Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
- (d) 13 — Method: the numbers of matchsticks form a sequence with a term-to-term rule, so count the first square in full and then add the repeated amount once for every extra square. Working: one square uses 4 matchsticks; a row of 4 squares has 3 extra squares after the first, and each of those adds 3 matchsticks, giving 3 × 3 = 9 to add on to the 4. Answer: 13. The distractors: 16 comes from counting each square as a separate set of 4 matchsticks, 4 × 4, and ignoring the shared sides; 12 comes from using 3 matchsticks for all four squares, 3 × 4, and forgetting that the first square needs a fourth side; 10 comes from adding the 3 only twice, as though a row of four squares had two extra squares rather than three.
- (b) h = 2A/b — The height has been multiplied by the base and the result then divided by 2, so undo the division first. Multiplying both sides by 2 gives 2A = bh. Undoing the multiplication by the base comes next: dividing both sides by b gives 2A/b = h, so h = 2A/b. Dividing by 2 instead of multiplying gives A/(2b), a quarter of the correct height; multiplying by the base instead of dividing gives 2Ab; writing b/(2A) turns the final fraction upside down.
- (c) x = 5, y = 5 — x² − 10x + 30 = (x − 5)² − 5² + 30 = (x − 5)² + 5. Substituting x = 5: 5² = 25, 10 × 5 = 50, so 25 − 50 + 30 = 5, confirming the minimum value 5 at x = 5: turning point (5, 5). Using −10 instead of half of it inside the bracket gives (x − 10)² − 70, turning point (10, −70) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−5, 5) — wrong, because (x − 5)² is zero at x = 5, not x = −5. Computing 25 − 30 = −5 instead of 30 − 25 = 5 flips the sign of the constant, giving (5, −5) — wrong, since the completed square's constant must be evaluated as 30 minus 25, not 25 minus 30. Always check a turning point by substituting its x-value back into the original equation.
- (d) The graph never crosses either axis — Since x ≠ 0, there is no point on the graph where x = 0, so it cannot cross the y-axis; likewise 1/x is never equal to 0 for any x, so it cannot cross the x-axis either — the graph never touches either axis. A candidate who forgets the restriction x ≠ 0 might think the graph behaves like other graphs and passes through the origin, (0, 0). A candidate who correctly rules out the x-axis but forgets that x = 0 is also excluded might say the graph crosses the y-axis but never the x-axis. A candidate who only pictures the branch where x and y are both positive might say the graph has only one branch, in quadrant 1, forgetting the second branch where x and y are both negative.
- (b) y = f(−x) — y = f(−x) reflects the graph of y = f(x) in the y-axis: every x-coordinate changes sign. The x-intercepts −3 and 7 become 3 and −7, matching the second graph's intercepts −7 and 3. A point already on the y-axis is unaffected, since −0 = 0, so the y-intercept (0, 21) stays exactly where it is — matching the second graph as well. y = −f(x) leaves the x-intercepts unchanged at −3 and 7, since f(x) = 0 exactly where −f(x) = 0, which does not match; it also sends the y-intercept to (0, −21), a second mismatch. y = −f(−x) does send the x-intercepts to the right places, −7 and 3, but it sends the y-intercept to (0, −21) instead of (0, 21), so it fails the second clue. y = f(x) − 4 moves every point down 4, sending the y-intercept to (0, 17) instead of (0, 21), so it fails the y-axis clue. Test each option against BOTH clues — the pair of x-intercepts and the point on the y-axis — because more than one option gets only one of the two right.
- (a) 5x − 3 = 12 — 5x − 3 = 12 is an equation with exactly one solution: adding 3 and dividing by 5 gives x = 3, and no other value works. 5x − 3 = 5x − 3 is true for every value of x, since both sides are identical — it has infinitely many solutions, not one. 5x − 3 > 12 is an inequality: any value of x greater than 3 satisfies it, so it has a whole range of solutions, not a single one. 5x − 3 = 5x + 2 has no solution at all, since subtracting 5x from both sides leaves −3 = 2, which is never true. The equation with exactly one solution is 5x − 3 = 12.
