Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 13 — Method: the numbers of matchsticks form a sequence with a term-to-term rule, so count the first square in full and then add the repeated amount once for every extra square. Working: one square uses 4 matchsticks; a row of 4 squares has 3 extra squares after the first, and each of those adds 3 matchsticks, giving 3 × 3 = 9 to add on to the 4. Answer: 13. The distractors: 16 comes from counting each square as a separate set of 4 matchsticks, 4 × 4, and ignoring the shared sides; 12 comes from using 3 matchsticks for all four squares, 3 × 4, and forgetting that the first square needs a fourth side; 10 comes from adding the 3 only twice, as though a row of four squares had two extra squares rather than three.
- (a) 18 — The common ratio is 2√3 ÷ 2 = √3. Checking: 6 ÷ 2√3 = √3 and 6√3 ÷ 6 = √3, so the ratio is consistent throughout. The next term is 6√3 × √3 = 6 × 3 = 18, since √3 × √3 = 3. Looking only at the coefficients 2, 2, 6, 6 and continuing them by doubling the last one gives 6 × 2 = 12, which is wrong because the step from each term to the next is a multiplication by √3, not a pattern in the coefficients alone. Doubling the previous term instead of multiplying by the surd ratio √3 gives 6√3 × 2 = 12√3, which is wrong because the common ratio is √3, not 2. Using 3 instead of √3 as the common ratio — squaring the true ratio by mistake — gives 6√3 × 3 = 18√3, which is wrong because 3 is the SQUARE of the common ratio, not the ratio itself.
- (a) Yes — the gradients multiply to −2 × 1/2 = −1. — Rearrange Q into the form y = mx + c: 2y = x + 6 gives y = (1/2)x + 3, so Q has gradient 1/2. P has gradient −2. Two lines are perpendicular exactly when the product of their gradients is −1: −2 × 1/2 = −1. Since this holds, P and Q are perpendicular. Distractor routes: "the product is −1, but perpendicular needs 1" works out the product correctly but misremembers the condition — the perpendicular test is a product of exactly −1, and parallel lines are spotted by their gradients being equal, not by a product of 1. "Q's gradient is 2, and −2 × 2 = −4" comes from reading the 2 in front of y in 2y = x + 6 as the gradient, instead of dividing the whole equation by 2 first to reach y = (1/2)x + 3, where the gradient is 1/2. "Both equations have a negative x-term" is not a valid test at all — P's equation does have a negative x-term, but Q's, once rearranged, does not, and matching signs say nothing about the actual gradients.
- (b) 5 — From x + y = 7, x = 7 − y. Substituting into 3x + 2y = 16: 3(7 − y) + 2y = 16, so 21 − 3y + 2y = 16, giving 21 − y = 16, so y = 5 (then x = 2). A candidate who forgets to multiply the y-term inside the bracket by 3 would write 21 − y + 2y = 16, giving 21 + y = 16, so y = −5. A candidate who subtracts the two equations directly, (3x + 2y) − (x + y) = 16 − 7, gets 2x + y = 9, and if they wrongly treat this as giving y alone, ignoring the x term, they would answer 9. A candidate who reports the value of x instead of y would answer 2.
- (c) x = 5, y = 5 — x² − 10x + 30 = (x − 5)² − 5² + 30 = (x − 5)² + 5. Substituting x = 5: 5² = 25, 10 × 5 = 50, so 25 − 50 + 30 = 5, confirming the minimum value 5 at x = 5: turning point (5, 5). Using −10 instead of half of it inside the bracket gives (x − 10)² − 70, turning point (10, −70) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−5, 5) — wrong, because (x − 5)² is zero at x = 5, not x = −5. Computing 25 − 30 = −5 instead of 30 − 25 = 5 flips the sign of the constant, giving (5, −5) — wrong, since the completed square's constant must be evaluated as 30 minus 25, not 25 minus 30. Always check a turning point by substituting its x-value back into the original equation.
- (d) x = 5y + 4 — To make x the subject of y = (x − 4)/5, first multiply both sides by 5 to clear the fraction: 5y = x − 4, then add 4 to both sides: x = 5y + 4. Writing x = 5y − 4 multiplies correctly but keeps the minus sign on the 4 instead of changing it to a plus when moving it across. Writing x = y/5 + 4 divides by 5 instead of multiplying, the wrong inverse of the fraction. Writing x = 5(y + 4) adds 4 before multiplying by 5, reversing the correct order of the two steps. The correct rearrangement is x = 5y + 4.
- (a) 3.5 km/h — Average speed is total distance ÷ total time. Total distance = 5 + 9 = 14 km. Total time, including the rest, = 1 + 1 + 2 = 4 hours. So average speed = 14 ÷ 4 = 3.5 km/h. Leaving out the 1 hour rest and dividing by only the 3 hours of walking gives 14 ÷ 3 = 4.67 km/h. Averaging the two separate speeds, 5 km/h and 4.5 km/h, instead of using total distance over total time, gives (5 + 4.5) ÷ 2 = 4.75 km/h. Dividing only the second leg's distance by the total time, 9 ÷ 4 = 2.25 km/h, ignores the first leg's distance.
