Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (a) 3 and 7 — Method: one equation is linear and the other is not, so rearrange the linear equation and substitute it into the other to leave a single quadratic in one letter. Working: x + y = 10 gives y = 10 − x, so xy = 21 becomes x(10 − x) = 21, which rearranges to x² − 10x + 21 = 0; factorising gives (x − 3)(x − 7) = 0, so the two values are 3 and 7, and 3 + 7 = 10 with 3 × 7 = 21. Answer: 3 and 7. The distractors: 1 and 21 comes from using only the product and taking the first factor pair of 21; −3 and −7 comes from factorising as (x + 3)(x + 7), which reverses the sign of both values; 5 and 5 comes from using only the sum and splitting 10 into two equal parts.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (c) 71 — Method: square x first, then multiply by 3, then subtract 4, following the order of operations. Working: x² = 5² = 25; 3 × 25 = 75; 75 − 4 = 71. Answer: 71. 221 comes from squaring (3x) as a whole first: (3 × 5)² = 225, then − 4 = 221, squaring the coefficient along with x. 75 comes from correctly working out 3x² but forgetting to subtract the 4. 3 comes from subtracting the 4 from x before squaring: (5 − 4)² × 3 = 3, doing the operations in the wrong order.
- (c) x ≥ 3 — Method: collect the number terms first; the x term is negative, so the final step multiplies both sides by −1, and that is the one step that turns the inequality sign round. Working: subtracting 5 from both sides of 5 − x ≤ 2 gives −x ≤ −3; multiplying both sides by −1 turns −x into x and −3 into 3, and because the multiplier is negative the ≤ becomes ≥, so x ≥ 3. Answer: x ≥ 3. The distractors: x ≤ 3 comes from multiplying by −1 without turning the sign round, the commonest slip on this type; x ≤ −3 comes from reading −x ≤ −3 as though the minus sign could simply be rubbed off the left-hand side; x ≥ −3 comes from turning the sign round correctly but leaving the right-hand side at −3 instead of multiplying it by −1 as well.
- (c) y = 3x + 5 — Method: find the gradient from the two points, then substitute one point into y = mx + c to find c. Working: gradient = (14 − 2) ÷ (3 − (−1)) = 12 ÷ 4 = 3. Using the point (3, 14): 14 = 3(3) + c, so 14 = 9 + c, giving c = 5. Answer: y = 3x + 5. y = 6x − 4 comes from mishandling the negative x-coordinate, treating 3 − (−1) as 3 − 1 = 2, so the gradient becomes 12 ÷ 2 = 6, and then c = 14 − 18 = −4. y = 3x + 23 comes from a sign error isolating c, adding 9 to 14 instead of subtracting it: c = 14 + 9 = 23. y = x/3 + 13 comes from dividing the change in x by the change in y instead of the other way round, giving a gradient of 4 ÷ 12 = 1/3, and then c = 14 − 1 = 13.
- (a) n² + n — n² + n = n(n + 1), the product of two consecutive integers. One of any two consecutive integers is always even, so their product is always even, whatever whole number n is. n² − n + 1 = n(n − 1) + 1 is always ODD, since n(n − 1) is even and adding 1 makes it odd — the opposite of what's asked. 2n + 1 is always odd by definition, not even. n² + 1 is not always even at all: it depends on whether n is odd or even, and testing n = 2 gives 5, which is odd.
- (d) y = −f(x + 2) has a maximum turning point at (1, 5). — y = f(x + 2) translates the graph 2 units in the negative x-direction, so the turning point's x-coordinate moves from 3 to 1; reflecting in the x-axis then negates the y-coordinate, turning −5 into 5, and also turns a minimum into a maximum — giving a true maximum turning point at (1, 5). Translating the root at x = 1 in the wrong direction, adding 2 instead of subtracting it, gives x = 3, but the true image root is at 1 − 2 = −1, so that statement is false. Keeping the coordinates (1, 5) correct but forgetting that reflecting in the x-axis turns a minimum into a maximum gives a false "minimum turning point" statement. Getting the reflection's effect on the turning-point type right (a maximum) but translating the x-coordinate in the wrong direction, using 3 + 2 = 5 instead of 3 − 2 = 1, gives a false statement at (5, 5).
