Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (d) £16.70 — The mileage charge is 2.20 × 6 = £13.20. Adding the fixed fee: £13.20 + £3.50 = £16.70. A candidate who forgets the fixed fee gives just the mileage charge, £13.20. A candidate who adds the fixed fee to the per-mile rate before multiplying by the number of miles, (3.50 + 2.20) × 6, gets £34.20. A candidate who rounds £2.20 down to £2 gets 2 × 6 + 3.50 = £15.50.
- (d) −2 — Method: substitute the value into both terms, working out the index and the multiplication before the addition. Working: m² = (−2) × (−2) = 4 and 3m = 3 × (−2) = −6, so the expression becomes 4 + (−6), which is −2. Answer: −2. The distractors: −10 comes from squaring −2 as −4, giving −4 + (−6); 10 comes from working out 3m as +6 and losing the minus sign, giving 4 + 6; −14 comes from working from left to right instead of multiplying first, giving (4 + 3) × (−2).
- (b) y = 2x and y = −(1/2)x + 1 — Method: two lines are perpendicular when the product of their gradients is −1, so the gradient of each line is read from the number multiplying x and the two are multiplied together. Working: for y = 2x and y = −(1/2)x + 1 the gradients are 2 and −1/2, and 2 × (−1/2) = −1, so that pair is perpendicular. Answer: y = 2x and y = −(1/2)x + 1. The distractors: the pair y = 2x and y = 2x + 1 has equal gradients, whose product is 4, so those two lines are parallel and never meet, and they are chosen by a candidate applying the parallel condition; the pair y = 2x and y = −2x + 1 comes from changing the sign of the gradient without turning it upside down, and its product is −4; the pair y = 2x and y = (1/2)x + 1 comes from turning the gradient upside down without changing its sign, and its product is 1.
- (b) x = y/3 − 2 — The bracket containing x has been multiplied by 3, so divide both sides by 3 first, which gives y/3 = x + 2. Subtracting 2 from both sides then leaves y/3 − 2 = x, so x = y/3 − 2. Taking the 2 away before dividing gives (y − 2)/3, which divides the 2 by 3 as well, although the 2 was never divided in the original formula. Adding 2 rather than subtracting it gives y/3 + 2, and multiplying by 3 instead of dividing gives 3y − 2.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (b) One turning point. — Every quadratic graph, one with an x² term and no higher power of x, has exactly one turning point, since it is a single U-shaped or n-shaped curve. Saying two turning points describes a cubic graph, which can rise, turn, then turn again. Saying no turning points describes a straight line, which has none. Saying four turning points greatly overestimates how many times a simple quadratic curve changes direction — that would need a much higher power of x.
- (c) x + 3 — Expand the bracket: 0.5(4x + 6) = 2x + 3. Then subtract the x: 2x + 3 − x = x + 3. The option 2x + 3 comes from expanding the bracket correctly but then forgetting to subtract the x at all. The option x + 6 comes from forgetting to multiply the 6 inside the bracket by 0.5 (treating it as 2x + 6), then subtracting x. The option 3x + 3 comes from adding the x instead of subtracting it: 2x + 3 + x = 3x + 3.
- (a) y = −2x − 1 — Method: the gradient is the change in y divided by the change in x with both differences taken in the same order, and the constant then comes from substituting either point into y = mx + c. Working: m = (−9 − 3) ÷ (4 − (−2)) = (−12) ÷ 6 = −2, so the line is y = −2x + c; substituting (−2, 3) gives 3 = −2 × (−2) + c = 4 + c, so c = 3 − 4 = −1. Answer: y = −2x − 1. The distractors: y = −2x + 1 comes from rearranging 3 = 4 + c the wrong way round and taking the constant as 4 − 3; y = 2x + 7 comes from losing the minus sign when −12 is divided by 6 and then substituting correctly, 3 = 2 × (−2) + c; y = −(1/2)x + 2 comes from writing the gradient upside down as the change in x over the change in y, 6 ÷ (−12).
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (d) x = 1 and x = 2 — Method: where a line meets a curve the two expressions for y are equal, so set them equal and solve the quadratic that results. Working: x² − 1 = 3x − 3 collects to x² − 3x + 2 = 0; factorising gives (x − 1)(x − 2) = 0, so x = 1 or x = 2, and each value gives the same y on both graphs. Answer: x = 1 and x = 2. The distractors: x = −1 and x = −2 come from factorising as (x + 1)(x + 2) and so reversing the sign of both roots; x = −1 and x = 4 come from moving the −3 across the equals sign without changing its sign, which gives x² − 3x − 4 = 0; x = 1 and x = −1 come from setting each expression equal to zero separately instead of equal to each other.
- (c) −4 — f(2) = 7, and y = f(x) + a passing through (2, 3) means f(2) + a = 3, so 7 + a = 3, giving a = 3 − 7 = −4. Writing a = 4 comes from subtracting the wrong way round, 7 − 3 instead of 3 − 7. Writing a = 10 comes from adding the two y-values instead of subtracting one from the other. Writing a = 3 comes from taking the new y-coordinate as the value of a directly, without accounting for the original y-value of 7 at all.
Build your own mix at the worksheet builder.