Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) $y = x^2 + 3$ — Method: a point lies on a curve only if substituting its x-coordinate into the equation gives back its y-coordinate, so read one or two points off curve B and test each equation. Working: curve B crosses the y-axis at (0, 3), and its lowest point is also (0, 3); substituting x = 0 into y = x² + 3 gives 0² + 3 = 3, which matches. Checking a second point: at x = 2 curve B is at y = 7, and 2² + 3 = 4 + 3 = 7, which matches as well. Answer: curve B has equation y = x² + 3. Distractor refutation: y = x² − 3 comes from reading the 3 as a move down instead of a move up; substituting x = 0 gives −3, so that curve would cross the y-axis three squares below the origin, while curve B crosses it three squares above. y = (x − 3)² comes from putting the 3 inside the brackets; substituting x = 0 gives (−3)² = 9, and that curve's lowest point is at (3, 0), three squares to the right along the x-axis, whereas curve B has its lowest point on the y-axis. y = x² + 3x comes from attaching the 3 to the x term instead of writing it on its own; substituting x = 0 gives 0² + 3 × 0 = 0, so that curve passes through the origin, and curve B does not pass through the origin.
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
- (d) 7n − 2 — Method: find how much the total cost rises each month, then find the constant that fits the cost for one month. Working: the cost rises by £7 for each extra month (12 − 5 = 7, 19 − 12 = 7, 26 − 19 = 7), so the cost has the form 7n + c. Substituting n = 1: 7(1) + c = 5, so c = −2. Answer: the total cost in pounds is 7n − 2. The value 7n comes from leaving out the constant. The value 7n + 5 comes from using the cost of one month as the constant directly, without subtracting the monthly rise first. The value 5n + 7 comes from swapping the roles of the cost of one month, £5, and the monthly rise, £7 — using the cost of one month as the coefficient of n and the rise as the constant.
- (d) 3x² + 4x − 7 — Method: the minus sign in front of the second bracket changes the sign of every term inside it; then collect like terms. Working: removing the brackets gives 5x² + 3x − 2 − 2x² + x − 5; the squared terms give 5x² − 2x² = 3x², the x terms give 3x + x = 4x, and the number terms give −2 − 5 = −7. Answer: 3x² + 4x − 7. The distractors: 7x² + 2x + 3 comes from adding the two brackets instead of subtracting, giving 5x² + 2x², 3x − x and −2 + 5; 3x² + 2x + 3 comes from applying the minus sign to 2x² only, leaving −x and +5 unchanged so that 3x − x = 2x and −2 + 5 = 3; 3x² + 4x + 3 comes from changing the signs of the terms with letters but leaving +5 as it stood, so the number terms give −2 + 5 = 3.
- (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.
- (a) 1 — a² − 2b = (−3)² − 2(4) = 9 − 8 = 1. A candidate who squares −3 but keeps the negative sign gets −9 − 8 = −17. A candidate who forgets to square a and substitutes it as −3 gets −3 − 8 = −11. A candidate who adds instead of subtracting 2b gets 9 + 8 = 17.
- (d) 3 — 2x² − 12x + 7 rewrites as 2(x² − 6x) + 7, then as 2[(x − 3)² − 9] + 7, which simplifies to 2(x − 3)² − 11, since −2 × 9 + 7 = −11. The bracket (x − 3)² is zero when x = 3, so the minimum occurs at x = 3. Treating the shift as b/a instead of b/(2a) — using 6 instead of 3 — gives x = 6, which is wrong. Reading the bracket's sign directly without negating it gives x = −3, wrong, because (x − 3)² is zero at x = 3, not x = −3. Reading off the coefficient of x itself, −12, and calling that the answer skips the completing-the-square process entirely and gives x = −12, which is wrong because b is not the turning point's x-coordinate under any circumstance. Always check: substituting your value of x should make the bracketed term equal to zero, and nothing else.
