km as the hourly speed and 14 km as the length of the route.
- (a) 6x + 12 — A regular hexagon has 6 equal sides, so the perimeter is 6(x + 2) = 6x + 12. A candidate who multiplies only the x-term by 6 and forgets to multiply the 2 gets 6x + 2. A candidate who multiplies only the number term by 6 and forgets to multiply the x gets x + 12. A candidate who adds 6 and 2 to make a single coefficient of x instead of expanding the brackets gets 8x.
- (a) 3 and 7 — Method: one equation is linear and the other is not, so rearrange the linear equation and substitute it into the other to leave a single quadratic in one letter. Working: x + y = 10 gives y = 10 − x, so xy = 21 becomes x(10 − x) = 21, which rearranges to x² − 10x + 21 = 0; factorising gives (x − 3)(x − 7) = 0, so the two values are 3 and 7, and 3 + 7 = 10 with 3 × 7 = 21. Answer: 3 and 7. The distractors: 1 and 21 comes from using only the product and taking the first factor pair of 21; −3 and −7 comes from factorising as (x + 3)(x + 7), which reverses the sign of both values; 5 and 5 comes from using only the sum and splitting 10 into two equal parts.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (b) 19 — A line through (x₁, y₁) with gradient m has equation y − y₁ = m(x − x₁). Substituting (6, 1) and m = −3: y − 1 = −3(x − 6), so y = −3x + 18 + 1, which simplifies to y = −3x + 19; at x = 0 this gives 19. Making a sign error when distributing, writing −3(x − 6) as −3x − 18 instead of −3x + 18, gives the wrong line y = −3x − 17, so −17 at x = 0. Forgetting to add the y₁ = 1 at the end, using y = −3(x − 6) alone, gives 18 at x = 0. Substituting the y-coordinate into the gradient term instead of using x, working out 1 + (−3 × 1), gives −2.
- (b) 6 — Method: for any point that lies on y = k/x, the value of k is found by multiplying the x-coordinate and the y-coordinate together, since k = x × y. Working: k = 2 × 3 = 6. Answer: k = 6. Distractor refutation: 1.5 comes from dividing the y-coordinate by the x-coordinate instead of multiplying them. 5 comes from adding the two coordinates instead of multiplying them. 9 comes from misreading the point's x-coordinate as 3 instead of 2, then multiplying 3 × 3.
- (d) g is one-to-one: f(3) = f(−3), removed by x ≥ 0 — A function has an inverse only if it is one-to-one: every output must come from exactly one input. f(3) = 9 and f(−3) = 9, so two different inputs give the same output, and there is no way to send 9 back to a single input — f is not one-to-one over all real x. Restricting the domain to x ≥ 0 removes one of the two inputs behind every such pair, so g is one-to-one and does have an inverse. 'g's outputs are positive; f's could be negative' is wrong because f(x) = x² also only gives outputs of 0 or more — the outputs of f and g are identical sets; it is the INPUTS that differ, not the outputs. 'Restricting any domain always creates an inverse' is wrong because a restriction only helps if it actually removes the repeated outputs: restricting f(x) = x² to x ≥ −3 still leaves f(1) = f(−1) = 1, so that restricted function is still not one-to-one and still has no inverse. 'Squares can never be reversed, under any conditions' is wrong because √9 = 3 does reverse 3² = 9 once you know the input was non-negative — a square root just cannot tell you WHICH of two inputs you started from unless the domain has already ruled one of them out.
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (b) y = f(−x) — y = f(−x) reflects the graph of y = f(x) in the y-axis: every x-coordinate changes sign. The x-intercepts −3 and 7 become 3 and −7, matching the second graph's intercepts −7 and 3. A point already on the y-axis is unaffected, since −0 = 0, so the y-intercept (0, 21) stays exactly where it is — matching the second graph as well. y = −f(x) leaves the x-intercepts unchanged at −3 and 7, since f(x) = 0 exactly where −f(x) = 0, which does not match; it also sends the y-intercept to (0, −21), a second mismatch. y = −f(−x) does send the x-intercepts to the right places, −7 and 3, but it sends the y-intercept to (0, −21) instead of (0, 21), so it fails the second clue. y = f(x) − 4 moves every point down 4, sending the y-intercept to (0, 17) instead of (0, 21), so it fails the y-axis clue. Test each option against BOTH clues — the pair of x-intercepts and the point on the y-axis — because more than one option gets only one of the two right.
- (a) It is 2(w + (w + 3)) = 4w + 6, not 2w + 3. — The perimeter of a rectangle is twice the width plus twice the length: 2 × w + 2 × (w + 3) = 2w + 2w + 6 = 4w + 6, so the gardener's 2w + 3 is wrong. Writing w + (w + 3) = 2w + 3 forgets to double the sides at all, only adding one width and one length once. Writing 4(w + 3) = 4w + 12 wrongly treats all four sides as equal to the length, as if the garden were a square. Writing 3w + 6 comes from doubling the length correctly but adding the width only once instead of doubling it too.
- (d) 47 — To reach the 8th term from the 1st term, the difference of 6 is added 7 times (8 − 1 = 7): 5 + 7 × 6 = 47. A candidate who multiplies by the term number itself, rather than one less, would compute 5 + 8 × 6 = 53. A candidate who uses one step too few (6 instead of 7) would reach 5 + 6 × 6 = 41. A candidate who forgets to include the first term at all would compute just 8 × 6 = 48.
- (c) Correct: 3y = 4 − x gives f⁻¹(x) = (4 − x)/3 — Swap x and y: x = 4 − 3y. Add 3y to both sides and subtract x from both sides: 3y = 4 − x. Divide by 3: y = (4 − x)/3, which is exactly what Ben wrote — his rearrangement is correct. Check with a value: f(1) = 4 − 3 = 1, and Ben's formula gives (4 − 1)/3 = 1, which matches. 'Correct, but only because f is its own inverse' gives the right verdict for a false reason — f(f(x)) = 4 − 3(4 − 3x) = 9x − 8, which is not x, so f is not self-inverse; Ben's rearrangement is correct for the ordinary algebraic reason above, not because of any special property of f. 'Wrong: sign kept, giving (−4 − x)/3' comes from not carrying the swap through consistently — testing x = 1 gives (−4 − 1)/3 = −5/3, which does not equal 1, so it is wrong. 'Wrong: correct inverse is (x − 4)/3' comes from writing 3y = x − 4 instead of 3y = 4 − x, a sign slip when isolating y — testing x = 1 gives (1 − 4)/3 = −1, which again does not equal 1.
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.
Build your own mix at the worksheet builder.