Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (c) 2(x + 4) ≡ 2x + 8 — 2(x + 4) ≡ 2x + 8 is an identity because expanding the bracket on the left gives exactly the right-hand side for every value of x — try any number and both sides match. 2(x + 4) = 20 is an equation: expanding gives 2x + 8 = 20, which is only true for the single value x = 6. 2(x + 4) = 2x + 4 is not true for any value of x at all: expanding the left side gives 2x + 8, which can never equal 2x + 4 since 8 ≠ 4. x + 4 = 2x is also an equation, true only for the single value x = 4. The identity is 2(x + 4) ≡ 2x + 8.
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (b) a = 7; turning point (4, 2) — A vertical translation y = f(x) + a moves every point on the graph up or down by a, so the x-coordinate of the turning point stays at 4 and the minimum value becomes −5 + a. Setting −5 + a = 2 and solving gives a = 7, so the new turning point is (4, 2). Rearranging −5 + a = 2 with a sign error, treating it as a = −5 − 2, gives a = −7 while still landing on the correct turning-point coordinates. Correctly finding a = 7 but then writing down the original turning point instead of the shifted one gives (4, −5). Assuming a is simply equal to the new minimum value itself, ignoring the original −5 entirely, gives a = 2.
- (d) (4, 8) — The other endpoint is found from 2 × midpoint − known endpoint: x = 2 × (−1) − (−6) = −2 + 6 = 4, y = 2 × 5 − 2 = 10 − 2 = 8, giving (4, 8). (−3.5, 3.5) comes from averaging the given endpoint and the midpoint as if they were the two endpoints of a segment, instead of working backwards from the midpoint. (5, 3) comes from working out (−1 − (−6), 5 − 2) instead of doubling the midpoint before subtracting. (4, 5) comes from correctly finding the x-coordinate but copying the midpoint's y-coordinate of 5 instead of doubling it.
- (b) 2x + 3 — fg(x) means f(g(x)): apply g first, then apply f to the result. g(x) = 2x, so f(g(x)) = f(2x) = 2x + 3. Writing 2x + 6 comes from working out gf(x) instead — g(f(x)) = g(x + 3) = 2(x + 3) = 2x + 6 — which applies the functions in the wrong order. Writing 3x + 3 comes from adding f(x) and g(x) together, (x + 3) + 2x = 3x + 3, instead of composing them. Writing 2x² + 6x comes from multiplying f(x) and g(x) together, (x + 3)(2x) = 2x² + 6x, instead of substituting one into the other.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (b) y = 2x² + 14x + 19 — A translation by the vector (−2, 0) moves the graph 2 units in the negative x-direction, which means replacing x with (x + 2): 2(x + 2)² + 6(x + 2) − 1. Expanding 2(x + 2)² gives 2x² + 8x + 8, and 6(x + 2) gives 6x + 12; collecting terms 2x² + 8x + 8 + 6x + 12 − 1 simplifies to 2x² + 14x + 19. Substituting (x − 2) instead of (x + 2) — translating in the wrong direction — gives 2(x−2)² + 6(x−2) − 1, which simplifies to 2x² − 2x − 5. Distributing the outer 2 only onto the x² term of the expansion, instead of onto every term of (x + 2)², gives 2x² + 10x + 15. Dropping the −1 when collecting the constant terms, treating 8 + 12 as 20 rather than 8 + 12 − 1 as 19, gives 2x² + 14x + 20.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (c) x = 0, y = 3 and x = 3, y = 0 — Substitute y = 3 − x into x² + y² = 9: x² + (3 − x)² = 9. Expanding (3 − x)² = 9 − 6x + x² gives x² + 9 − 6x + x² = 9, which simplifies to 2x² − 6x = 0, or 2x(x − 3) = 0, so x = 0 or x = 3. Using y = 3 − x: x = 0 gives y = 3; x = 3 gives y = 0. Distractor routes: x = 0, y = 3 alone stops after the factor 2x = 0 and never checks the second factor, x − 3 = 0. x = 0, y = 3 and x = −3, y = 6 comes from factorising 2x² − 6x as 2x(x + 3), a sign error that gives a second root of −3 instead of 3. x = 0, y = 3 and x = 6, y = −3 comes from expanding (3 − x)² as 9 − 6x, dropping the x² term, which changes the quadratic to x² − 6x = 0 and its second root to 6.
