Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) An inequality, because ≤ compares the two sides — The symbol ≤ means 'is less than or equal to', so the statement compares the sizes of the two sides instead of saying they are equal: that makes it an inequality. Solving it gives n ≤ 5, a whole range of values rather than the single value an equation would give. An identity has to be true for every value of the letter, and this fails at n = 6, so it is not one. A formula works one quantity out from another, and there is only one letter here.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (c) 5 — Method: substitute the value into the formula, work out the index first and the addition afterwards. Working: x² = (−2) × (−2) = 4, so y = 4 + 1 = 5. Answer: 5. The distractors: −3 comes from squaring only the 2 and keeping the minus sign outside the index, giving −4 + 1; 1 comes from adding the 1 to x before squaring, giving (−2 + 1)²; 4 comes from squaring correctly but stopping there and never adding the 1.
- (b) 8 — Method: a circle centred on the origin has equation x² + y² = r², where r is the radius, so the number on the right-hand side is the square of the radius and not the radius itself. Working: comparing x² + y² = 64 with x² + y² = r² gives r² = 64, so r = √64 = 8. Answer: the radius is 8. The distractors: 64 is r² read straight off the equation as though the right-hand side were the radius, which is the commonest error on this form; 32 comes from halving 64, treating the right-hand side as a diameter that has to be halved; 16 is the diameter, 2 × 8, quoted in place of the radius.
- (c) 360° — The graph of y = cos x repeats itself every 360°, so its period is 360°. 180° is the period of y = tan x, not y = cos x — confusing the two graphs gives this. 90° is the horizontal distance from a maximum of y = cos x to the next point where the graph crosses the x-axis, a quarter of the period, mistaken for the whole period. 720° comes from counting the interval containing two full repeats of the graph, from one maximum to the second repeat of that maximum, instead of the first.
- (b) (−5, −2) — A rotation of 180° about the origin reverses the sign of both coordinates, so Q = (−5, −2). A candidate who reverses the sign of only the y-coordinate, as if reflecting in the x-axis, gets (5, −2). A candidate who reverses the sign of only the x-coordinate, as if reflecting in the y-axis, gets (−5, 2). A candidate who swaps the coordinates instead of reversing their signs gets (2, 5).
- (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
- (d) h = 2A / (a + b) — Method: undo the multiplication by 1/2 by multiplying both sides by 2, then undo the multiplication by (a + b) by dividing both sides by it. Working: A = (a + b)h / 2, so multiplying both sides by 2 gives 2A = (a + b)h, then dividing both sides by (a + b) gives h = 2A / (a + b). The value h = A / (a + b) comes from forgetting to multiply by 2 to clear the 1/2 first. The value h = 2A / a + b comes from dividing only by a and leaving b outside the fraction, instead of dividing by the whole bracket (a + b). The value h = (a + b) / (2A) comes from inverting the fraction.
- (d) a = 4 — Expand the left-hand side: (2x + 3)(x + a) = 2x² + 2ax + 3x + 3a = 2x² + (2a + 3)x + 3a. For this to match 2x² + 11x + 12 for every value of x, the x-coefficients must be equal and the constants must be equal: 2a + 3 = 11 and 3a = 12. Both give a = 4, so a = 4. Writing a = 12 comes from the constant-term equation 3a = 12: reading it as saying a itself is 12, rather than dividing both sides by 3. Writing a = 8 comes from the x-coefficient equation 2a + 3 = 11: working out 11 − 3 = 8 correctly but then stopping, without dividing by the 2 in front of a. Writing a = −4 comes from rearranging 2a + 3 = 11 the wrong way round, as 2a = 3 − 11 = −8, which gives a = −4 instead of a = 4.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (a) 19 — Each time x increases by 1, y increases by 3 (4, 7, 10, 13 — a constant difference of 3). So at x = 4, y = 13 + 3 = 16, and at x = 5, y = 16 + 3 = 19. A candidate who stops one step early, giving the value for x = 4 instead of x = 5, answers 16. A candidate who overcounts and adds three steps of 3 instead of two from x = 3 gets 13 + 9 = 22. A candidate who mistakes the y-intercept (4) for the common difference and adds 4 twice from x = 3 gets 13 + 8 = 21.
- (d) 47 — To reach the 8th term from the 1st term, the difference of 6 is added 7 times (8 − 1 = 7): 5 + 7 × 6 = 47. A candidate who multiplies by the term number itself, rather than one less, would compute 5 + 8 × 6 = 53. A candidate who uses one step too few (6 instead of 7) would reach 5 + 6 × 6 = 41. A candidate who forgets to include the first term at all would compute just 8 × 6 = 48.
- (c) 4 — x² + 12x + 40 = (x + 6)² − 6² + 40 = (x + 6)² + 4, so a = 6 and b = 4. Since (x + 6)² can never be negative, y = (x + 6)² + 4 is smallest when the bracket is zero, so the minimum value of y is 4. Giving 40 instead reads off the ORIGINAL constant term and ignores the completing-the-square step entirely — wrong, because 40 is the value of y when x = 0, not the minimum value. Giving −6 instead answers with the x-coordinate of the turning point (where the bracket is zero) rather than the minimum y-value itself — wrong, because the question asks for the minimum value of y, not the value of x that produces it. Giving 36 instead stops after squaring half the coefficient, 6² = 36, without combining it with the 40 already in the expression — wrong, because the minimum value is 40 minus 36, not 36 on its own.
- (b) 5 — Method: expand the bracket first, then solve the resulting linear equation. Working: 3(2x − 1) = 6x − 3, so 6x − 3 = 27. Add 3 to both sides: 6x = 30. Divide by 6: x = 5. Answer: 5. 4 2/3 comes from multiplying only the 2x inside the bracket by 3 and forgetting to multiply the −1 as well, giving 6x − 1 = 27. 4 comes from a sign error when expanding, writing 6x + 3 instead of 6x − 3. 4.5 comes from dividing 27 by 3 to get 2x − 1 = 9, then forgetting to add 1 back before dividing by 2, using 2x = 9 instead of 2x = 10.
- (c) y = (5/12)x − 169/12 — The gradient of the radius to (5, −12) is (−12 − 0) ÷ (5 − 0) = −12/5. A tangent is perpendicular to the radius at that point, so its gradient is the negative reciprocal, 5/12. Using y − y₁ = m(x − x₁) with (5, −12): y + 12 = (5/12)(x − 5), which gives y = (5/12)x − 169/12. y = −(12/5)x comes from using the radius's own gradient, −12/5, instead of turning it into the perpendicular gradient, and building the line through the origin (as the radius itself does). y = −(5/12)x − 119/12 comes from taking the reciprocal of −12/5 correctly as a size but keeping the wrong sign, using −5/12 instead of 5/12. y = (5/12)x − 25/12 comes from using the correct gradient 5/12 but building the line through (5, 0) instead of (5, −12) — dropping the point's y-coordinate.
Build your own mix at the worksheet builder.