Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) x = 2, y = 3 — Method: no letter cancels straight away, so make one letter the subject of one equation and substitute that expression into the other. Working: 2x + y = 7 gives y = 7 − 2x, so x + 2y = 8 becomes x + 2(7 − 2x) = 8, that is x + 14 − 4x = 8, so −3x = −6 and x = 2; substituting back gives y = 7 − 4 = 3. Answer: x = 2, y = 3, which checks in 2 + 6 = 8. The distractors: x = 3, y = 2 comes from adding the equations to x + y = 5 and then subtracting them the wrong way round, writing x − y = 1 instead of x − y = −1; x = 2, y = 5 comes from substituting x = 2 into 2x + y = 7 as 2 + y = 7, dropping the coefficient; x = −2, y = 11 comes from dividing −3x = −6 as though two minus signs gave a negative answer.
- (b) 3 — Method: a term is any part of an expression separated from the rest by a + or − sign, including a number on its own. Working: 8 − 3x + 5x² splits at the + and − signs into 8, −3x and 5x² — that is three separate terms. Answer: 3. Ryan's answer of 2 comes from wrongly excluding the number 8, thinking a term must contain a letter. 5 comes from miscounting by treating the coefficients and powers as separate terms as well as the letters. 1 comes from treating the whole expression as a single term because it is written without brackets.
- (b) y ≥ 2, y ≤ x, x ≤ 6 — "On or above the line y = 2" means y ≥ 2. "On or below the line y = x" means y ≤ x. "On or to the left of the line x = 6" means x ≤ 6. Together these give y ≥ 2, y ≤ x, x ≤ 6. Distractor routes: y ≤ 2, y ≤ x, x ≤ 6 flips the first inequality, describing "on or below" y = 2 instead of "on or above". y ≥ 2, y ≥ x, x ≤ 6 flips the second, describing "on or above" y = x instead of "on or below". y ≥ 2, y ≤ x, x ≥ 6 flips the third, describing "on or to the right of" x = 6 instead of "on or to the left".
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (a) 3x = 12 — Adding the two equations: the y-terms, +y and −y, have opposite signs, so they cancel; the x-terms combine to 2x + x = 3x; and the right-hand sides add to 11 + 1 = 12. This gives 3x = 12. A candidate who forgets that the y-terms cancel, and instead adds them as if they had the same sign, would write 3x + 2y = 12. A candidate who subtracts the right-hand sides instead of adding them would get 3x = 10. A candidate who correctly reaches 3x = 12 but then treats 12 itself as the value of x, skipping the final division, would write x = 12.
- (d) 8 — Working backwards by halving (undoing the doubling), one 4-hour step at a time: 9,600 (20 h) → 4,800 (16 h) → 2,400 (12 h) → 1,200 (8 h) → 600 (4 h) → 300 (0 h). Reading these in time order — 300, 600, 1,200, 2,400, 4,800, 9,600 at 0, 4, 8, 12, 16, 20 hours — the population is still at or below 1,000 at 4 hours (600) and first goes above 1,000 at 8 hours (1,200). So the recorded population first exceeds 1,000 at 8 hours. Answering 20 just reads off the time stated in the question, without working out when the threshold was actually first crossed — wrong, because 9,600 is only the value AT 20 hours, not necessarily the first time the population passed 1,000. Answering 0 comes from recovering the starting population by dividing 9,600 by 5 (the number of 4-hour gaps up to 20 hours) instead of by 2⁵ = 32 (the correct number of halvings), giving a wrongly-inflated starting value of 9,600 ÷ 5 = 1,920 — already above 1,000 at 0 hours — wrong, because doubling means the value must be halved five times, dividing by 2 five times (2⁵ = 32), not divided once by the number of gaps. Answering 12 comes from halving back only twice, from 9,600 to 4,800 (16 h) to 2,400 (12 h), and stopping there because 2,400 is already above 1,000, without checking that 1,200 at 8 hours is also above 1,000 and occurs earlier — wrong, because the FIRST recorded time above 1,000 is the earliest such time, not the first one reached while working backwards from 20 hours.
- (d) 6 — Method: rearrange the formula to make d the subject, then substitute C = 133. Working: C = 25 + 18d, so subtracting 25 from both sides gives C − 25 = 18d, then dividing by 18 gives d = (C − 25) / 18. Substituting C = 133: d = (133 − 25) / 18 = 108 / 18 = 6. The value 7.4 comes from dividing 133 by 18 without subtracting the fixed £25 first (133 / 18 ≈ 7.4). The value 4.6 comes from pairing the numbers the wrong way round, working out (133 − 18) / 25 = 4.6. The value 90 comes from subtracting both 25 and 18 from 133 instead of dividing by 18.
- (c) 2 < x < 3 — Factorise x² − 5x + 6 = (x − 2)(x − 3), giving roots x = 2 and x = 3. Since the coefficient of x² is positive, the graph is a U-shape that dips below the x-axis between its roots. So x² − 5x + 6 < 0 for 2 < x < 3. Distractor routes: x < 2 or x > 3 takes the region OUTSIDE the roots, where the graph is above the x-axis, the opposite of what is wanted. 2 ≤ x ≤ 3 uses ≤ instead of the strict < the question asks for, wrongly including the roots themselves, where the expression equals zero, not less than zero. −3 < x < −2 comes from factorising as (x + 2)(x + 3), reversing the sign of both roots.