- (c) −8 — The nth term is the first term plus (n − 1) lots of the common difference: 40 + 8 × (−6) = 40 − 48 = −8. A candidate who uses 9 lots of the common difference instead of 8 gets 40 + 9 × (−6) = −14. A candidate who treats the common difference as +6 instead of −6 gets 40 + 8 × 6 = 88. A candidate who uses only 7 lots of the common difference gets 40 + 7 × (−6) = −2.
- (c) (3, 9) — Reflecting in the horizontal line y = 2 keeps the x-coordinate the same and maps y to 2 × 2 − y = 4 − (−5) = 9, so S = (3, 9). A candidate who uses k − y instead of 2k − y gets 2 − (−5) = 7, giving (3, 7). A candidate who reflects in the x-axis instead of the line y = 2, simply changing the sign of y, gets (3, 5). A candidate who also changes the sign of the x-coordinate, as if reflecting in both axes, gets (−3, 9).
- (a) 0 — the line does not intersect the circle — Substitute y = 2x + 7 into x² + y² = 4: x² + (2x + 7)² = 4, which expands to x² + 4x² + 28x + 49 = 4, giving 5x² + 28x + 45 = 0. The discriminant is b² − 4ac = 28² − 4 × 5 × 45. Since 28² = 784 and 4 × 5 × 45 = 900, the discriminant is 784 − 900 = −116. Since the discriminant is negative, the quadratic has no real solutions, so the line does not meet the circle at all: 0 intersection points. Distractor routes: "1 — the line is a tangent" confuses a negative discriminant with a zero one; a discriminant of exactly zero gives one point, a tangent, but −116 is not zero. "2 — the line crosses the circle at two points" assumes a positive discriminant without actually working it out. "It cannot be found without solving the quadratic" is the whole point the discriminant exists to avoid — its sign alone, without finding x, tells you the number of real solutions.
- (c) A reflection in the y-axis — Replacing x with −x reflects the graph in the y-axis: each point (x, y) maps to (−x, y). Reflecting the OUTPUT instead, y = −f(x), gives a reflection in the x-axis — that is a different function. Combining both reflections gives a rotation of 180° about the origin, and reflecting in the line y = x swaps the x- and y-values, which is what produces the inverse function, not f(−x). Check first which side of f the minus sign sits on.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (d) −11/60 — The radius from the origin to (11, 60) has gradient 60/11. The tangent is perpendicular to this radius, so its gradient is the negative reciprocal: −1 ÷ (60/11) = −11/60. Choosing 60/11 uses the radius's gradient unchanged, without applying perpendicularity. Choosing −60/11 negates the radius's gradient but forgets to take its reciprocal. Choosing 11/60 takes the reciprocal correctly but keeps the gradient positive instead of negative.
- (c) Wrong — the product is −4/25, not −1. — The student's rearrangement is correct: 5y = −2x + 15 gives y = −(2/5)x + 3, gradient −2/5. But the test for perpendicularity is that the product of the two gradients equals exactly −1, not merely that it is negative. Here 2/5 × (−2/5) = −4/25, which is not −1, so the lines are NOT perpendicular. Distractor routes: "a negative product always means perpendicular" states a rule that does not exist — many pairs of lines have a negative gradient product without being perpendicular, as this pair shows. "The rearrangement is incorrect" wrongly blames a correct step; 5y = −2x + 15 does rearrange to y = −(2/5)x + 3. "2/5 and −2/5 are negatives of each other" notices a true but irrelevant fact — being negatives of each other is not the perpendicularity condition; an exact product of −1 is.
Build your own mix at the worksheet builder.