Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (b) (−2, 0) — Method: a graph meets the x-axis where the y-value is 0, so setting y = 0 turns the equation into a linear equation in x. Working: 0 = 3x + 6 gives 3x = −6, so x = (−6) ÷ 3 = −2 and the meeting point is (−2, 0). Answer: (−2, 0). The distractors: (2, 0) comes from solving 3x = −6 and then dropping the minus sign from the result; (0, 6) is the y-axis crossing, found by substituting x = 0 instead of y = 0; (6, 0) comes from reading the constant 6 straight off as the x-coordinate, without dividing by 3 and without changing its sign.
- (c) 6 — Method: substitute the value, work out the top of the fraction first, then the division, and add the 3 last. Working: the top gives 10 − 4 = 6, dividing by 2 gives 6 ÷ 2 = 3, and adding 3 gives 3 + 3 = 6. Answer: 6. The distractors: 11 comes from dividing only the 4 by 2 instead of the whole of the top, giving 10 − 2 + 3; 4.5 comes from dividing the + 3 by 2 as well, giving (10 − 4 + 3) ÷ 2; 0 comes from subtracting the wrong way round on the top, giving (4 − 10) ÷ 2 = −3 and then −3 + 3.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (d) x = 5y + 4 — To make x the subject of y = (x − 4)/5, first multiply both sides by 5 to clear the fraction: 5y = x − 4, then add 4 to both sides: x = 5y + 4. Writing x = 5y − 4 multiplies correctly but keeps the minus sign on the 4 instead of changing it to a plus when moving it across. Writing x = y/5 + 4 divides by 5 instead of multiplying, the wrong inverse of the fraction. Writing x = 5(y + 4) adds 4 before multiplying by 5, reversing the correct order of the two steps. The correct rearrangement is x = 5y + 4.
- (d) It is n-shaped, since the x² coefficient is negative. — The coefficient of x² is −2, which is negative, so the quadratic curve opens downward — shaped like an n, with a maximum turning point. Saying it is U-shaped focuses only on x² being non-negative and ignores that the −2 in front of it flips the whole curve to open downward. Saying it is a straight line confuses having a constant term with being linear — any equation with an x² term is a curve, not a line. Saying it repeatedly rises and falls like a wave describes a trigonometric graph such as y = sin x, not a quadratic.
- (d) x = (y + 3)/4 — Two operations have been applied to x: it has been multiplied by 4 and then 3 has been subtracted. Undo them in the opposite order. Adding 3 to both sides gives y + 3 = 4x. Dividing both sides by 4 then gives (y + 3)/4 = x, so x = (y + 3)/4. The bracket matters: writing y/4 + 3 divides only the y by 4 and leaves the 3 untouched. Writing (y − 3)/4 subtracts the 3 instead of adding it, and writing 4(y + 3) multiplies by 4 rather than dividing.
- (c) P — Sequence P has a common ratio of 2 (4 × 2 = 8, 8 × 2 = 16, 16 × 2 = 32), so it is geometric. Sequence Q has a common difference of 4, which is arithmetic, not geometric — a candidate who confuses a constant difference with a constant ratio picks Q. Sequence R has increasing differences of 3, 5, 7, a quadratic sequence, not geometric — a candidate who assumes any fast-growing sequence must be geometric picks R. Sequence S is the square numbers from 2² onwards (2², 3², 4², 5²), which is also quadratic, not geometric — a candidate who thinks squaring always means geometric growth picks S.
- (d) x = 4 and x = −4 — Substituting y = 3 gives x² + 9 = 25, which simplifies to x² = 16, so x = 4 or x = −4. Choosing 'x = 3 and x = −3' uses the given value y = 3 as if it were the x-coordinate. Choosing 'x = 4' alone finds the positive square root of 16 but forgets the negative root. Choosing 'x = 5 and x = −5' skips subtracting 3² = 9 from 25 and takes the square root of 25 directly.
- (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
- (b) n² + 4n — First differences of 5, 12, 21, 32, 45 are 7, 9, 11, 13. Second differences are 2, 2, 2, so a = 2 ÷ 2 = 1. Subtracting n² (1, 4, 9, 16, 25) from the totals (5, 12, 21, 32, 45) leaves 4, 8, 12, 16, 20, the linear expression 4n. So the number of oranges is n² + 4n. Using the second difference itself as the coefficient of n², without halving it, gives 2n² + 4n. Finding a = 1 correctly but dropping the linear remainder 4n entirely leaves n². Treating the first first difference (7) as a constant common difference and building a linear formula 5 + 7(n − 1) = 7n − 2 fits only the first two totals, and gives 19 for n = 3 instead of 21.
- (a) An identity, true for every value of x — Expanding the bracket on the left gives 3x + 12, which matches the right-hand side exactly, so the statement is true for every value of x — this makes it an identity. A candidate who reasons that any statement with an equals sign must be an equation picks that option, missing that an equation is only true for particular value(s) of x, not all of them. A candidate who confuses an identity with a formula, because both relate two expressions, picks the formula option — but a formula connects two different quantities, such as area and side length, not two equivalent forms of the same expression. A candidate who assumes it can be solved for a single value of x, as with a normal equation, picks that option, not realising there is no single solution here.
- (d) y = −2x + 10 — Method: a tangent is perpendicular to the radius drawn to the point where it touches, so work out the gradient of that radius, take its negative reciprocal for the tangent, then substitute into y − y₁ = m(x − x₁). Working: the radius joins (0, 0) to (4, 2), so its gradient is 2 ÷ 4 = 1/2; turning 1/2 upside down gives 2 and changing the sign gives −2. Substituting into y − 2 = −2(x − 4) gives y − 2 = −2x + 8, so y = −2x + 10. Answer: y = −2x + 10. The distractors: y = −0.5x + 4 changes the sign of the radius gradient but never turns it upside down, using −1/2 where −2 belongs; y = 2x − 6 turns the gradient upside down but leaves it positive, using 2 where −2 belongs; y = −2x − 10 has the correct gradient but substitutes the point with both signs reversed, writing y + 2 = −2(x + 4) instead of y − 2 = −2(x − 4).
- (d) 110 — Method: form the equation 15 + 0.08m = 23.80, where m is the number of minutes, then solve for m. Working: subtract the fixed fee: 0.08m = 23.80 − 15 = 8.80. Divide by the cost per minute: m = 8.80 ÷ 0.08 = 110. Answer: 110 minutes. 1.1 comes from using 8 instead of 0.08 as the cost per minute, forgetting to convert pence to pounds. 297.5 comes from dividing the whole bill by the cost per minute without subtracting the fixed fee first, 23.80 ÷ 0.08. 485 comes from adding the fixed fee to the bill instead of subtracting it, before dividing by the cost per minute, (23.80 + 15) ÷ 0.08.
Build your own mix at the worksheet builder.