Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (a) It gets closer to zero but never actually reaches it. — y = 60 × (0.5)ˣ is always positive, however large x is, because a positive number raised to any power stays positive. As x increases, (0.5)ˣ gets smaller and smaller but never equals zero, so y approaches zero without ever reaching it. Believing the curve reaches zero when x = 60, because 60 is the starting value, mixes up the y-intercept with a stopping point — an exponential decay curve like this one never actually reaches the x-axis, so this is wrong. Believing the curve goes negative for large x is wrong because multiplying a positive number by (0.5) any number of times can never produce a negative result. Believing the curve levels off at y = 0.5, confusing the base of the exponential with its eventual level, is wrong: the base only controls how fast the curve falls, not where it settles — this curve settles at y = 0, not y = 0.5. Whenever you sketch an exponential decay curve, draw it approaching the x-axis but never touching it.
- (d) $y = x^2 + 3$ — Method: a point lies on a curve only if substituting its x-coordinate into the equation gives back its y-coordinate, so read one or two points off curve B and test each equation. Working: curve B crosses the y-axis at (0, 3), and its lowest point is also (0, 3); substituting x = 0 into y = x² + 3 gives 0² + 3 = 3, which matches. Checking a second point: at x = 2 curve B is at y = 7, and 2² + 3 = 4 + 3 = 7, which matches as well. Answer: curve B has equation y = x² + 3. Distractor refutation: y = x² − 3 comes from reading the 3 as a move down instead of a move up; substituting x = 0 gives −3, so that curve would cross the y-axis three squares below the origin, while curve B crosses it three squares above. y = (x − 3)² comes from putting the 3 inside the brackets; substituting x = 0 gives (−3)² = 9, and that curve's lowest point is at (3, 0), three squares to the right along the x-axis, whereas curve B has its lowest point on the y-axis. y = x² + 3x comes from attaching the 3 to the x term instead of writing it on its own; substituting x = 0 gives 0² + 3 × 0 = 0, so that curve passes through the origin, and curve B does not pass through the origin.
- (b) 319 — Substitute n = 10: 3 × 10² + 2 × 10 − 1 = 3 × 100 + 20 − 1 = 300 + 20 − 1 = 319. A sign error on the +2n term, treating it as −2n, gives 300 − 20 − 1 = 279. Working out 3 × 10² + 2 × 10 but forgetting to subtract the final 1 gives 300 + 20 = 320. Using n = 9 instead of n = 10 gives 3 × 81 + 18 − 1 = 243 + 18 − 1 = 260.
- (b) The total volume of water, in litres, that has flowed in. — On a rate-time graph, the y-axis is in litres per minute and the x-axis is in minutes; multiplying a rate by a time gives litres per minute × minutes = litres, a total volume. So the area under the graph represents the total volume of water that has flowed in. Thinking the area itself represents the rate, rather than what the rate accumulates to, gives the wrong claim about the average rate of flow. Confusing the area with the gradient of the graph — which measures how the rate is changing — gives the wrong claim about litres per minute squared. Ignoring the flow-rate axis and focusing only on the time axis gives the wrong claim that the area is simply the total time.
- (d) 12 — Method: substitute the value into both terms, remembering that subtracting a negative number has the same effect as adding the matching positive number. Working: n² = (−3) × (−3) = 9, and subtracting n means subtracting −3, which adds 3, so the calculation is 9 + 3 = 12. Answer: 12. The distractors: 6 comes from subtracting 3 rather than subtracting −3, giving 9 − 3; −6 comes from squaring −3 as −9 while still adding the 3, giving −9 + 3; −3 comes from reading n² as 2n, giving 2 × (−3) = −6 and then −6 + 3.
- (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
- (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
- (a) 45 — The ratio between the two given points, one power of x apart, gives b: 405 ÷ 135 = 3, so b = 3. Substituting back, at x = 1, y = A × b, so 135 = A × 3, giving A = 45. Giving the common ratio b itself instead of A confuses which unknown was asked for and produces 3 — wrong, because the question asks for A, not b. Giving 135 instead treats the first given point as the y-intercept and reads A off it directly — wrong, because that point is at x = 1, not x = 0, so 135 is A × b, not A. Assuming A equals b⁰ = 1 by itself, rather than substituting a known point to solve for A, gives 1 — wrong, because b⁰ is always 1 regardless of A; A must be found using an actual (x, y) pair from the graph.
- (c) Statement (ii) — Statement (ii) opens with 'Since n(n + 1) is even', treating the very fact the proof is meant to establish as if it were already known — that is circular reasoning, assuming the conclusion to help derive itself. Statement (i) only names the two consecutive integers as n and n + 1; it makes no claim about whether their product is even, so it introduces nothing circular. Statement (iii) states the conclusion, and would be a valid final step if statement (ii) had reached 'one of n and n + 1 is even' by a genuine argument, such as considering the cases where n is even or odd separately. Saying the proof assumes nothing circular is wrong, because statement (ii)'s opening clause is exactly that assumption.
- (d) a = 4 — Expand the left-hand side: (2x + 3)(x + a) = 2x² + 2ax + 3x + 3a = 2x² + (2a + 3)x + 3a. For this to match 2x² + 11x + 12 for every value of x, the x-coefficients must be equal and the constants must be equal: 2a + 3 = 11 and 3a = 12. Both give a = 4, so a = 4. Writing a = 12 comes from the constant-term equation 3a = 12: reading it as saying a itself is 12, rather than dividing both sides by 3. Writing a = 8 comes from the x-coefficient equation 2a + 3 = 11: working out 11 − 3 = 8 correctly but then stopping, without dividing by the 2 in front of a. Writing a = −4 comes from rearranging 2a + 3 = 11 the wrong way round, as 2a = 3 − 11 = −8, which gives a = −4 instead of a = 4.
- (b) 10 — Check n = 9: a₉ = 3 × 2⁸ = 3 × 256 = 768, below 1,000. Check n = 10: a₁₀ = 3 × 2⁹ = 3 × 512 = 1,536, above 1,000. So the first term greater than 1,000 is at position n = 10. Answering 9 comes from forgetting the −1 shift and using the formula as 3 × 2ⁿ instead of 3 × 2ⁿ⁻¹: checking 3 × 2⁹ = 1,536 (which exceeds 1,000) but then reporting the position as n = 9, the exponent used, instead of n = 10 — wrong, because the exponent in the real formula is n − 1, not n. Answering 11 comes from going one term too far: correctly finding that a₁₀ already exceeds 1,000, but then checking one position further and reporting n = 11 instead of stopping at the first position that already works — wrong, because n = 11 is not the FIRST term greater than 1,000. Answering 1,536 gives the VALUE of the term (a₁₀ itself) rather than its position — wrong, because the question asks which term it is (the value of n), not what that term is worth.
- (c) 3c + 2d — Method: 'triple c' is 3c, 'double d' is 2d, and 'add' joins the two separate terms with a plus sign. Working: 3c + 2d. Answer: 3c + 2d. 2c + 3d comes from swapping which letter gets tripled and which gets doubled. 6cd comes from multiplying the two terms together instead of adding them, and also multiplying the coefficients (3 × 2 = 6). 5(c + d) comes from adding the coefficients (3 + 2 = 5) and applying that single number to both letters together, as if c and d always came as a pair.
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
Build your own mix at the worksheet builder.