Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (d) (4, 3) — The sides are parallel to the axes: the missing vertex must share the y-coordinate 3 with (−2, 3) and the x-coordinate 4 with (4, −3), giving (4, 3). (−4, 3) comes from a sign error on the x-coordinate. (4, −9) comes from continuing the pattern of the given points by subtracting 6 from the y-coordinate again instead of matching it to (−2, 3). (3, 4) comes from swapping the x- and y-coordinates.
- (d) y = −f(x + 2) has a maximum turning point at (1, 5). — y = f(x + 2) translates the graph 2 units in the negative x-direction, so the turning point's x-coordinate moves from 3 to 1; reflecting in the x-axis then negates the y-coordinate, turning −5 into 5, and also turns a minimum into a maximum — giving a true maximum turning point at (1, 5). Translating the root at x = 1 in the wrong direction, adding 2 instead of subtracting it, gives x = 3, but the true image root is at 1 − 2 = −1, so that statement is false. Keeping the coordinates (1, 5) correct but forgetting that reflecting in the x-axis turns a minimum into a maximum gives a false "minimum turning point" statement. Getting the reflection's effect on the turning-point type right (a maximum) but translating the x-coordinate in the wrong direction, using 3 + 2 = 5 instead of 3 − 2 = 1, gives a false statement at (5, 5).
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (d) (4, 8) — The other endpoint is found from 2 × midpoint − known endpoint: x = 2 × (−1) − (−6) = −2 + 6 = 4, y = 2 × 5 − 2 = 10 − 2 = 8, giving (4, 8). (−3.5, 3.5) comes from averaging the given endpoint and the midpoint as if they were the two endpoints of a segment, instead of working backwards from the midpoint. (5, 3) comes from working out (−1 − (−6), 5 − 2) instead of doubling the midpoint before subtracting. (4, 5) comes from correctly finding the x-coordinate but copying the midpoint's y-coordinate of 5 instead of doubling it.
- (c) 5(x + y − 1) — Method: take out the highest common factor of all three terms and divide every term by it, the number term included. Working: the highest common factor of 5x, 5y and −5 is 5; dividing gives 5x ÷ 5 = x, 5y ÷ 5 = y and −5 ÷ 5 = −1, so the bracket holds x + y − 1. Answer: 5(x + y − 1), which multiplies back out to 5x + 5y − 5. The distractors: 5(x + y + 1) comes from dividing −5 by 5 and losing the minus sign; 5(x + y − 5) comes from dividing only the terms containing a letter by 5 and carrying the −5 into the bracket unchanged; 5(xy − 1) comes from collecting the unlike terms 5x and 5y as 5xy before factorising.
- (a) 3 — y = f(x + 2) is f(x) translated 2 units to the LEFT (inside the bracket, adding moves the graph in the negative x-direction). The root moves with the whole graph: 5 − 2 = 3. Moving right instead of left gives 7; assuming a bracket shift leaves the root unchanged gives 5; writing down the shift amount 2 itself skips the translation altogether.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (d) The cost increases by about £10 per extra item — Gradient = change in cost ÷ change in items = (800 − 400) ÷ (70 − 30) = 400 ÷ 40 = 10. The units of the gradient are £ per item, so the cost is increasing by about £10 for every extra item produced, near x = 50. Subtracting in the wrong order, (400 − 800) ÷ (70 − 30) = −10, gives the right size but the wrong sign — check which point comes first each time. Leaving out the division by 40 gives £400 per item; dividing the wrong way round, 40 ÷ 400 = 0.1, gives £0.10 per item.
- (c) {x : x ≤ −4} ∪ {x : x ≥ 4} — Rearrange so one side is zero: x² − 16 ≥ 0, then factorise: (x − 4)(x + 4) ≥ 0. The critical values are x = −4 and x = 4. Since the coefficient of x² is positive, the graph is a U-shape that is on or above the x-axis outside its roots, so the solution is x ≤ −4 or x ≥ 4, written as {x : x ≤ −4} ∪ {x : x ≥ 4}. Distractor routes: {x : −4 ≤ x ≤ 4} takes the region BETWEEN the roots, which is where x² − 16 is negative, the opposite region. {x : x ≥ 4} keeps only the positive square root and drops the negative branch entirely. {x : x ≤ 4} comes from a sign error, treating the inequality as if it were x² ≤ 16.
- (b) 319 — Substitute n = 10: 3 × 10² + 2 × 10 − 1 = 3 × 100 + 20 − 1 = 300 + 20 − 1 = 319. A sign error on the +2n term, treating it as −2n, gives 300 − 20 − 1 = 279. Working out 3 × 10² + 2 × 10 but forgetting to subtract the final 1 gives 300 + 20 = 320. Using n = 9 instead of n = 10 gives 3 × 81 + 18 − 1 = 243 + 18 − 1 = 260.
- (b) 2x + 3 — fg(x) means f(g(x)): apply g first, then apply f to the result. g(x) = 2x, so f(g(x)) = f(2x) = 2x + 3. Writing 2x + 6 comes from working out gf(x) instead — g(f(x)) = g(x + 3) = 2(x + 3) = 2x + 6 — which applies the functions in the wrong order. Writing 3x + 3 comes from adding f(x) and g(x) together, (x + 3) + 2x = 3x + 3, instead of composing them. Writing 2x² + 6x comes from multiplying f(x) and g(x) together, (x + 3)(2x) = 2x² + 6x, instead of substituting one into the other.
- (c) y = 3x + 1 — Method: a line of known gradient m has equation y = mx + c, and c is found by substituting the coordinates of a point known to lie on it. Working: the gradient is 3, so the line is y = 3x + c; substituting x = 1 and y = 4 gives 4 = 3 × 1 + c, so c = 4 − 3 = 1. Answer: y = 3x + 1. The distractors: y = 3x − 1 comes from working out the constant as mx − y, 3 − 4 = −1, instead of y − mx; y = x + 3 comes from swapping the two numbers over, putting the gradient 3 in the constant position and the x-coordinate 1 in front of x; y = 3x + 4 comes from using the y-coordinate 4 as the constant without substituting.
- (a) It is 2(w + (w + 3)) = 4w + 6, not 2w + 3. — The perimeter of a rectangle is twice the width plus twice the length: 2 × w + 2 × (w + 3) = 2w + 2w + 6 = 4w + 6, so the gardener's 2w + 3 is wrong. Writing w + (w + 3) = 2w + 3 forgets to double the sides at all, only adding one width and one length once. Writing 4(w + 3) = 4w + 12 wrongly treats all four sides as equal to the length, as if the garden were a square. Writing 3w + 6 comes from doubling the length correctly but adding the width only once instead of doubling it too.
- (c) t = 1 second and t = 5 seconds — The ball is at ground level when h = 0, which happens when either bracket is zero. t − 1 = 0 gives t = 1, and 5 − t = 0 gives t = 5. The option with t = −1 makes a sign error solving the first bracket. The option with t = −5 makes a sign error solving the second bracket, treating 5 − t = 0 as if it gave a negative solution. The option with t = 4 seconds is an arithmetic slip in solving 5 − t = 0.
Build your own mix at the worksheet builder.