Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (b) n² + 2n + 3 — First differences: 5, 7, 9, 11. Second differences: 2, 2, 2, so a = 2 ÷ 2 = 1. Subtracting n² (1, 4, 9, 16, 25) from the terms (6, 11, 18, 27, 38) leaves 5, 7, 9, 11, 13, which is the linear expression 2n + 3. So the nth term is n² + 2n + 3. Using the second difference itself as a, without halving it, gives 2n² + 2n + 3. Finding a = 1 correctly but then dropping the linear part 2n, keeping only the constant, gives n² + 3. Finding a = 1 correctly but dropping the constant +3 gives n² + 2n.
- (d) n/2 + 5 — Half of n is n ÷ 2, which is written as the fraction n/2. 'More than' means add, and the addition happens after the halving, so the expression is n/2 + 5. Writing (n + 5)/2 halves the 5 as well, because everything inside a bracket is divided; writing 2n + 5 doubles n instead of halving it; writing 5n/2 multiplies half of n by 5 instead of adding 5 to it.
- (d) 23 — Method: let the smallest integer be n, so the three consecutive integers are n, n + 1 and n + 2. Form the equation n + (n + 1) + (n + 2) = 72. Working: simplify the left side: 3n + 3 = 72, so 3n = 69, giving n = 23. Answer: 23. 24 comes from dividing 72 by 3 directly, 72 ÷ 3 = 24, which finds the middle integer rather than realising the three numbers differ. 25 comes from correctly finding n = 23 but reading off the largest integer, n + 2, instead of the smallest as asked. 21 comes from dividing first and subtracting after, (72 ÷ 3) − 3, instead of subtracting 3 before dividing by 3.
- (d) 8 — Method: write the nth term of the sequence, 2000 + 800(n − 1), and find the smallest whole n for which it is greater than 7000. Working: 2000 + 800(n − 1) > 7000, so 800(n − 1) > 5000, giving n − 1 > 6.25. Since n − 1 must be a whole number, the smallest value is 7, so n = 8. Check: year 8's total is 2000 + 800 × 7 = 7600, which is more than £7000, while year 7's total is 2000 + 800 × 6 = 6800, which is not. Answer: year 8. 7 comes from rounding 6.25 to the nearest whole number, 6, and then adding 1, instead of rounding up to the next whole number before adding 1. 6 comes from using 6.25 rounded down to 6 as the year number directly, without adding the 1 needed to convert from the number of increases to the year number. 9 comes from adding one extra year beyond the year that already satisfies the condition.
- (d) x³ + 6x² + 11x + 6 — (x + 1)(x + 2) = x² + 3x + 2. Multiplying by (x + 3): (x² + 3x + 2)(x + 3) = x³ + 3x² + 2x + 3x² + 9x + 6, which simplifies to x³ + 6x² + 11x + 6. Choosing x³ + 6x² + 6x + 6 has the right x² and constant terms but adds 1 + 2 + 3 = 6 for the x-coefficient instead of the correct sum of pairwise products 1×2 + 1×3 + 2×3 = 11. Choosing x³ + 5x² + 11x + 6 sums only two of the three constants (2 + 3 = 5) for the x² coefficient, leaving out the 1. Choosing x³ + 6x² + 11x + 5 adds the last two constants (2 + 3 = 5) instead of multiplying all three (1 × 2 × 3 = 6) for the constant term.
- (b) 6 — Method: for any point that lies on y = k/x, the value of k is found by multiplying the x-coordinate and the y-coordinate together, since k = x × y. Working: k = 2 × 3 = 6. Answer: k = 6. Distractor refutation: 1.5 comes from dividing the y-coordinate by the x-coordinate instead of multiplying them. 5 comes from adding the two coordinates instead of multiplying them. 9 comes from misreading the point's x-coordinate as 3 instead of 2, then multiplying 3 × 3.
- (c) 64 m — The distance travelled is the area under the speed-time graph. From t = 0 to t = 4, the shape is a triangle with base 4 and height 8, area 1/2 × 4 × 8 = 16. From t = 4 to t = 10, the shape is a rectangle with base 6 and height 8, area 6 × 8 = 48. Total distance: 16 + 48 = 64 m. Treating the whole 10 seconds as a single trapezium with parallel sides 0 and 8 and width 10, instead of splitting it into the triangle and rectangle, gives 40 m. Ignoring the acceleration phase completely and assuming the car travels at a constant 8 m/s for all 10 seconds gives 8 × 10 = 80 m. Misreading the second interval as running from t = 4 to t = 8 instead of t = 4 to t = 10 gives a rectangle area of 4 × 8 = 32, plus the correct triangle of 16, totalling 48 m.