- (d) It has a solution between x = 2.2 and x = 2.3 — Since f(2.2) is negative and f(2.3) is positive, the graph of f crosses the x-axis somewhere between x = 2.2 and x = 2.3, so the equation has a solution in that interval. Choosing 'between x = −2.2 and x = −2.3' confuses the negative f-VALUE at 2.2 with a negative x-value. Choosing 'no solution' misreads a change of sign as meaning the opposite of what it shows. Choosing 'exactly two solutions' assumes a single change of sign must give two roots, which is not what the rule guarantees.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (c) x ≤ 4 — Subtract 9 from both sides: −2x ≥ 1 − 9 = −8. Divide both sides by −2, flipping the inequality: x ≤ 4. A candidate who divides by −2 but forgets to flip the inequality gets x ≥ 4. A candidate who divides −8 by −2 but keeps a negative sign gets x ≤ −4. A candidate who miscalculates 1 − 9 as −10 gets x ≤ 5.
- (c) 90° — The graph of y = tan x has a vertical asymptote at x = 90°, the smallest positive value for which it is undefined. tan 0° = 0, a defined value, not an undefined one — confusing where the graph equals zero with where it is undefined gives 0°. x = 270° is also a value where y = tan x is undefined, but it is not the smallest positive one, since 90° comes first. tan 45° = 1, a defined value — confusing the asymptote with the angle at which tan x = 1 gives 45°.
- (b) y = 2x² + 14x + 19 — A translation by the vector (−2, 0) moves the graph 2 units in the negative x-direction, which means replacing x with (x + 2): 2(x + 2)² + 6(x + 2) − 1. Expanding 2(x + 2)² gives 2x² + 8x + 8, and 6(x + 2) gives 6x + 12; collecting terms 2x² + 8x + 8 + 6x + 12 − 1 simplifies to 2x² + 14x + 19. Substituting (x − 2) instead of (x + 2) — translating in the wrong direction — gives 2(x−2)² + 6(x−2) − 1, which simplifies to 2x² − 2x − 5. Distributing the outer 2 only onto the x² term of the expansion, instead of onto every term of (x + 2)², gives 2x² + 10x + 15. Dropping the −1 when collecting the constant terms, treating 8 + 12 as 20 rather than 8 + 12 − 1 as 19, gives 2x² + 14x + 20.
- (d) x = −2, y = −5 — 3x² + 12x + 7 rewrites as 3(x² + 4x) + 7, then as 3[(x + 2)² − 4] + 7, which simplifies to 3(x + 2)² − 5, since −3 × 4 + 7 = −5. Substituting x = −2: 3 × (−2)² = 12, 12 × (−2) = −24, so 12 − 24 + 7 = −5, confirming the minimum value −5 at x = −2: turning point x = −2, y = −5. Halving b instead of halving b/a — using −4 as the shift instead of −2 — lands on turning point x = −4, y = −41, which is wrong because when a ≠ 1 the shift inside the bracket is b/(2a), not b/a alone. Reading the bracket's sign directly as the turning point's x-coordinate gives x = 2, y = −5 — wrong, because (x + 2)² is zero at x = −2, not x = 2. Computing 12 − 7 = 5 instead of 7 − 12 = −5 flips the sign of the constant, giving x = −2, y = 5 — wrong, since the completed square's constant must be evaluated as 7 minus 12, not 12 minus 7. Whenever a ≠ 1, factor a out of the x² and x terms first, and always check a turning point by substituting back into the original equation.
- (c) Translate +1 in y; new range 0 ≤ y ≤ 2 — Adding 1 to sin x translates the graph 1 unit in the positive y-direction, and every y-value on the range increases by 1: −1 + 1 = 0 and 1 + 1 = 2, giving a new range of 0 ≤ y ≤ 2. A translation in the x-direction would not add anything to the y-values, so 'Translate +1 in x; range unchanged' correctly leaves the range at −1 ≤ y ≤ 1 for that (wrong) transformation, but the transformation itself is not what y = sin x + 1 shows. 'Translate +1 in y; new range −2 ≤ y ≤ 0' correctly spots the translation but subtracts 1 from each bound instead of adding it. 'Reflect in the x-axis' mistakes the transformation for a reflection rather than a translation; reflecting sin x in the x-axis does leave the range at −1 ≤ y ≤ 1 unchanged in size, but that is not the transformation y = sin x + 1 actually applies.
- (c) y = 3x + 2 — Method: divide the change in the outputs by the change in the inputs to find the multiplier, then put one pair of values into the rule to find the number added on. Working: the output rises by 11 − 5 = 6 while the input rises by 3 − 1 = 2, so the multiplier is 6 ÷ 2 = 3; with an input of 1, 3 × 1 = 3 and the output is 5, so 2 is added. Answer: y = 3x + 2, checked against the second pair by 3 × 3 + 2 = 11. The distractors: y = 3x − 2 comes from finding the multiplier 3 and then subtracting the 2 instead of adding it; y = 2x + 3 comes from swapping the multiplier and the number added on; y = x + 4 comes from assuming the input is multiplied by 1 and using 5 − 1 = 4 as the number added on.
Build your own mix at the worksheet builder.