- (d) (4, 3) — The sides are parallel to the axes: the missing vertex must share the y-coordinate 3 with (−2, 3) and the x-coordinate 4 with (4, −3), giving (4, 3). (−4, 3) comes from a sign error on the x-coordinate. (4, −9) comes from continuing the pattern of the given points by subtracting 6 from the y-coordinate again instead of matching it to (−2, 3). (3, 4) comes from swapping the x- and y-coordinates.
- (c) 5 — Method: substitute the value into the formula, work out the index first and the addition afterwards. Working: x² = (−2) × (−2) = 4, so y = 4 + 1 = 5. Answer: 5. The distractors: −3 comes from squaring only the 2 and keeping the minus sign outside the index, giving −4 + 1; 1 comes from adding the 1 to x before squaring, giving (−2 + 1)²; 4 comes from squaring correctly but stopping there and never adding the 1.
- (d) 680 m — First find how long the acceleration takes: acceleration = change in speed ÷ time, so 2.5 = 20 ÷ t, giving t = 20 ÷ 2.5 = 8 seconds. The distance during this phase is the area of a triangle with base 8 and height 20: 1/2 × 8 × 20 = 80 m. The distance during the constant-speed phase is 20 × 30 = 600 m, since distance = speed × time at a constant speed. The total distance is 80 + 600 = 680 m. Using the given 30 seconds for the acceleration phase as well, 1/2 × 30 × 20 = 300, plus the correct 600, gives 900 m — but 30 seconds is only stated for the constant-speed phase. Leaving out the 1/2 and using the full rectangle for the acceleration phase, 8 × 20 = 160, plus the correct 600, gives 760 m — the speed is not constant during acceleration, so this area is a triangle, not a rectangle. Swapping the two times round, and using 8 seconds for the constant-speed distance instead of 30, 20 × 8 = 160, plus the correct triangle area of 80, gives 240 m.
- (d) 7n + 5 — Method: find the rate charged per extra chair, then find the fixed part of the cost that fits hiring 1 chair. Working: the cost rises by £7 for each extra chair (19 − 12 = 7, 26 − 19 = 7, 33 − 26 = 7), so the cost has the form 7n + c. Substituting n = 1: 7(1) + c = 12, so c = 5. Answer: the cost in pounds is 7n + 5. The value 7n comes from ignoring the fixed part of the charge entirely. The value 7n + 12 comes from using the cost of 1 chair as the fixed part directly, without subtracting the per-chair rate first. The value 12n + 7 comes from swapping the roles of the cost of hiring 1 chair, £12, and the rate per extra chair, £7 — using the total for one chair as the coefficient of n and the rate as the fixed part.
- (b) −3/4 — The tangent to a circle at a point is always perpendicular to the radius drawn to that point. The radius from (0, 0) to (3, 4) has gradient 4/3. The gradient of a line perpendicular to a line with gradient m is the negative reciprocal, −1/m, so the tangent's gradient here is −3/4. Using the radius's own gradient, forgetting that the tangent is perpendicular to it, gives 4/3. Negating the radius's gradient without also taking the reciprocal gives −4/3. Taking the reciprocal of the radius's gradient without negating it gives 3/4.
- (d) 12 — Since a₃ = a₂ + a₁, rearranging gives a₂ = a₃ − a₁ = 17 − 5 = 12. 22 comes from adding instead of subtracting: a₃ + a₁ = 17 + 5 = 22. 11 comes from treating the sequence as if it were arithmetic and averaging the two given terms: (5 + 17) ÷ 2 = 11 — but a Fibonacci-type sequence isn't arithmetic, so this doesn't apply. −12 comes from subtracting in the wrong order: a₁ − a₃ = 5 − 17 = −12.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
Build your own mix at the worksheet builder.