Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) x = 0 — Expand (x + 4)² correctly: (x + 4)² = x² + 8x + 16. This equals x² + 16 only when 8x is zero, i.e. when x = 0 — at every other value of x the two expressions differ by 8x. Choosing x = 4 confuses the constant inside the bracket with the value of x that makes the expressions match. Choosing x = −4 makes the same confusion but with the sign flipped. Choosing x = 8 mistakes the coefficient of the middle term, 8x, for the value of x itself.
- (d) 168 m — Split the area under the graph into two parts. The rising section (0 to 8 s) is a triangle: area = 0.5 × 8 × 12 = 48. The constant section, from 8 s to 18 s (10 s), is a rectangle: area = 12 × 10 = 120. Total distance = 48 + 120 = 168 m. Leaving out the 0.5 doubles the triangle, giving 8 × 12 + 120 = 216 m; ignoring the triangle section altogether gives only 120 m; averaging the start and final speeds over the whole 18 seconds, (0 + 12) ÷ 2 = 6, then 6 × 18 = 108 m, wrongly treats the tram as accelerating the whole time, when the graph is flat for the last 10 seconds.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (b) 5 and −6 — Method: turn the sentence into an equation in one letter, collect every term on one side so it reads as a quadratic equal to zero, then factorise. Working: if the number is x then x² + x = 30, which rearranges to x² + x − 30 = 0; two numbers that multiply to −30 and add to 1 are 6 and −5, so (x + 6)(x − 5) = 0 and x = −6 or x = 5. Both values work: 5 + 25 = 30 and −6 + 36 = 30. Answer: 5 and −6. The distractors: 6 and −5 comes from reading the numbers inside the brackets as the solutions without changing their signs; 5 only comes from discarding the negative solution, although nothing in the question rules out a negative number; 5 and 6 comes from hunting for a factor pair of 30 instead of forming and solving the quadratic.
- (a) y = −2x − 1 — Method: the gradient is the change in y divided by the change in x with both differences taken in the same order, and the constant then comes from substituting either point into y = mx + c. Working: m = (−9 − 3) ÷ (4 − (−2)) = (−12) ÷ 6 = −2, so the line is y = −2x + c; substituting (−2, 3) gives 3 = −2 × (−2) + c = 4 + c, so c = 3 − 4 = −1. Answer: y = −2x − 1. The distractors: y = −2x + 1 comes from rearranging 3 = 4 + c the wrong way round and taking the constant as 4 − 3; y = 2x + 7 comes from losing the minus sign when −12 is divided by 6 and then substituting correctly, 3 = 2 × (−2) + c; y = −(1/2)x + 2 comes from writing the gradient upside down as the change in x over the change in y, 6 ÷ (−12).
- (b) x = −3, y = −7 — x² + 6x + 2 = (x + 3)² − 3² + 2 = (x + 3)² − 7. Substituting x = −3: (−3)² = 9, 6 × (−3) = −18, so 9 − 18 + 2 = −7, confirming the minimum value −7 at x = −3: turning point (−3, −7). Using 6 instead of half of 6 inside the bracket gives (x + 6)² − 34, turning point (−6, −34) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (3, −7) — wrong, because (x + 3)² is zero at x = −3, not x = 3. Computing 9 − 2 = 7 instead of 2 − 9 = −7 flips the sign of the constant, giving (−3, 7) — wrong, since the completed square's constant must be evaluated as 2 minus 9, not 9 minus 2. Always check a turning point by substituting its x-value back into the original equation.
- (d) 6n + 3 — Method: find the price per passenger, then find the booking fee that fits a booking for 1 passenger. Working: the cost rises by £6 for each extra passenger (15 − 9 = 6, 21 − 15 = 6, 27 − 21 = 6), so the cost has the form 6n + c. Substituting n = 1: 6(1) + c = 9, so c = 3. Answer: the cost in pounds is 6n + 3. 6n ignores the booking fee altogether. 6n + 9 uses the cost of one passenger, £9, as the fee without first subtracting the £6 per-passenger price. 9n + 6 swaps the two numbers, using the first cost as the price per passenger and the difference as the fee.
