Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (b) h = 2A/b — The height has been multiplied by the base and the result then divided by 2, so undo the division first. Multiplying both sides by 2 gives 2A = bh. Undoing the multiplication by the base comes next: dividing both sides by b gives 2A/b = h, so h = 2A/b. Dividing by 2 instead of multiplying gives A/(2b), a quarter of the correct height; multiplying by the base instead of dividing gives 2Ab; writing b/(2A) turns the final fraction upside down.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (c) 6,400 — 9 hours contains 9 ÷ 3 = 3 whole periods of doubling, so the population is 800 × 2³. Since 2³ = 8, the population after 9 hours is 800 × 8 = 6,400. Adding 100% growth three times instead of compounding it — treating the growth as simple, not repeated doubling — gives 800 × 4 = 3,200, which is wrong because each period doubles the CURRENT population, not the original one. Using 9 as the power instead of dividing by the 3-hour period first gives 800 × 2⁹ = 409,600, which is wrong because the exponent counts periods, not hours. Giving the growth factor 2³ = 8 on its own, without multiplying by the starting population 800, leaves the answer as 8, which is wrong because the question asks for the population, not the multiplier. Always check that your final number of periods matches the total time divided by the period length.
- (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
- (d) 1 — Method: find the step in the outputs for each step of 1 in the input, write the rule from that step and from one pair of values, then apply the rule to the last input. Working: the outputs −5, −3, −1 rise by 2 while x rises in ones, so x is multiplied by 2; at x = 1, 2 × 1 = 2 while y = −5, so 7 is subtracted, giving y = 2x − 7; at x = 4 the rule gives 2 × 4 = 8 and 8 − 7 = 1. Answer: y = 1. The distractors: 3 comes from carrying the outputs on one step too far, to x = 5; 0 comes from assuming the outputs −5, −3, −1 carry on by adding 1 rather than by adding 2; 8 comes from doubling the input and forgetting to subtract the 7.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (a) 8 — f(x − 1) means every input to f is reduced by 1 before it is looked up. At x = 2, the input to f becomes 2 − 1 = 1, so f(x − 1) at x = 2 is f(1) = 8. Reading f(2) = 4 directly from the table, without applying the shift, gives 4. Shifting in the wrong direction, using x + 1 = 3 instead of x − 1 = 1, gives f(3) = 1. Confusing f(x − 1) with f(x) − 1 — taking f(2) = 4 and then subtracting 1 — gives 3.
- (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).
- (b) The total volume of water, in litres, that has flowed in. — On a rate-time graph, the y-axis is in litres per minute and the x-axis is in minutes; multiplying a rate by a time gives litres per minute × minutes = litres, a total volume. So the area under the graph represents the total volume of water that has flowed in. Thinking the area itself represents the rate, rather than what the rate accumulates to, gives the wrong claim about the average rate of flow. Confusing the area with the gradient of the graph — which measures how the rate is changing — gives the wrong claim about litres per minute squared. Ignoring the flow-rate axis and focusing only on the time axis gives the wrong claim that the area is simply the total time.
- (a) x = 6 — Method: a minus sign in front of a bracket changes the sign of every term inside it, so expand the bracket first and then simplify. Working: expanding gives 4x − 2x + 6 = 18, which simplifies to 2x + 6 = 18; subtracting 6 from both sides gives 2x = 12, and dividing both sides by 2 gives x = 6. Answer: x = 6. The distractors: x = 12 comes from leaving the −6 unchanged when the bracket is removed, giving 4x − 2x − 6 = 18 and so 2x = 24; x = 24 comes from reaching 2x = 12 correctly and then multiplying by 2 instead of dividing by 2; x = 3 comes from dividing by 2 too early, at 2x + 6 = 18, and dividing only the 2x and the 18 while leaving the 6 untouched, which gives x + 6 = 9.
- (b) 20 — 3x² − 4x = 3(−2)² − 4(−2) = 3(4) − (−8) = 12 + 8 = 20. A candidate who makes a sign error on −4x, treating −4 × −2 as −8 instead of +8, gets 12 − 8 = 4. A candidate who squares −2 but keeps the result negative, using 3 × (−4) = −12 for the first term, but correctly works out −4x = −4 × (−2) = 8, gets −12 + 8 = −4. A candidate who squares the whole term 3x, working out (3 × −2)² − 4 × (−2), gets (−6)² + 8 = 36 + 8 = 44.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
Build your own mix at the worksheet builder.