Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (d) Yes: the 8th term is 50 − 8 × 7 = −6, which is negative. — Method: find the 8th term by subtracting 8 a total of 7 times from the first term, since the 1st term itself needs 0 subtractions. Working: 8th term = 50 − 8 × 7 = 50 − 56 = −6, which is negative, so Priya is correct. Answer: Yes, the 8th term is 50 − 8 × 7 = −6, which is negative. The "50 − 8 × 6 = 2" option subtracts 8 only six times instead of seven, an off-by-one error in counting the steps. The "50 − 8 × 8 = −14" option subtracts 8 eight times instead of seven, the opposite off-by-one error. The claim that repeated subtraction "can never go negative" ignores that subtracting enough times from any starting value eventually gives a negative result.
- (a) Underestimate: the chord lies below the curve — For a curve that is concave down (bending downward), the straight line joining any two points on the curve lies BELOW the curve. The trapezium's top edge is this straight line, so the trapezium's area is smaller than the true area under the curve — the trapezium rule UNDERESTIMATES the distance in this case. This is because a curve whose gradient keeps decreasing bends away from any chord joining two of its points, dropping the chord below every point of the curve in between. The reverse, a chord lying above the curve, is the rule for a concave-up curve, not this one — check which way the curve bends before deciding. The trapezium rule does not always overestimate or underestimate, and it is not exact except when the graph really is a straight line.
- (d) h = 2A / (a + b) — Method: undo the multiplication by 1/2 by multiplying both sides by 2, then undo the multiplication by (a + b) by dividing both sides by it. Working: A = (a + b)h / 2, so multiplying both sides by 2 gives 2A = (a + b)h, then dividing both sides by (a + b) gives h = 2A / (a + b). The value h = A / (a + b) comes from forgetting to multiply by 2 to clear the 1/2 first. The value h = 2A / a + b comes from dividing only by a and leaving b outside the fraction, instead of dividing by the whole bracket (a + b). The value h = (a + b) / (2A) comes from inverting the fraction.
- (a) P — A sequence is geometric when consecutive terms share a constant ratio. For P: 6 ÷ 3 = 2, 12 ÷ 6 = 2, 24 ÷ 12 = 2 — the ratio is constant at 2, so P is geometric. Q is the square numbers (1², 2², 3², 4²), a quadratic sequence: its ratios are 4, 2.25, 1.78, … — not constant. R looks geometric at first (2, 4, 8 doubles each time), but the pattern breaks: 8 to 14 is a ratio of 1.75, not 2. Its first differences are 2, 4, 6 — a constant second difference of 2 — so R is a quadratic sequence, not geometric. S has a constant DIFFERENCE of 5 (it is arithmetic), but its ratios (2, 1.5, 1.33, …) are not constant, so it is not geometric.
- (a) 4 — a₅ = a₄ + a₃, so a₄ = a₅ − a₃ = 29 − 11 = 18. a₄ = a₃ + a₂, so a₂ = a₄ − a₃ = 18 − 11 = 7. a₃ = a₂ + a₁, so a₁ = a₃ − a₂ = 11 − 7 = 4. Checking forwards: 4, 7, 11, 18, 29. Answering 7 stops one step early, reporting a₂ = 7 instead of continuing back one more step to a₁ — wrong, because the question asks for a₁, not a₂. Answering 18 reports a₄ = 18, an intermediate value found along the way, instead of a₁ — wrong, because a₄ is a term used to reach the answer, not the term the question asks for. Answering 3 takes one backward step too many, working out a further term a₀ = a₂ − a₁ = 7 − 4 = 3 — wrong, because the sequence starts at a₁, so a₁ = 4 is as far back as the question goes.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (c) 22 m — Rearranging P = 2l + 2w for l gives l = (P − 2w)/2. Substituting P = 60 and w = 8: l = (60 − 16)/2 = 44/2 = 22 m. Answering 30 m comes from ignoring the width altogether and working out l = P/2, which only holds when w = 0. Answering 38 m comes from adding 2w instead of subtracting it: (60 + 16)/2 = 38. Answering 11 m comes from dividing by 4 instead of 2, as if the formula were P = 4l + 4w. The pen's length is 22 m.
- (d) L/6 − 4 — Method: find the length of one equal piece first (divide by 6), then apply the later change (subtract 4) to that piece. Working: one piece is L/6 metres; removing 4 metres from it gives L/6 − 4. Answer: L/6 − 4. L/6 + 4 comes from adding the 4 metres instead of removing it. (L − 4)/6 comes from removing the 4 metres from the whole rope before cutting it into pieces, the wrong order. 4 − L/6 comes from subtracting the piece length from 4 instead of the other way round.
- (d) $y = x^2 - 2x - 3$ — Method: read the two x-intercepts (roots) from the graph, write the quadratic as the product of the corresponding factors, then expand. Working: the curve crosses the x-axis at x = −1 and x = 3, so the equation factorises as (x + 1)(x − 3), which expands to x² − 2x − 3. Answer: y = x² − 2x − 3. Distractor refutation: y = x² − x − 6 comes from misreading the left-hand crossing point as x = −2 instead of x = −1, giving factors (x + 2)(x − 3). y = x² − x − 2 comes from misreading the right-hand crossing point as x = 2 instead of x = 3, giving factors (x + 1)(x − 2). y = x² + 2x − 3 comes from writing the factors as (x − 1)(x + 3), swapping which root gets the plus sign and which gets the minus sign, giving the wrong sign on the x term.
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
- (d) 9 — Method: expand the brackets fully first, then collect the x-terms and constants before dividing. Working: 4(x − 3) = 4x − 12, so 4x − 12 = 2x + 6; 4x − 2x = 6 + 12; 2x = 18; x = 9. Answer: x = 9. 4.5 comes from expanding only the x-term in the bracket and forgetting to multiply the 3, giving 4x − 3 = 2x + 6, then 2x = 9, x = 4.5. −3 comes from a sign error when expanding, giving 4x + 12 = 2x + 6, then 2x = −6, x = −3. 3 comes from a sign error collecting the x-terms, adding instead of subtracting: 4x + 2x = 6 + 12, so 6x = 18, x = 3.
- (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
Build your own mix at the worksheet builder.