Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 3w − 5 ≥ 16 — "Three times w, minus 5" translates to 3w − 5, and "is at least 16" means it must be 16 or more, giving 3w − 5 ≥ 16. A candidate who reads "at least" as a strict inequality writes 3w − 5 > 16. A candidate who misreads the wording and applies the subtraction before the multiplication writes 3(w − 5) ≥ 16. A candidate who reverses the direction of the inequality writes 3w − 5 ≤ 16.
- (d) £2000 — This is an arithmetic sequence with first term £500 and common difference £300. The 6th term is 500 + 5 × 300 = 2000. A candidate who uses 6 lots of the increase instead of 5 gets 500 + 6 × 300 = 2300. A candidate who forgets to add the first year's profit at all gets 5 × 300 = 1500. A candidate who miscounts the number of increases as 4 instead of 5 gets 500 + 4 × 300 = 1700.
- (b) (3, 3) and (−1, −5) — Set the two expressions for y equal: x² − 6 = 2x − 3, which rearranges to x² − 2x − 3 = 0. Factorise: (x − 3)(x + 1) = 0, so x = 3 or x = −1. Substitute into the linear equation, y = 2x − 3: x = 3 gives y = 3; x = −1 gives y = −5. The points are (3, 3) and (−1, −5). Distractor routes: (3, 3) and (1, −1) comes from mis-factorising x² − 2x − 3 as (x − 3)(x − 1), giving a second root of 1 instead of −1. (3, 9) and (−1, 1) comes from finding the y-coordinate from y = x² instead of substituting back into the given line equation y = 2x − 3. (3, 3) alone stops after finding only the first root of the quadratic.
- (d) It is n-shaped, since the x² coefficient is negative. — The coefficient of x² is −2, which is negative, so the quadratic curve opens downward — shaped like an n, with a maximum turning point. Saying it is U-shaped focuses only on x² being non-negative and ignores that the −2 in front of it flips the whole curve to open downward. Saying it is a straight line confuses having a constant term with being linear — any equation with an x² term is a curve, not a line. Saying it repeatedly rises and falls like a wave describes a trigonometric graph such as y = sin x, not a quadratic.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (d) (x − 7)² + 1 is at least 1 for every x, so y is never 0 — x² − 14x + 50 = (x − 7)² − 7² + 50 = (x − 7)² + 1. Since a squared term can never be negative, (x − 7)² ≥ 0 for every real x, so y = (x − 7)² + 1 ≥ 1 for every x — y is always at least 1, so it can never equal 0, and the curve never crosses the x-axis. Claiming the discriminant is positive is wrong on the facts: b² − 4ac = (−14)² − 4(1)(50) = 196 − 200 = −4, which is NEGATIVE, not positive — a negative discriminant is in fact the standard reason a quadratic has no real roots, so this option misstates its own sign. Claiming the turning point is at (7, −1) is wrong because completing the square gives (x − 7)² + 1, so the turning point is (7, 1) — the constant is +1, not −1, and a point with a negative y-coordinate would sit BELOW the x-axis, not above it, contradicting the option's own claim. Claiming that 50 being positive is enough is wrong because it ignores the −14x term completely — a positive constant term alone does not guarantee y stays positive for every x (the expression still dips down towards its turning point before growing again, and it is the completed square that shows how far it dips, not the constant on its own).
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) 12 — Method: substitute the value into both terms, remembering that subtracting a negative number has the same effect as adding the matching positive number. Working: n² = (−3) × (−3) = 9, and subtracting n means subtracting −3, which adds 3, so the calculation is 9 + 3 = 12. Answer: 12. The distractors: 6 comes from subtracting 3 rather than subtracting −3, giving 9 − 3; −6 comes from squaring −3 as −9 while still adding the 3, giving −9 + 3; −3 comes from reading n² as 2n, giving 2 × (−3) = −6 and then −6 + 3.
- (c) x = 5, y = 5 — x² − 10x + 30 = (x − 5)² − 5² + 30 = (x − 5)² + 5. Substituting x = 5: 5² = 25, 10 × 5 = 50, so 25 − 50 + 30 = 5, confirming the minimum value 5 at x = 5: turning point (5, 5). Using −10 instead of half of it inside the bracket gives (x − 10)² − 70, turning point (10, −70) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−5, 5) — wrong, because (x − 5)² is zero at x = 5, not x = −5. Computing 25 − 30 = −5 instead of 30 − 25 = 5 flips the sign of the constant, giving (5, −5) — wrong, since the completed square's constant must be evaluated as 30 minus 25, not 25 minus 30. Always check a turning point by substituting its x-value back into the original equation.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
- (b) 1.6 m/s² — Acceleration is the change in velocity divided by the time taken: (11 − 3) ÷ 5 = 8 ÷ 5 = 1.6 m/s². Forgetting to subtract the initial velocity and dividing the final velocity by the time instead gives 11 ÷ 5 = 2.2 m/s². Inverting the fraction, dividing the time by the change in velocity, gives 5 ÷ 8 = 0.625 m/s². Finding the change in velocity, 8 m/s, but stopping without dividing by the time gives 8 m/s².
- (c) y = 3x + 5 — Method: find the gradient from the two points, then substitute one point into y = mx + c to find c. Working: gradient = (14 − 2) ÷ (3 − (−1)) = 12 ÷ 4 = 3. Using the point (3, 14): 14 = 3(3) + c, so 14 = 9 + c, giving c = 5. Answer: y = 3x + 5. y = 6x − 4 comes from mishandling the negative x-coordinate, treating 3 − (−1) as 3 − 1 = 2, so the gradient becomes 12 ÷ 2 = 6, and then c = 14 − 18 = −4. y = 3x + 23 comes from a sign error isolating c, adding 9 to 14 instead of subtracting it: c = 14 + 9 = 23. y = x/3 + 13 comes from dividing the change in x by the change in y instead of the other way round, giving a gradient of 4 ÷ 12 = 1/3, and then c = 14 − 1 = 13.
- (b) 85 — Substitute n = 10: 10² − 2 × 10 + 5 = 100 − 20 + 5 = 85. A sign error on the −2n term, treating it as +2n, gives 100 + 20 + 5 = 125. Using n = 9 instead of n = 10 gives 81 − 18 + 5 = 68. Working out 10² − 2 × 10 but forgetting to add the final +5 gives 80.
- (d) −2 — Method: run the machine backwards, undoing the operations in the opposite order and swapping each one for its inverse. Working: the machine added 7 last, so take 7 off the output: 1 − 7 = −6; before that the machine had multiplied by 3, so divide: −6 ÷ 3, and a negative divided by a positive stays negative. Answer: −2, which checks because 3 × (−2) + 7 = −6 + 7 = 1. The distractors: 2 comes from dividing 6 by 3 and losing the minus sign; −6 comes from taking the 7 off and stopping there, never undoing the multiplication; −18 comes from multiplying −6 by 3 instead of dividing by 3.
Build your own mix at the worksheet builder.