- (c) Translate +1 in y; new range 0 ≤ y ≤ 2 — Adding 1 to sin x translates the graph 1 unit in the positive y-direction, and every y-value on the range increases by 1: −1 + 1 = 0 and 1 + 1 = 2, giving a new range of 0 ≤ y ≤ 2. A translation in the x-direction would not add anything to the y-values, so 'Translate +1 in x; range unchanged' correctly leaves the range at −1 ≤ y ≤ 1 for that (wrong) transformation, but the transformation itself is not what y = sin x + 1 shows. 'Translate +1 in y; new range −2 ≤ y ≤ 0' correctly spots the translation but subtracts 1 from each bound instead of adding it. 'Reflect in the x-axis' mistakes the transformation for a reflection rather than a translation; reflecting sin x in the x-axis does leave the range at −1 ≤ y ≤ 1 unchanged in size, but that is not the transformation y = sin x + 1 actually applies.
- (a) It gets closer to zero but never actually reaches it. — y = 60 × (0.5)ˣ is always positive, however large x is, because a positive number raised to any power stays positive. As x increases, (0.5)ˣ gets smaller and smaller but never equals zero, so y approaches zero without ever reaching it. Believing the curve reaches zero when x = 60, because 60 is the starting value, mixes up the y-intercept with a stopping point — an exponential decay curve like this one never actually reaches the x-axis, so this is wrong. Believing the curve goes negative for large x is wrong because multiplying a positive number by (0.5) any number of times can never produce a negative result. Believing the curve levels off at y = 0.5, confusing the base of the exponential with its eventual level, is wrong: the base only controls how fast the curve falls, not where it settles — this curve settles at y = 0, not y = 0.5. Whenever you sketch an exponential decay curve, draw it approaching the x-axis but never touching it.
- (c) 7 — To reverse the rule, subtract the constant then divide by the coefficient: 30−2=28, then 28÷4=7, so n=7. A candidate who adds the constant instead of subtracting it, a sign error when rearranging, would compute (30+2)÷4=32÷4=8. A candidate who subtracts the constant correctly but then forgets to divide by the coefficient would stop at 30−2=28. A candidate who treats 4n+2 as a single term 6n, adding the coefficient and constant together, would compute 30÷6=5.
- (a) 9 — Method: the gaps in this sequence are not constant, so work out each of the two terms named from the rule and then subtract the earlier from the later. Working: the 5th term is 5² + 1 = 25 + 1 = 26 and the 4th term is 4² + 1 = 16 + 1 = 17, so the difference is 26 − 17. Answer: 9. The distractors: 7 comes from using the 3rd and 4th terms, one position too early, 17 − 10; 11 comes from using the 5th and 6th terms, one position too late, 37 − 26; 1 comes from subtracting the position numbers, 5 − 4, instead of the terms themselves.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (b) £115, and C = 40 + 25h is a formula — Substitute h = 3 into the rule, multiplying before adding. The hours cost 25 × 3 = 75, and adding the call-out fee gives 40 + 75 = 115, so the charge is £115. The rule itself links two different quantities, C and h, and lets one be worked out from the other, so it is a formula; an expression would have no equals sign in it. Adding the fee before multiplying gives 65 × 3 = 195, which charges the call-out fee three times over, and stopping at 40 + 25 leaves £65, the charge for a single hour.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (d) 12√2 — The nth term of a geometric sequence is a × rⁿ⁻¹. Here a = 3, r = √2, n = 6, so the 6th term is 3 × (√2)⁵. Since (√2)² = 2, (√2)⁴ = (2)² = 4, so (√2)⁵ = (√2)⁴ × √2 = 4√2. The 6th term is 3 × 4√2 = 12√2. 15√2 comes from treating (√2)⁵ as 5√2 — multiplying the index by the surd instead of raising √2 to that power — then multiplying by 3 gives 3 × 5√2 = 15√2, which is wrong because powers of a surd do not scale linearly with the index. 24√2 comes from miscalculating (√2)⁴ as 8 instead of 4 (a squaring slip, since (√2)² = 2 but (√2)⁴ should be 2² = 4, not 2 × 4), giving 3 × 8√2 = 24√2. 4√2 comes from forgetting to multiply by the first term a = 3, leaving just (√2)⁵ = 4√2.
Build your own mix at the worksheet builder.