- (a) y = 2ˣ — An exponential graph y = 2ˣ passes through (0, 1) since 2⁰ = 1, rises more and more steeply for positive x, and has the x-axis as an asymptote as x becomes very negative, since 2ˣ gets closer to 0 without ever reaching it. y = x² + 1 also passes through (0, 1) and also rises steeply for positive x, but as x becomes very negative it rises to infinity too, rather than settling towards the x-axis — mistaking any curve that gets steeper for an exponential misses this. y = x³ + 1 passes through (0, 1) and rises for positive x, but as x becomes very negative it falls towards negative infinity rather than approaching the x-axis from above. y = 1 − x² also passes through (0, 1), but it falls for large positive x rather than rising — a candidate who checks only the y-intercept, without reading the described shape of the curve, could pick this.
- (d) 8 — Working backwards by halving (undoing the doubling), one 4-hour step at a time: 9,600 (20 h) → 4,800 (16 h) → 2,400 (12 h) → 1,200 (8 h) → 600 (4 h) → 300 (0 h). Reading these in time order — 300, 600, 1,200, 2,400, 4,800, 9,600 at 0, 4, 8, 12, 16, 20 hours — the population is still at or below 1,000 at 4 hours (600) and first goes above 1,000 at 8 hours (1,200). So the recorded population first exceeds 1,000 at 8 hours. Answering 20 just reads off the time stated in the question, without working out when the threshold was actually first crossed — wrong, because 9,600 is only the value AT 20 hours, not necessarily the first time the population passed 1,000. Answering 0 comes from recovering the starting population by dividing 9,600 by 5 (the number of 4-hour gaps up to 20 hours) instead of by 2⁵ = 32 (the correct number of halvings), giving a wrongly-inflated starting value of 9,600 ÷ 5 = 1,920 — already above 1,000 at 0 hours — wrong, because doubling means the value must be halved five times, dividing by 2 five times (2⁵ = 32), not divided once by the number of gaps. Answering 12 comes from halving back only twice, from 9,600 to 4,800 (16 h) to 2,400 (12 h), and stopping there because 2,400 is already above 1,000, without checking that 1,200 at 8 hours is also above 1,000 and occurs earlier — wrong, because the FIRST recorded time above 1,000 is the earliest such time, not the first one reached while working backwards from 20 hours.
- (b) 143 — fg(4) means f(g(4)): work out g(4) first, then substitute the result into f. g(4) = 3 × 4 = 12, then f(12) = 12² − 1 = 144 − 1 = 143. Working out gf(4) instead swaps the order: f(4) = 4² − 1 = 15, then g(15) = 3 × 15 = 45 — that is the wrong composition. Treating f(x) as x − 1 (forgetting to square the input) gives f(12) = 12 − 1 = 11. Applying g twice instead of applying g then f gives g(g(4)) = g(12) = 3 × 12 = 36, which mixes up which function should be applied second.
- (a) 130 — Method: substitute the total bill into the formula, then subtract the fixed charge and divide by the cost per text message. Working: 24.50 = 18 + 0.05t, so 0.05t = 24.50 − 18 = 6.50, t = 6.50 ÷ 0.05 = 130. Answer: 130 extra text messages. 490 comes from dividing the whole bill by 0.05 without first subtracting the £18 fixed charge: 24.50 ÷ 0.05 = 490. 13 comes from dividing the £6.50 by 0.5 instead of 0.05, moving the decimal point one place too far: 6.50 ÷ 0.5 = 13. 65 comes from dividing the £6.50 by 0.1 instead of 0.05.
Build your own mix at the worksheet builder.