- (c) x ≥ 3 — Method: collect the number terms first; the x term is negative, so the final step multiplies both sides by −1, and that is the one step that turns the inequality sign round. Working: subtracting 5 from both sides of 5 − x ≤ 2 gives −x ≤ −3; multiplying both sides by −1 turns −x into x and −3 into 3, and because the multiplier is negative the ≤ becomes ≥, so x ≥ 3. Answer: x ≥ 3. The distractors: x ≤ 3 comes from multiplying by −1 without turning the sign round, the commonest slip on this type; x ≤ −3 comes from reading −x ≤ −3 as though the minus sign could simply be rubbed off the left-hand side; x ≥ −3 comes from turning the sign round correctly but leaving the right-hand side at −3 instead of multiplying it by −1 as well.
- (d) 2.7 — The height after 3 years of 10% compound growth is 2 × 1.1³ = 2.662 m, which rounds to 2.7 m. A candidate who adds 10% of the original height (0.2 m) in each of the 3 years, instead of compounding on the new height each time, would reach 2 + 3×0.2 = 2.6 m. A candidate who compounds for only 2 years would reach 2 × 1.1² = 2.42 m, rounding to 2.4 m. A candidate who compounds for 4 years instead of 3 would reach 2 × 1.1⁴ = 2.928 m, rounding to 2.9 m.
- (d) g is one-to-one: f(3) = f(−3), removed by x ≥ 0 — A function has an inverse only if it is one-to-one: every output must come from exactly one input. f(3) = 9 and f(−3) = 9, so two different inputs give the same output, and there is no way to send 9 back to a single input — f is not one-to-one over all real x. Restricting the domain to x ≥ 0 removes one of the two inputs behind every such pair, so g is one-to-one and does have an inverse. 'g's outputs are positive; f's could be negative' is wrong because f(x) = x² also only gives outputs of 0 or more — the outputs of f and g are identical sets; it is the INPUTS that differ, not the outputs. 'Restricting any domain always creates an inverse' is wrong because a restriction only helps if it actually removes the repeated outputs: restricting f(x) = x² to x ≥ −3 still leaves f(1) = f(−1) = 1, so that restricted function is still not one-to-one and still has no inverse. 'Squares can never be reversed, under any conditions' is wrong because √9 = 3 does reverse 3² = 9 once you know the input was non-negative — a square root just cannot tell you WHICH of two inputs you started from unless the domain has already ruled one of them out.
- (d) 6.0 — Subtract 1.8 from both sides: 6.3x ≤ 38.2. Divide both sides by 6.3: x ≤ 6.0634… . The question asks for the greatest value to 1 decimal place that still satisfies the inequality. Testing 6.1: 6.3 × 6.1 + 1.8 = 40.23, which is more than 40, so 6.1 fails. Testing 6.0: 6.3 × 6.0 + 1.8 = 39.6, which is no more than 40, so 6.0 works and is the greatest such value. A candidate who simply rounds 6.0634… to 1 decimal place answers 6.1, without checking that it satisfies the inequality. A candidate who adds 1.8 instead of subtracting works out 41.8 ÷ 6.3 and answers 6.6. A candidate who forgets the 1.8 altogether divides 40 by 6.3 and answers 6.3.
- (d) 44 m — The trapezium rule between t = 2 and t = 5 uses only the speeds at t = 2, 3, 4 and 5 — 12, 15, 16 and 14 — with three strips of width 1: adding the first and last readings and twice the sum of the middle readings gives 12 + 14 + 2 × (15 + 16) = 88, and half of that is 44 m. Writing 68.5 m comes from applying the trapezium rule to the whole table, from t = 0 to t = 6, instead of restricting it to the interval t = 2 to t = 5 that the question asks for. Writing 28.5 m comes from forgetting to double the two middle readings, 15 and 16, in the trapezium rule formula. Writing 39 m comes from averaging only the first and last speeds in the interval, 12 and 14, and multiplying by the 3-second interval, ignoring the readings at t = 3 and t = 4 in between.
- (a) 55 − 5n — The number of chairs decreases by 5 in each row after the first, so the common difference is d=−5, and the first term is a=50. The nth term is a+(n−1)d = 50+(n−1)(−5) = 50−5n+5 = 55−5n. A candidate who uses the common difference as the constant term instead of correctly finding 55, giving the constant as −5 instead, would write −5n−5. A candidate who uses the first term, 50, as the coefficient of n instead of the common difference, would write 50n−5. A candidate who does not multiply the common difference by n at all, treating the nth term as n+d instead of dn+c, would write n−5.
- (d) 6 — Method: collect the x-terms on one side and the constants on the other, then divide by the remaining coefficient of x. Working: 6x − 3x = 13 + 5, so 3x = 18, x = 18 ÷ 3 = 6. Answer: x = 6. 2.67 comes from a sign error when moving the 5, subtracting instead of adding: 3x = 13 − 5 = 8, x = 8 ÷ 3 ≈ 2.67. 2 comes from a sign error when moving the x-term, adding instead of subtracting: 9x = 18, x = 2. 18 comes from correctly finding 3x = 18 but forgetting to divide by 3.
Build your own mix at the worksheet builder.