- (a) Underestimate: the chord lies below the curve — For a curve that is concave down (bending downward), the straight line joining any two points on the curve lies BELOW the curve. The trapezium's top edge is this straight line, so the trapezium's area is smaller than the true area under the curve — the trapezium rule UNDERESTIMATES the distance in this case. This is because a curve whose gradient keeps decreasing bends away from any chord joining two of its points, dropping the chord below every point of the curve in between. The reverse, a chord lying above the curve, is the rule for a concave-up curve, not this one — check which way the curve bends before deciding. The trapezium rule does not always overestimate or underestimate, and it is not exact except when the graph really is a straight line.
- (b) y decreases towards zero but never reaches it — Method: as x gets larger, dividing 20 by a bigger number gives a smaller result, so y decreases; because 20/x can never be exactly zero for any positive x, the curve gets closer to zero without ever reaching it, so y decreases towards zero but never reaches it. Distractor origins: 'y increases towards a limit but never reaches it' has the relationship backwards, treating y as increasing when it is actually decreasing; 'y decreases at a steady rate and reaches zero' wrongly assumes the graph behaves like a straight line that eventually hits zero; 'y stays the same however large x becomes' wrongly assumes there is no change in y at all.
- (b) 2n + 3 — Method: multiply the cost per mile by the number of miles to get an expression, then add the fixed fee as a separate term. Working: n miles at £2 each is 2n; add the £3 fixed fee: 2n + 3. Answer: 2n + 3. 3n + 2 comes from swapping the fee and the rate round, treating £3 as the rate per mile and £2 as the fixed fee. 5n comes from adding the fee and the rate together first (3 + 2 = 5) and multiplying the result by n, instead of keeping the fixed fee as its own term. 2n − 3 comes from subtracting the fixed fee instead of adding it.
- (c) 71 — Method: square x first, then multiply by 3, then subtract 4, following the order of operations. Working: x² = 5² = 25; 3 × 25 = 75; 75 − 4 = 71. Answer: 71. 221 comes from squaring (3x) as a whole first: (3 × 5)² = 225, then − 4 = 221, squaring the coefficient along with x. 75 comes from correctly working out 3x² but forgetting to subtract the 4. 3 comes from subtracting the 4 from x before squaring: (5 − 4)² × 3 = 3, doing the operations in the wrong order.
- (d) (6, 6) — y = f(x − 4) + 1 combines two translations: the −4 inside the brackets moves the graph 4 units to the RIGHT, and the +1 outside the brackets moves it 1 unit UP. Applying both to (2, 5): add 4 to the x-coordinate 2, and add 1 to the y-coordinate 5, giving (6, 6). Moving left instead of right, as the minus sign inside the bracket might suggest, gives (−2, 6) or (−2, 4); forgetting the horizontal shift altogether and only applying the vertical one gives (2, 6).
- (c) x = 8 — The turning point lies exactly halfway between the two roots. If the other root is r, the midpoint of −2 and r must be 3, so (−2 + r) ÷ 2 = 3, giving r = 8. Choosing x = 5 comes from adding 2 and 3 rather than using the midpoint relationship correctly. Choosing x = 1 comes from subtracting 2 from 3 instead of reflecting −2 across the turning point. Choosing x = −8 finds the right distance but then reflects in the y-axis instead of in the line of symmetry x = 3, so the sign of the answer is flipped.
- (d) h = 2A / (a + b) — Method: undo the multiplication by 1/2 by multiplying both sides by 2, then undo the multiplication by (a + b) by dividing both sides by it. Working: A = (a + b)h / 2, so multiplying both sides by 2 gives 2A = (a + b)h, then dividing both sides by (a + b) gives h = 2A / (a + b). The value h = A / (a + b) comes from forgetting to multiply by 2 to clear the 1/2 first. The value h = 2A / a + b comes from dividing only by a and leaving b outside the fraction, instead of dividing by the whole bracket (a + b). The value h = (a + b) / (2A) comes from inverting the fraction.
Build your own mix at the worksheet builder.