Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (a) y = (x − 2)² + 3 — Since (x − 2)² is never negative, (x − 2)² + 3 is always at least 3, so y can never equal 0 and the graph never crosses the x-axis. The other three graphs are all given in a factorised or difference-of-squares form that shows two real roots: y = (x − 2)(x + 3) crosses at x = 2 and x = −3; y = x² − 9 = (x − 3)(x + 3) crosses at x = 3 and x = −3; y = (x + 4)(x − 1) crosses at x = −4 and x = 1.
- (c) h = V / (lw) — Method: undo the multiplication by lw by dividing both sides by lw. Working: V = lwh, so dividing both sides by lw gives h = V / (lw). The value h = V − lw comes from subtracting lw instead of dividing by it. The value h = Vlw comes from multiplying by lw instead of dividing. The value h = lw / V comes from inverting the fraction, dividing lw by V instead of V by lw.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (d) £195 — Substituting x = 3 into y = 45x + 60 gives y = 45 × 3 + 60 = 135 + 60 = 195. A candidate who forgets to add the call-out fee would get only 45 × 3 = £135. A candidate who adds the hours to the fee and the rate instead of multiplying would get 45 + 60 + 3 = £108. A candidate who multiplies both the hourly rate and the call-out fee by the number of hours would get 45 × 3 + 60 × 3 = £315.
- (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
- (c) 4 — x² + 12x + 40 = (x + 6)² − 6² + 40 = (x + 6)² + 4, so a = 6 and b = 4. Since (x + 6)² can never be negative, y = (x + 6)² + 4 is smallest when the bracket is zero, so the minimum value of y is 4. Giving 40 instead reads off the ORIGINAL constant term and ignores the completing-the-square step entirely — wrong, because 40 is the value of y when x = 0, not the minimum value. Giving −6 instead answers with the x-coordinate of the turning point (where the bracket is zero) rather than the minimum y-value itself — wrong, because the question asks for the minimum value of y, not the value of x that produces it. Giving 36 instead stops after squaring half the coefficient, 6² = 36, without combining it with the 40 already in the expression — wrong, because the minimum value is 40 minus 36, not 36 on its own.
- (a) They always charge the same, since 3(2n + 4) = 6n + 12. — Expand Advert A's formula by multiplying both terms inside the bracket by 3: 3 × 2n = 6n, and 3 × 4 = 12, giving 3(2n + 4) = 6n + 12, which is identical to Advert B's formula — so the two adverts always charge the same amount, whatever n is. Getting 6n + 4 comes from multiplying the 2n by 3 but leaving the 4 unmultiplied. Getting 2n + 7 comes from adding 3 to the bracket instead of multiplying by it. Saying it depends on n avoids expanding the bracket at all — once expanded, both formulas are identical for every value of n, so the cost can be compared directly.
- (a) y = −3x − 5 — Gradient = (−8 − 4) ÷ (1 − (−3)) = −12 ÷ 4 = −3. Using the point (1, −8): −8 = −3(1) + c, so c = −5, giving y = −3x − 5. A candidate who drops the negative sign on the gradient, using m = 3 instead, would then solve −8 = 3(1) + c to get c = −11, writing y = 3x − 11. A candidate who makes a sign error isolating c, writing c = 5 instead of −5, would write y = −3x + 5. A candidate who mixes up both mistakes — keeping the correct gradient but the wrong, positive value of c from the flipped-gradient calculation — would write y = −3x + 11.
- (d) 4 — Method: collect the x terms on one side and the number terms on the other. Working: subtract 3x from both sides: 4x − 5 = 11. Add 5 to both sides: 4x = 16. Divide by 4: x = 4. Answer: 4. 0.6 comes from adding the x terms instead of subtracting when collecting them, 7x + 3x = 10x, and also subtracting the constants the wrong way round, 11 − 5 = 6, giving 10x = 6. 1.5 comes from correctly collecting the x terms as 4x but subtracting the constants the wrong way round, 11 − 5 instead of 11 + 5. −4 comes from moving the x terms to the wrong side, giving 3x − 7x instead of 7x − 3x, along with a matching sign error on the constants.
- (d) 3 — 2x² − 12x + 7 rewrites as 2(x² − 6x) + 7, then as 2[(x − 3)² − 9] + 7, which simplifies to 2(x − 3)² − 11, since −2 × 9 + 7 = −11. The bracket (x − 3)² is zero when x = 3, so the minimum occurs at x = 3. Treating the shift as b/a instead of b/(2a) — using 6 instead of 3 — gives x = 6, which is wrong. Reading the bracket's sign directly without negating it gives x = −3, wrong, because (x − 3)² is zero at x = 3, not x = −3. Reading off the coefficient of x itself, −12, and calling that the answer skips the completing-the-square process entirely and gives x = −12, which is wrong because b is not the turning point's x-coordinate under any circumstance. Always check: substituting your value of x should make the bracketed term equal to zero, and nothing else.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
Build your own mix at the worksheet builder.