Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 2n + 3 — Method: multiply the cost per mile by the number of miles to get an expression, then add the fixed fee as a separate term. Working: n miles at £2 each is 2n; add the £3 fixed fee: 2n + 3. Answer: 2n + 3. 3n + 2 comes from swapping the fee and the rate round, treating £3 as the rate per mile and £2 as the fixed fee. 5n comes from adding the fee and the rate together first (3 + 2 = 5) and multiplying the result by n, instead of keeping the fixed fee as its own term. 2n − 3 comes from subtracting the fixed fee instead of adding it.
- (c) r = √(A/π) — A = πr² means r has been squared and then multiplied by π. To make r the subject, first divide both sides by π to get A/π = r², then take the square root of both sides: r = √(A/π). Writing r = A/π stops after dividing by π and forgets that r is still squared — it never undoes the square. Writing r = √A/π takes the square root before dividing by π, which square-roots only the A and not the whole of A/π. Writing r = (A/π)² squares A/π instead of taking its square root — the opposite of what is needed to undo r². The correct rearrangement is r = √(A/π).
- (c) Second and fourth — If x + y = 0 then y = −x, so x and y always have opposite signs, one positive and one negative. A point with a negative x and a positive y lies in the second quadrant, and a point with a positive x and a negative y lies in the fourth quadrant, so the point lies in the second or the fourth. A candidate who reads x + y = 0 as meaning x and y have the same sign picks First and third, which is where x × y is positive, not where x + y = 0. A candidate who decides that y must be the positive coordinate picks the two quadrants above the x-axis, First and second. A candidate who decides that y must be the negative coordinate picks the two quadrants below the x-axis, Third and fourth.
- (d) 50/3 — Method: call the smaller number x, write the larger number in terms of x and use the total. Working: the larger number is 2x, so x + 2x = 50, that is 3x = 50 and x = 50/3. Answer: 50/3, since 50/3 added to 100/3 makes 50 and 100/3 is twice 50/3. The distractors: 100/3 is the larger of the two numbers rather than the smaller one asked for; 25 comes from halving 50 and treating the two numbers as equal; 24 comes from reading 'twice the smaller number' as 'two more than the smaller number' and solving x + (x + 2) = 50.
- (c) 37 — The first differences are 3, 5, 7, 9 — they increase by 2 each time (the second difference), so the next first difference is 11, giving 26+11=37. A candidate who repeats the last first difference (9) instead of increasing it would reach 26+9=35. A candidate who increases the difference by 4 instead of 2 would reach 26+13=39. A candidate who adds only the second difference (2) to the last term, instead of the next first difference, would reach 26+2=28.
- (c) n = 4 — Testing n = 4: 4² = 16, and 16 + 4 + 1 = 21, and 21 = 3 × 7 is not a prime number, so this value disproves the claim. Testing n = 1: 1² = 1, and 1 + 1 + 1 = 3, which is prime, so it does not disprove the claim. Testing n = 2: 2² = 4, and 4 + 2 + 1 = 7, which is prime. Testing n = 3: 3² = 9, and 9 + 3 + 1 = 13, which is also prime — a counterexample has to give a result that isn't prime, and only n = 4 does that.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
- (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
- (a) 4 — Rectangle 1: P = 2(9 + 4) = 2 × 13 = 26 cm. Rectangle 2: P = 2(6 + 5) = 2 × 11 = 22 cm. Difference = 26 − 22 = 4 cm. 2 comes from finding the difference between (l + w) for each rectangle, 13 − 11 = 2, but forgetting to double it. 26 comes from giving rectangle 1's whole perimeter instead of the difference between the two. 6 comes from doubling only the change in length, 2 × (9 − 6), and ignoring that the width also changed.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (a) P — A sequence is geometric when consecutive terms share a constant ratio. For P: 6 ÷ 3 = 2, 12 ÷ 6 = 2, 24 ÷ 12 = 2 — the ratio is constant at 2, so P is geometric. Q is the square numbers (1², 2², 3², 4²), a quadratic sequence: its ratios are 4, 2.25, 1.78, … — not constant. R looks geometric at first (2, 4, 8 doubles each time), but the pattern breaks: 8 to 14 is a ratio of 1.75, not 2. Its first differences are 2, 4, 6 — a constant second difference of 2 — so R is a quadratic sequence, not geometric. S has a constant DIFFERENCE of 5 (it is arithmetic), but its ratios (2, 1.5, 1.33, …) are not constant, so it is not geometric.
- (d) x = (y + 8) / 3 — Method: add 8 to both sides, then divide the whole side by 3. Working: y = 3x − 8, so adding 8 to both sides gives y + 8 = 3x, then dividing both sides by 3 gives x = (y + 8) / 3. The value x = y + 8 / 3 is Priya's version, which comes from dividing only the 8 by 3 instead of dividing the whole expression y + 8 by 3. The value x = (y − 8) / 3 comes from a sign error, keeping −8 instead of moving it to +8. The value x = 3(y + 8) comes from multiplying by 3 instead of dividing.
- (b) h = 2A/b — The height has been multiplied by the base and the result then divided by 2, so undo the division first. Multiplying both sides by 2 gives 2A = bh. Undoing the multiplication by the base comes next: dividing both sides by b gives 2A/b = h, so h = 2A/b. Dividing by 2 instead of multiplying gives A/(2b), a quarter of the correct height; multiplying by the base instead of dividing gives 2Ab; writing b/(2A) turns the final fraction upside down.
- (c) £9.70 — F = 2.50 + 1.20 × 6 = 2.50 + 7.20 = £9.70. £7.20 comes from forgetting to add the £2.50 fixed charge. £10.20 comes from adding the 2.50 to the number of miles before multiplying by 1.20, 1.20 × (6 + 2.50). £22.20 comes from adding the fixed charge and the rate together first and then multiplying by the miles, (2.50 + 1.20) × 6.
- (b) √2 — 5√2 ÷ 5 = √2. Checking between the third and second terms: 10 ÷ 5√2 = √2 as well (since 10 ÷ 5√2 = 2 ÷ √2 = √2), so the common ratio is confirmed as √2 throughout. Squaring the ratio instead of leaving it as a surd gives 2, which is wrong because 2 is the SQUARE of the common ratio, not the ratio itself. Rounding the exact surd to a decimal gives 1.41, which is wrong because the sequence is defined using an exact surd ratio, and a rounded decimal is not the same value. Writing down the SECOND TERM of the sequence, 5√2, instead of the ratio BETWEEN terms, gives 5√2, which is wrong because a term of the sequence is not the same thing as the common ratio.
Build your own mix at the worksheet builder.