Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 15 and 9 — Method: write the two facts as two equations in the same pair of letters and add them, because the letter with opposite signs cancels. Working: with x the larger number and y the smaller, x + y = 24 and x − y = 6; adding gives 2x = 30, so x = 15, and substituting into x + y = 24 gives y = 9. Answer: 15 and 9, which add to 24 and differ by 6. The distractors: 18 and 6 come from halving 24 to 12 and then adding and subtracting the whole difference of 6 instead of half of it, which leaves a difference of 12; 15 and 21 come from finding the larger number correctly and then adding 6 to it instead of subtracting; 15 and 6 come from finding the larger number and then taking the 6 in the question to be the smaller number itself.
- (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (c) L/5 − 3 — Each of the 5 equal pieces is L/5 metres long, and removing 3 metres from one piece gives L/5 − 3. Subtracting the 3 metres before dividing by 5, (L − 3)/5, divides the removed length between all 5 pieces instead of taking it from just one. Dividing only the 3 by 5 instead of dividing L by 5, L − 3/5, divides the wrong number. Writing 5/L − 3 inverts the fraction, swapping which number is the numerator.
- (c) 71 — Method: square x first, then multiply by 3, then subtract 4, following the order of operations. Working: x² = 5² = 25; 3 × 25 = 75; 75 − 4 = 71. Answer: 71. 221 comes from squaring (3x) as a whole first: (3 × 5)² = 225, then − 4 = 221, squaring the coefficient along with x. 75 comes from correctly working out 3x² but forgetting to subtract the 4. 3 comes from subtracting the 4 from x before squaring: (5 − 4)² × 3 = 3, doing the operations in the wrong order.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
- (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
- (d) 12 — Method: write the nth term of the sequence, 18 + 4(n − 1), set it equal to 62, and solve for n. Working: 18 + 4(n − 1) = 62, so 4(n − 1) = 44, giving n − 1 = 11, so n = 12. Answer: row 12. 11 comes from using 18 + 4n = 62 instead of 18 + 4(n − 1) = 62, an off-by-one error, giving n = 11. 48 comes from correctly simplifying to 4n = 48 but stopping there, without dividing by 4 to find n. 15.5 comes from dividing 62 by 4 directly, ignoring the 18 seats already in the front row.
- (a) It gets closer to zero but never actually reaches it. — y = 60 × (0.5)ˣ is always positive, however large x is, because a positive number raised to any power stays positive. As x increases, (0.5)ˣ gets smaller and smaller but never equals zero, so y approaches zero without ever reaching it. Believing the curve reaches zero when x = 60, because 60 is the starting value, mixes up the y-intercept with a stopping point — an exponential decay curve like this one never actually reaches the x-axis, so this is wrong. Believing the curve goes negative for large x is wrong because multiplying a positive number by (0.5) any number of times can never produce a negative result. Believing the curve levels off at y = 0.5, confusing the base of the exponential with its eventual level, is wrong: the base only controls how fast the curve falls, not where it settles — this curve settles at y = 0, not y = 0.5. Whenever you sketch an exponential decay curve, draw it approaching the x-axis but never touching it.
- (b) y = f(−x) — y = f(−x) reflects the graph of y = f(x) in the y-axis: every x-coordinate changes sign. The x-intercepts −3 and 7 become 3 and −7, matching the second graph's intercepts −7 and 3. A point already on the y-axis is unaffected, since −0 = 0, so the y-intercept (0, 21) stays exactly where it is — matching the second graph as well. y = −f(x) leaves the x-intercepts unchanged at −3 and 7, since f(x) = 0 exactly where −f(x) = 0, which does not match; it also sends the y-intercept to (0, −21), a second mismatch. y = −f(−x) does send the x-intercepts to the right places, −7 and 3, but it sends the y-intercept to (0, −21) instead of (0, 21), so it fails the second clue. y = f(x) − 4 moves every point down 4, sending the y-intercept to (0, 17) instead of (0, 21), so it fails the y-axis clue. Test each option against BOTH clues — the pair of x-intercepts and the point on the y-axis — because more than one option gets only one of the two right.
