Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 7 — Multiply the input by 2: 6 × 2 = 12. Then subtract 5: 12 − 5 = 7. A candidate who does the operations in the wrong order, subtracting 5 first and then multiplying by 2, gets (6 − 5) × 2 = 2. A candidate who only carries out the multiplication and forgets to subtract gets 12. A candidate who adds 5 instead of subtracting gets 6 × 2 + 5 = 17.
- (a) 45 — The ratio between the two given points, one power of x apart, gives b: 405 ÷ 135 = 3, so b = 3. Substituting back, at x = 1, y = A × b, so 135 = A × 3, giving A = 45. Giving the common ratio b itself instead of A confuses which unknown was asked for and produces 3 — wrong, because the question asks for A, not b. Giving 135 instead treats the first given point as the y-intercept and reads A off it directly — wrong, because that point is at x = 1, not x = 0, so 135 is A × b, not A. Assuming A equals b⁰ = 1 by itself, rather than substituting a known point to solve for A, gives 1 — wrong, because b⁰ is always 1 regardless of A; A must be found using an actual (x, y) pair from the graph.
- (c) 7 — To reverse the rule, subtract the constant then divide by the coefficient: 30−2=28, then 28÷4=7, so n=7. A candidate who adds the constant instead of subtracting it, a sign error when rearranging, would compute (30+2)÷4=32÷4=8. A candidate who subtracts the constant correctly but then forgets to divide by the coefficient would stop at 30−2=28. A candidate who treats 4n+2 as a single term 6n, adding the coefficient and constant together, would compute 30÷6=5.
- (b) 19 — A line through (x₁, y₁) with gradient m has equation y − y₁ = m(x − x₁). Substituting (6, 1) and m = −3: y − 1 = −3(x − 6), so y = −3x + 18 + 1, which simplifies to y = −3x + 19; at x = 0 this gives 19. Making a sign error when distributing, writing −3(x − 6) as −3x − 18 instead of −3x + 18, gives the wrong line y = −3x − 17, so −17 at x = 0. Forgetting to add the y₁ = 1 at the end, using y = −3(x − 6) alone, gives 18 at x = 0. Substituting the y-coordinate into the gradient term instead of using x, working out 1 + (−3 × 1), gives −2.
- (c) 8a + 2 — The perimeter of a rectangle is twice the length plus twice the width: P = 2(3a + 2) + 2(a − 1) = (6a + 4) + (2a − 2) = 8a + 2. Answering 5a adds the length and width once each but doubles only one of them, missing that a rectangle has two of each side. Answering 8a + 6 distributes the 2 into (a − 1) correctly as far as 2a, but then adds 2 instead of subtracting it, as though the bracket had been (a + 1). Answering 12a + 8 uses the length for all four sides instead of using the length twice and the width twice, as if the field were a square with side (3a + 2). The perimeter of the field is (8a + 2) metres.
- (b) x = −3, y = −7 — x² + 6x + 2 = (x + 3)² − 3² + 2 = (x + 3)² − 7. Substituting x = −3: (−3)² = 9, 6 × (−3) = −18, so 9 − 18 + 2 = −7, confirming the minimum value −7 at x = −3: turning point (−3, −7). Using 6 instead of half of 6 inside the bracket gives (x + 6)² − 34, turning point (−6, −34) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (3, −7) — wrong, because (x + 3)² is zero at x = −3, not x = 3. Computing 9 − 2 = 7 instead of 2 − 9 = −7 flips the sign of the constant, giving (−3, 7) — wrong, since the completed square's constant must be evaluated as 2 minus 9, not 9 minus 2. Always check a turning point by substituting its x-value back into the original equation.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (a) 3x/2 — Factorise top and bottom first: 6x³ − 15x² = 3x²(2x − 5), and 4x² − 10x = 2x(2x − 5). The bracket (2x − 5) is common to both, so it cancels, leaving 3x²/(2x); dividing the power of x, 3x² ÷ x = 3x, gives 3x/2. Writing 3x²/2 cancels the (2x − 5) correctly and removes the denominator's x, but never reduces the power of x left in the numerator — 3x² ÷ x should give 3x, not stay as 3x². Writing 3/2 cancels the (2x − 5) correctly but then drops the x from the numerator altogether, treating 3x² over x as if it cancelled completely to 3 instead of reducing to 3x. Writing −3x/2 comes from factorising the denominator with the wrong sign, as 2x(5 − 2x) instead of 2x(2x − 5); cancelling (5 − 2x) against the numerator's (2x − 5) then needs an extra minus sign, which flips the answer to −3x/2.
- (d) x ≤ 30 — Method: add the fixed cost to the cost of x balloons, set that total against the £150 limit with the sign that 'at most' calls for, then solve. Working: the total spend is 60 + 3x pounds, so 60 + 3x ≤ 150; subtracting 60 from both sides gives 3x ≤ 90; dividing both sides by 3, a positive number, gives x ≤ 30. Answer: x ≤ 30. The distractors: x ≤ 90 comes from taking the cake off the budget and stopping at 3x ≤ 90, reading the 90 as a number of balloons when it is the money left for them; x ≤ 50 comes from dividing the whole £150 by 3 and leaving the cake out of the calculation altogether; x ≥ 30 comes from reading 'at most' as 'at least', which reverses the condition.
- (b) 10 km — Method: find the constant speed from the graph (distance ÷ time for any point on the line), then multiply that speed by 20 minutes. Working: the line passes through (4 minutes, 2 km), so the speed is 2 ÷ 4 = 0.5 km per minute; in 20 minutes the cyclist travels 0.5 × 20 = 10 km. Answer: 10 km. Distractor refutation: 3 km comes from reading off the distance shown at the end of the plotted section (6 minutes) and stopping there, instead of extending the line to 20 minutes. 20 km comes from misreading the speed as 1 km per minute instead of 0.5 km per minute, doubling the true rate. 40 km comes from dividing 20 by the speed instead of multiplying by it, a reciprocal mix-up.
- (d) x + y = 7 — The midpoint of AB is (−1 + 5)/2, (2 + 8)/2, which is (2, 5). The gradient of AB is (8 − 2)/(5 − (−1)) = 6/6 = 1. The perpendicular bisector has gradient −1 and passes through (2, 5): y − 5 = −(x − 2), which rearranges to x + y = 7. Distractor routes: x − y = −3 uses the gradient of AB itself, 1, rather than its negative reciprocal, giving a line PARALLEL to AB through the midpoint instead of perpendicular to it. x + y = 12 comes from adding the y-coordinates, 2 + 8 = 10, but forgetting to divide by 2, using the midpoint (2, 10) instead of (2, 5). x + y = 4 comes from using A's x-coordinate, −1, directly instead of averaging it with B's, giving the point (−1, 5) instead of the true midpoint (2, 5).
- (a) (3, 7) — y = f(x) + 5 is a vertical translation of y = f(x) by 5 units up — the translation vector is (0, 5) — so only the y-coordinate of any point changes. Turning point (3, 2) → (3, 2 + 5) = (3, 7). Adding the 5 to the x-coordinate, or treating it as a horizontal shift like y = f(x + 5), moves the wrong coordinate — check first whether the number sits inside or outside the brackets.
- (c) The object was stationary (not moving) — On a distance-time graph, the gradient at any point represents the speed at that point. A gradient of 0 means distance is not changing over time, so the object is stationary. A straight, sloped line (not flat) shows constant nonzero speed; a curve bending one way shows acceleration or deceleration; a flat section is not a maximum speed — it is no speed at all. Read the shape of the graph, not just how steep it looks.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
Build your own mix at the worksheet builder.