Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) −8 — (−2)³ = (−2) × (−2) × (−2) = −8, since multiplying three negative numbers gives a negative result. A candidate who forgets the sign of a negative number when cubing it might treat (−2)³ as if it were 2³ = 8. A candidate who multiplies −2 by 3 instead of cubing it might get −2 × 3 = −6. A candidate who combines both mistakes — multiplying by 3 and dropping the sign — might get 2 × 3 = 6.
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (a) {x : x < −3} ∪ {x : x ≥ 1} — "Less than −3" stays strict, since the wording never says "or equal to": x < −3. "Greater than or equal to 1" is inclusive: x ≥ 1. These are two separate, non-overlapping ranges joined with "or", so in set notation they are combined with the union symbol: {x : x < −3} ∪ {x : x ≥ 1}. Distractor routes: {x : x ≤ −3} ∪ {x : x > 1} swaps the strict and inclusive signs, marking −3 as included and 1 as excluded, the opposite of the wording. {x : −3 < x ≤ 1} treats "or" as "and", joining the two conditions into one continuous interval between the values instead of a union of two separate ranges. {x : x > −3} ∪ {x : x ≤ 1} reverses both inequality directions; the two reversed ranges then overlap and between them cover every number on the number line, so that set is the whole of the real line rather than the two separate ranges the description asks for.
- (b) xₙ₊₁ = (xₙ² + 3) ÷ 5 — Starting from x² = 5x − 3, add 3 to both sides: x² + 3 = 5x. Divide both sides by 5: x = (x² + 3) ÷ 5. Writing this as an iteration gives xₙ₊₁ = (xₙ² + 3) ÷ 5. xₙ₊₁ = (xₙ² − 3) ÷ 5 comes from a sign error when moving the −3 across the equals sign — it should become +3, not stay as −3. xₙ₊₁ = 5(xₙ² + 3) comes from multiplying by 5 instead of dividing by 5 when isolating x. xₙ₊₁ = (xₙ + 3) ÷ 5 comes from dropping the index on x², using xₙ instead of xₙ².
- (c) 360° — The graph of y = cos x repeats itself every 360°, so its period is 360°. 180° is the period of y = tan x, not y = cos x — confusing the two graphs gives this. 90° is the horizontal distance from a maximum of y = cos x to the next point where the graph crosses the x-axis, a quarter of the period, mistaken for the whole period. 720° comes from counting the interval containing two full repeats of the graph, from one maximum to the second repeat of that maximum, instead of the first.
- (d) 4x + 5 — A minus sign directly before a bracket changes the sign of both terms inside it: 6x − (2x − 5) = 6x − 2x + 5 = 4x + 5. The option 4x − 5 comes from only changing the sign of the 2x term and not the −5, giving 6x − 2x − 5. The option 8x − 5 comes from adding 2x instead of subtracting it, as if the minus sign did not apply to the bracket, giving 6x + 2x − 5. The option 8x + 5 repeats that same addition mistake and also changes the sign of the −5 term.
- (d) 6n + 3 — Method: find the price per passenger, then find the booking fee that fits a booking for 1 passenger. Working: the cost rises by £6 for each extra passenger (15 − 9 = 6, 21 − 15 = 6, 27 − 21 = 6), so the cost has the form 6n + c. Substituting n = 1: 6(1) + c = 9, so c = 3. Answer: the cost in pounds is 6n + 3. 6n ignores the booking fee altogether. 6n + 9 uses the cost of one passenger, £9, as the fee without first subtracting the £6 per-passenger price. 9n + 6 swaps the two numbers, using the first cost as the price per passenger and the difference as the fee.
- (b) 14 m/s — Average speed for a whole journey is total distance divided by total time: 350 ÷ 25 = 14 m/s. Multiplying the distance and time instead of dividing gives 350 × 25 = 8750 m/s. Adding the distance and time instead of dividing gives 350 + 25 = 375 m/s. Inverting the division, working out time divided by distance, gives 25 ÷ 350, which rounds to 0.07 m/s.
- (c) 3c + 2d — Method: 'triple c' is 3c, 'double d' is 2d, and 'add' joins the two separate terms with a plus sign. Working: 3c + 2d. Answer: 3c + 2d. 2c + 3d comes from swapping which letter gets tripled and which gets doubled. 6cd comes from multiplying the two terms together instead of adding them, and also multiplying the coefficients (3 × 2 = 6). 5(c + d) comes from adding the coefficients (3 + 2 = 5) and applying that single number to both letters together, as if c and d always came as a pair.
- (d) y = (x + 3)(x − 5) — A root at x = −3 means the matching bracket must be zero when x = −3, so the bracket is (x − (−3)) = (x + 3). A root at x = 5 means the other bracket is (x − 5). So the equation is y = (x + 3)(x − 5); checking the y-intercept, (0 + 3)(0 − 5) = 3 × (−5) = −15, which matches the given value. The option (x − 3)(x + 5) swaps the signs of both roots. The option (x + 3)(x + 5) keeps the correct sign for the first root but gets the second wrong. The option (x − 3)(x − 5) gets the first root's sign wrong.
- (c) (0, 0) — A curve crosses the y-axis where x = 0. Substituting x = 0 into y = x³ − 4x gives y = 0³ − 4(0) = 0 − 0 = 0, so the curve crosses the y-axis at (0, 0). A candidate who reads off the coefficient of x as the y-intercept, instead of working out the constant term, might write (0, −4). A candidate who swaps the coordinates might write (4, 0). A candidate who takes the coefficient of x but drops its sign might write (0, 4).
- (d) x = −4, y = −19 — x² + 8x − 3 = (x + 4)² − 4² − 3 = (x + 4)² − 19. Substituting x = −4: (−4)² = 16, 8 × (−4) = −32, so 16 − 32 − 3 = −19, confirming the minimum value −19 at x = −4: turning point (−4, −19). Using 8 instead of half of it inside the bracket gives (x + 8)² − 67, turning point (−8, −67) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (4, −19) — wrong, because (x + 4)² is zero at x = −4, not x = 4. Computing 16 + 3 = 19 instead of −3 − 16 = −19 flips the sign of the constant, giving (−4, 19) — wrong, since the completed square's constant must be evaluated as −3 minus 16, not 16 plus 3. Check by substitution whenever the sign of a constant feels uncertain.
- (c) 4(n + 3) — 'Add 3 to n' must happen before 'multiply the result by 4', so the addition needs brackets to show it happens first: 4(n + 3). Writing 4n + 3 multiplies n by 4 immediately and only adds the 3 afterwards, which reverses the order the words describe. Writing n + 3 × 4 only multiplies the 3 by 4, and adds n as a separate, unmultiplied term — it treats 'the result' as just the 3, not the whole of n + 3. Writing 3(n + 4) keeps the correct structure but swaps which number is added and which is multiplied. The expression for 'add 3 to n, then multiply the result by 4' is 4(n + 3).
- (a) x = 3 — Method: factorise x² + 2x − 15 as (x + 5)(x − 3), since 5 × (−3) = −15 and 5 + (−3) = 2. Setting each bracket equal to zero gives x + 5 = 0 or x − 3 = 0, so x = −5 or x = 3. Only x = 3 is offered here. Distractor origins: x = −3 reverses the sign of the factor pair, treating the bracket (x − 3) as giving x = −3 instead of x = 3; x = 5 takes the number from the other factor, (x + 5), but with the wrong sign, giving x = 5 instead of x = −5; x = 15 takes the constant term of the original expression as if it were a root, without factorising at all.
Build your own mix at the worksheet builder.