- (d) V = lwh — V = lwh is a formula: it relates one quantity, the volume V, to others, the length, width and height, in a way that is true generally. A candidate who picks lwh has chosen the expression, not a full statement relating two quantities. A candidate who picks lwh = 60 has chosen an equation, since it is only true for particular values of l, w and h that multiply to 60. A candidate who picks 2(l + w) ≡ 2l + 2w has chosen an identity, mistaking the identity symbol ≡ for a sign that makes a statement a formula.
- (b) (3, 3) and (−1, −5) — Set the two expressions for y equal: x² − 6 = 2x − 3, which rearranges to x² − 2x − 3 = 0. Factorise: (x − 3)(x + 1) = 0, so x = 3 or x = −1. Substitute into the linear equation, y = 2x − 3: x = 3 gives y = 3; x = −1 gives y = −5. The points are (3, 3) and (−1, −5). Distractor routes: (3, 3) and (1, −1) comes from mis-factorising x² − 2x − 3 as (x − 3)(x − 1), giving a second root of 1 instead of −1. (3, 9) and (−1, 1) comes from finding the y-coordinate from y = x² instead of substituting back into the given line equation y = 2x − 3. (3, 3) alone stops after finding only the first root of the quadratic.
- (c) y = (5/12)x − 169/12 — The gradient of the radius to (5, −12) is (−12 − 0) ÷ (5 − 0) = −12/5. A tangent is perpendicular to the radius at that point, so its gradient is the negative reciprocal, 5/12. Using y − y₁ = m(x − x₁) with (5, −12): y + 12 = (5/12)(x − 5), which gives y = (5/12)x − 169/12. y = −(12/5)x comes from using the radius's own gradient, −12/5, instead of turning it into the perpendicular gradient, and building the line through the origin (as the radius itself does). y = −(5/12)x − 119/12 comes from taking the reciprocal of −12/5 correctly as a size but keeping the wrong sign, using −5/12 instead of 5/12. y = (5/12)x − 25/12 comes from using the correct gradient 5/12 but building the line through (5, 0) instead of (5, −12) — dropping the point's y-coordinate.
- (b) (2x + 14)/((x − 1)(x + 3)) — To subtract these fractions, write them over the common denominator (x − 1)(x + 3): the numerator becomes 4(x + 3) − 2(x − 1). Expanding gives 4x + 12 − 2x + 2, which simplifies to 2x + 14, so the answer is (2x + 14)/((x − 1)(x + 3)). Writing (2x + 11)/((x − 1)(x + 3)) comes from not distributing the minus sign fully across the second bracket, treating −2(x − 1) as −2x − 1 instead of −2x + 2. Writing 2/((x − 1)(x + 3)) comes from subtracting the two original numerators directly, 4 − 2 = 2, the same mistake as subtracting fractions without a common denominator. Writing (2x − 10)/((x − 1)(x + 3)) comes from swapping which numerator multiplies which bracket, forming 4(x − 1) − 2(x + 3) instead of 4(x + 3) − 2(x − 1).
- (a) (15, 0) — Method: the tangent is perpendicular to the radius at the point of contact, so find the gradient of the radius, take its negative reciprocal, write the equation of the tangent, then substitute y = 0 because every point on the x-axis has y-coordinate 0. Working: the radius from (0, 0) to (3, 6) has gradient 6 ÷ 3 = 2, so the tangent has gradient −1/2. Substituting into y − 6 = −1/2(x − 3) gives y = −0.5x + 7.5. Setting y = 0 gives 0.5x = 7.5, so x = 15 and P is (15, 0). Answer: (15, 0). The distractors: (0, 7.5) is where the same tangent crosses the y-axis, reached by setting x = 0 instead of y = 0; (0, 0) comes from using the gradient of the radius, 2, for the tangent, which gives the line y = 2x through the centre and so crosses the x-axis at the origin; (6, 0) comes from changing the sign of the radius gradient without turning it upside down, which gives y = −2x + 12.
Build your own mix at the worksheet builder.