Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) w ≤ 630 — 'No more than 630 kg' means the weight can be exactly 630 kg or anything less, so the correct inequality is w ≤ 630, using 'less than or equal to' to include the limit itself. Writing w < 630 excludes 630 kg itself, as though the limit could not be reached exactly. Writing w ≥ 630 reverses the direction, describing a minimum weight rather than a maximum. Writing w > 630 both reverses the direction and excludes the boundary value. The inequality describing the lift's weight limit is w ≤ 630.
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (d) 66 — 6 and (4x + 3) are correct factors of 24x + 18. — Substituting x=2 into 24x+18: 24×2+18=48+18=66. Checking the factorisation: 6×4x=24x and 6×3=18, so 6(4x+3)=24x+18, matching the original expression — 6 and (4x+3) are correctly identified as factors. A candidate who substitutes x=2 into (4x+3) but forgets to multiply by the factor 6 afterwards would compute just 4×2+3=11. A candidate who adds 24 and 18 together before multiplying by x, instead of multiplying 24 by x first, would compute (24+18)×2=84. A candidate who distributes the 6 over only the first term inside the brackets, forgetting the second, would check the factorisation as 6×4x=24x but leave the 3 unmultiplied, getting 24x+3 instead of 24x+18 — and would wrongly conclude that 6 and (4x+3) are not correct factors.
- (a) 2 — The common ratio is 54 ÷ 162 = 1/3, confirmed by 18 ÷ 54 = 1/3 and 6 ÷ 18 = 1/3. The next term is 6 × 1/3 = 2. A candidate who wrongly treats the sequence as arithmetic and subtracts the last difference (18 − 6 = 12) again gets 6 − 12 = −6. A candidate who multiplies by 3 instead of dividing, effectively reversing the sequence, gets 18. A candidate who guesses the ratio is 1/2 gets 6 × 1/2 = 3.
- (c) Wrong — the correct equation is x² − 5x + 4 = 0. — Rearranging x − 2 = x² − 4x + 2 by moving every term across: 0 = x² − 4x + 2 − x + 2 = x² − 5x + 4. The candidate's x-term is wrong: combining −4x with the moved −x gives −4x − x = −5x, not −3x. So the correct equation is x² − 5x + 4 = 0. Distractor routes: "x² − 3x + 4 = 0 is correct" simply agrees with the candidate's sign error without checking it. "It should be x² − 5x − 4 = 0" correctly spots that something is wrong but blames the wrong term — the constant, 2 + 2 = 4, is correct; the error is in the x-term. "Subtracting is the same as adding" states something false: subtracting a term and adding it give different signs.
- (c) P — Sequence P has a common ratio of 2 (4 × 2 = 8, 8 × 2 = 16, 16 × 2 = 32), so it is geometric. Sequence Q has a common difference of 4, which is arithmetic, not geometric — a candidate who confuses a constant difference with a constant ratio picks Q. Sequence R has increasing differences of 3, 5, 7, a quadratic sequence, not geometric — a candidate who assumes any fast-growing sequence must be geometric picks R. Sequence S is the square numbers from 2² onwards (2², 3², 4², 5²), which is also quadratic, not geometric — a candidate who thinks squaring always means geometric growth picks S.
- (b) x² + y² = 1369 — For a circle centred at the origin, the radius squared equals the sum of the squares of the coordinates of any point on it: r² = 12² + 35² = 144 + 1225 = 1369. The equation is x² + y² = 1369. x² + y² = 2209 comes from adding the coordinates first and then squaring the sum: (12 + 35)² = 47² = 2209, instead of squaring each coordinate separately. x² + y² = 1225 comes from using only 35² and leaving out the 12² term. x² + y² = 144 comes from using only 12² and leaving out the 35² term.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (c) y = 4x − 5 — Parallel lines have the same gradient, so the new line has gradient 4; since it passes through (0, −5), its y-intercept is −5, giving y = 4x − 5. A candidate who drops the negative sign on the y-intercept would write y = 4x + 5. A candidate who changes the sign of the gradient, instead of keeping it the same for a parallel line, would write y = −4x − 5. A candidate who confuses m and c, using the y-intercept of the first line (3) as the gradient of the second, would write y = 3x − 5.
- (c) 32 — The terms are 60, 53, 46, 39, 32 — each found by subtracting 7 from the term before, so the 5th term is 32. Subtracting 7 five times from the first term instead of four times, 60 − 7 × 5 = 25, treats the first term as if it came before the sequence starts. Adding 7 four times instead of subtracting, 60 + 7 × 4 = 88, uses the wrong operation. Stopping one term early gives the 4th term, 39.
- (a) y = (1/4)x + 1/4 — Rearrange 4x + y = 12 to y = −4x + 12, so the path has gradient −4. The perpendicular gradient is 1/4. Substituting (3, 1) into y − 1 = (1/4)(x − 3): y = (1/4)x − 3/4 + 1 = (1/4)x + 1/4. Distractor routes: y = −4x + 13 uses the path's own gradient, −4, instead of the perpendicular gradient, giving a line PARALLEL to the path through (3, 1) rather than perpendicular to it. y = (1/4)x − 1/4 makes an arithmetic slip combining −3/4 and 1, landing on −1/4 instead of the correct 1/4. y = −(1/4)x + 1/4 takes the reciprocal of −4, which is −1/4, but forgets to change its sign, so it is not the true negative reciprocal.
- (c) x = 2y + 10 — Method: undo the operations done to x in reverse order — add 5, then multiply by 2. Working: y = x/2 − 5, so y + 5 = x/2, so x = 2(y + 5) = 2y + 10. Answer: x = 2y + 10. x = 2y + 5 comes from multiplying only the x/2 term by 2 and forgetting to multiply the 5 as well. x = 2y − 10 comes from a sign error, subtracting 5 instead of adding it before multiplying by 2. x = (y + 5)/2 comes from dividing by 2 instead of multiplying, the wrong operation to undo a division.
- (b) 25 — The tangent at (9, 12) is 9x + 12y = 225. Setting y = 0 (the x-axis): 9x = 225, so x = 25. Choosing 18.75 comes from swapping the coefficients in the tangent equation (using 12x + 9y = 225) before setting y = 0. Choosing 15 is where the circle itself meets the x-axis (from x² = 225), not where the tangent does. Choosing 9 is just the x-coordinate of the original point (9, 12), not the point P.
Build your own mix at the worksheet builder.