- (a) 8 — Method: rate = height gained ÷ time taken. Working: height gained = 52 − 20 = 32 m, time taken = 4 minutes, so rate = 32 ÷ 4 = 8 metres per minute. Answer: the rate is 8 metres per minute. 32 comes from working out the height gained but forgetting to divide by the time taken. 13 comes from dividing the final height, 52, by the time taken instead of the height gained. 5 comes from dividing the starting height, 20, by the time taken instead of the height gained.
- (a) 27 — Method: let the smaller number be n, so the larger number is n + 9. Form the equation n + (n + 9) = 45. Working: simplify: 2n + 9 = 45, so 2n = 36, giving n = 18. The larger number is 18 + 9 = 27. Answer: 27. 18 is the smaller number, found correctly, but given as the answer to the question asking for the larger number. 22.5 comes from ignoring the "9 more" part and simply halving the total, 45 ÷ 2. 36 comes from a sign error when isolating the constant, treating the equation as 2n = 45 + 9 instead of 2n = 45 − 9.
- (c) every value of x except x = −3 — Method: factorise the quadratic, then use the fact that a squared bracket is never negative to decide where the expression is strictly greater than zero. Working: x² + 6x + 9 factorises as (x + 3)², and a square is greater than or equal to 0 for every value of x; (x + 3)² is equal to 0 only when x + 3 = 0, that is when x = −3, so it is strictly greater than 0 at every other value. Answer: every value of x except x = −3. The distractors: 'every value of x, with no exceptions' comes from remembering that a square cannot be negative but forgetting that it can be zero, which a strict > rules out; 'x > −3 only' comes from taking the square root of both sides to get x + 3 > 0 and keeping only that branch; 'x < −3 only' comes from the same square-rooting followed by turning the sign round, as though the step had been a division by a negative number.
- (a) 120 m — The gradient of the second line is (0 − V)/(9 − 6) = −V/3, and this equals −8, so V = 24. The distance from t = 0 to t = 6 is the area of a trapezium with parallel sides 4 and 24 and width 6: 1/2 × (4 + 24) × 6 = 84. The distance from t = 6 to t = 9 is the area of a triangle with base 3 and height 24: 1/2 × 3 × 24 = 36. The total distance is 84 + 36 = 120 m. Using V = 8, treating the gradient's number as the missing velocity itself rather than solving −V/3 = −8 for V, gives a trapezium area of 1/2 × (4 + 8) × 6 = 36 and a triangle area of 1/2 × 3 × 8 = 12, a total of 48 m. Leaving out the 1/2 in the trapezium formula, (4 + 24) × 6 = 168, plus the correct triangle of 36, gives 204 m. Using the full 6 seconds as the triangle's base instead of the 3 seconds the second line actually lasts, 1/2 × 6 × 24 = 72, plus the correct trapezium of 84, gives 156 m.
- (a) 3x = 12 — Adding the two equations: the y-terms, +y and −y, have opposite signs, so they cancel; the x-terms combine to 2x + x = 3x; and the right-hand sides add to 11 + 1 = 12. This gives 3x = 12. A candidate who forgets that the y-terms cancel, and instead adds them as if they had the same sign, would write 3x + 2y = 12. A candidate who subtracts the right-hand sides instead of adding them would get 3x = 10. A candidate who correctly reaches 3x = 12 but then treats 12 itself as the value of x, skipping the final division, would write x = 12.
- (d) −11/60 — The radius from the origin to (11, 60) has gradient 60/11. The tangent is perpendicular to this radius, so its gradient is the negative reciprocal: −1 ÷ (60/11) = −11/60. Choosing 60/11 uses the radius's gradient unchanged, without applying perpendicularity. Choosing −60/11 negates the radius's gradient but forgets to take its reciprocal. Choosing 11/60 takes the reciprocal correctly but keeps the gradient positive instead of negative.
Build your own mix at the worksheet builder.