Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 19 — Method: set up the equation 15 + 9n = 186, then subtract the deposit and divide by the cost per student. Working: 9n = 186 − 15 = 171; n = 171 ÷ 9 = 19. Answer: 19 students. 20.67 comes from dividing the whole £186 by £9 without first subtracting the deposit: 186 ÷ 9 ≈ 20.67. 11.8 comes from swapping the two amounts round, subtracting £9 and dividing by £15: (186 − 9) ÷ 15 = 11.8. 22.33 comes from adding the deposit instead of subtracting it: (186 + 15) ÷ 9 ≈ 22.33.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (d) −2 — Method: a gradient can only be read off an equation that is written in the form y = mx + c, so y has to be made the subject first. Working: subtracting 2x from both sides of 2x + y = 8 gives y = −2x + 8, and comparing that with y = mx + c gives m = −2. Answer: −2. The distractors: 2 comes from reading the coefficient of x straight off the equation as it is printed, without rearranging, so the change of sign is missed; 8 comes from reading the constant as the gradient, confusing m with c; −1/2 comes from rearranging correctly and then writing the gradient upside down, as the change in x over the change in y.
- (d) x = −4, y = −19 — x² + 8x − 3 = (x + 4)² − 4² − 3 = (x + 4)² − 19. Substituting x = −4: (−4)² = 16, 8 × (−4) = −32, so 16 − 32 − 3 = −19, confirming the minimum value −19 at x = −4: turning point (−4, −19). Using 8 instead of half of it inside the bracket gives (x + 8)² − 67, turning point (−8, −67) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (4, −19) — wrong, because (x + 4)² is zero at x = −4, not x = 4. Computing 16 + 3 = 19 instead of −3 − 16 = −19 flips the sign of the constant, giving (−4, 19) — wrong, since the completed square's constant must be evaluated as −3 minus 16, not 16 plus 3. Check by substitution whenever the sign of a constant feels uncertain.
- (d) If the graph has two real roots, they are equal and opposite in value, so they sum to zero. — A turning point on the y-axis means the graph's axis of symmetry is the line x = 0, so any two roots must be symmetrical about x = 0 — equal in size but opposite in sign, summing to zero. The graph could still have no real roots, but that is not guaranteed just from the turning point's position, so the option claiming it must have none is too strong. The roots do not have to both be positive — if real, one is positive and one negative (or both are zero). The graph does not have to touch the x-axis at exactly one point either; it could cross at two symmetrical points, touch at one point, or miss the x-axis entirely.
- (a) (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1) — Two consecutive odd numbers can be written as 2n + 1 and 2n + 3, for a whole number n. Adding them: (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1), which is a multiple of 4 for every whole number n, proving the general result. Using 2n + 1 twice does not represent two different numbers, so it proves nothing about a sum of two numbers; writing n + (n + 2) drops the +1 that makes the numbers odd in the first place, and only shows a multiple of 2; and check every constant term is added correctly — 1 + 3 is 4, not 3.
- (c) 25 — Method: read off a, b and c with their signs and substitute them into b² − 4ac. Working: for 2x² + 3x − 2 = 0, a = 2, b = 3 and c = −2, so b² − 4ac = 3² − 4 × 2 × (−2) = 9 − (−16) = 9 + 16 = 25. Answer: 25. The distractors: −7 comes from taking c as +2, which gives 9 − 16; 22 comes from working b² as 2 × 3 = 6 and then 6 + 16; 13 comes from leaving the 4 out of 4ac and working 9 − 2 × (−2).
- (a) P — A sequence is geometric when consecutive terms share a constant ratio. For P: 6 ÷ 3 = 2, 12 ÷ 6 = 2, 24 ÷ 12 = 2 — the ratio is constant at 2, so P is geometric. Q is the square numbers (1², 2², 3², 4²), a quadratic sequence: its ratios are 4, 2.25, 1.78, … — not constant. R looks geometric at first (2, 4, 8 doubles each time), but the pattern breaks: 8 to 14 is a ratio of 1.75, not 2. Its first differences are 2, 4, 6 — a constant second difference of 2 — so R is a quadratic sequence, not geometric. S has a constant DIFFERENCE of 5 (it is arithmetic), but its ratios (2, 1.5, 1.33, …) are not constant, so it is not geometric.
- (d) 168 m — Split the area under the graph into two parts. The rising section (0 to 8 s) is a triangle: area = 0.5 × 8 × 12 = 48. The constant section, from 8 s to 18 s (10 s), is a rectangle: area = 12 × 10 = 120. Total distance = 48 + 120 = 168 m. Leaving out the 0.5 doubles the triangle, giving 8 × 12 + 120 = 216 m; ignoring the triangle section altogether gives only 120 m; averaging the start and final speeds over the whole 18 seconds, (0 + 12) ÷ 2 = 6, then 6 × 18 = 108 m, wrongly treats the tram as accelerating the whole time, when the graph is flat for the last 10 seconds.
- (b) 1 — First differences: 2, 4, 6, 8. Second differences: 2, 2, 2, a constant, confirming the sequence is quadratic. The coefficient of n² is half the constant second difference: 2 ÷ 2 = 1. Using the second difference itself as the coefficient, without halving it, gives 2. Halving twice, dividing the second difference by 4 instead of by 2, gives 0.5. Doubling the second difference instead of halving it, on the mistaken rule that the n² coefficient is twice the second difference, gives 2 × 2 = 4.
- (d) y = −f(x + 2) has a maximum turning point at (1, 5). — y = f(x + 2) translates the graph 2 units in the negative x-direction, so the turning point's x-coordinate moves from 3 to 1; reflecting in the x-axis then negates the y-coordinate, turning −5 into 5, and also turns a minimum into a maximum — giving a true maximum turning point at (1, 5). Translating the root at x = 1 in the wrong direction, adding 2 instead of subtracting it, gives x = 3, but the true image root is at 1 − 2 = −1, so that statement is false. Keeping the coordinates (1, 5) correct but forgetting that reflecting in the x-axis turns a minimum into a maximum gives a false "minimum turning point" statement. Getting the reflection's effect on the turning-point type right (a maximum) but translating the x-coordinate in the wrong direction, using 3 + 2 = 5 instead of 3 − 2 = 1, gives a false statement at (5, 5).
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (a) 6x + 12 — A regular hexagon has 6 equal sides, so the perimeter is 6(x + 2) = 6x + 12. A candidate who multiplies only the x-term by 6 and forgets to multiply the 2 gets 6x + 2. A candidate who multiplies only the number term by 6 and forgets to multiply the x gets x + 12. A candidate who adds 6 and 2 to make a single coefficient of x instead of expanding the brackets gets 8x.
- (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
- (d) 2x² − 4x + 3 — fg(x) means f(g(x)): substitute g(x) into f in place of x. g(x) = x − 1, so fg(x) = f(x − 1) = 2(x − 1)² + 1. Expanding (x − 1)² = x² − 2x + 1, so fg(x) = 2(x² − 2x + 1) + 1 = 2x² − 4x + 2 + 1 = 2x² − 4x + 3. Writing 2x² comes from working out gf(x) instead — g(f(x)) = f(x) − 1 = (2x² + 1) − 1 = 2x², which applies the functions in the wrong order. Writing 2x² − 1 comes from expanding (x − 1)² as x² − 1, dropping the middle term, so f(x − 1) becomes 2(x² − 1) + 1 = 2x² − 2 + 1 = 2x² − 1. Writing 2x² − 4x + 2 comes from expanding correctly but forgetting the final + 1 from f, stopping at 2(x² − 2x + 1) = 2x² − 4x + 2.
Build your own mix at the worksheet builder.