Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (c) x = 2, y = 3 — Method: no letter cancels straight away, so make one letter the subject of one equation and substitute that expression into the other. Working: 2x + y = 7 gives y = 7 − 2x, so x + 2y = 8 becomes x + 2(7 − 2x) = 8, that is x + 14 − 4x = 8, so −3x = −6 and x = 2; substituting back gives y = 7 − 4 = 3. Answer: x = 2, y = 3, which checks in 2 + 6 = 8. The distractors: x = 3, y = 2 comes from adding the equations to x + y = 5 and then subtracting them the wrong way round, writing x − y = 1 instead of x − y = −1; x = 2, y = 5 comes from substituting x = 2 into 2x + y = 7 as 2 + y = 7, dropping the coefficient; x = −2, y = 11 comes from dividing −3x = −6 as though two minus signs gave a negative answer.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (b) £47, and T=15+8h is a formula (relates T and h). — The charge is £15 fixed plus £8 for each hour: T=15+8h, so for h=4, T=15+8×4=15+32=47. Because T=15+8h relates two different quantities, the total charge T and the number of hours h, it is a formula, not an equation — an equation is solved for one particular value of an unknown, but this relationship holds for every value of h a job might last. A candidate who forgets to include the fixed £15 fee would compute only 8×4=32. A candidate who adds the three numbers in the formula together instead of multiplying the hourly rate by the number of hours would compute 15+8+4=27. A candidate who correctly finds the charge but mistakes the formula for an equation, treating it as something to be solved for one specific value of h rather than a general relationship between T and h, would pick the correct charge with the wrong classification.
- (b) 10 — Check n = 9: a₉ = 3 × 2⁸ = 3 × 256 = 768, below 1,000. Check n = 10: a₁₀ = 3 × 2⁹ = 3 × 512 = 1,536, above 1,000. So the first term greater than 1,000 is at position n = 10. Answering 9 comes from forgetting the −1 shift and using the formula as 3 × 2ⁿ instead of 3 × 2ⁿ⁻¹: checking 3 × 2⁹ = 1,536 (which exceeds 1,000) but then reporting the position as n = 9, the exponent used, instead of n = 10 — wrong, because the exponent in the real formula is n − 1, not n. Answering 11 comes from going one term too far: correctly finding that a₁₀ already exceeds 1,000, but then checking one position further and reporting n = 11 instead of stopping at the first position that already works — wrong, because n = 11 is not the FIRST term greater than 1,000. Answering 1,536 gives the VALUE of the term (a₁₀ itself) rather than its position — wrong, because the question asks which term it is (the value of n), not what that term is worth.
- (c) A reflection in the y-axis — Replacing x with −x reflects the graph in the y-axis: each point (x, y) maps to (−x, y). Reflecting the OUTPUT instead, y = −f(x), gives a reflection in the x-axis — that is a different function. Combining both reflections gives a rotation of 180° about the origin, and reflecting in the line y = x swaps the x- and y-values, which is what produces the inverse function, not f(−x). Check first which side of f the minus sign sits on.
- (b) y = −3x/4 + 25 — Method: a straight line that touches a circle at one point is a tangent there, so it is perpendicular to the radius drawn to that point; find the gradient of the radius, take its negative reciprocal, then substitute the point of contact into y − y₁ = m(x − x₁). Working: the radius from (0, 0) to (12, 16) has gradient 16 ÷ 12, which cancels to 4/3, so the tangent has gradient −3/4. Substituting gives y − 16 = −3/4(x − 12), so y − 16 = −3x/4 + 9 and y = −3x/4 + 25. Answer: y = −3x/4 + 25. The distractors: y = 3x/4 + 7 turns the gradient of the radius upside down but leaves it positive, so the perpendicular step is only half done; y = −4x/3 + 32 changes the sign of the radius gradient without turning it upside down, which is the other half left undone; y = −3x/4 − 25 uses the correct gradient but substitutes the point of contact with both signs reversed, writing y + 16 = −3/4(x + 12).
- (a) Outside: OQ² = 221 > r² = 169 — OQ² = 10² + 11² = 100 + 121 = 221. Comparing this with r² = 169: since 221 > 169, OQ > r, so Q lies outside the circle — this is the correct verdict AND the correct working. 'Outside: OQ = 21 (10 + 11) > r = 13' reaches the same Outside verdict, but by invalid working: it adds the coordinates instead of squaring them (10 + 11 = 21, rather than 10² + 11² = 221), so the stated 'OQ' of 21 is not a distance at all — the verdict happens to match, but the method is wrong. 'Inside: OQ ≈ 14.87 < r² = 169' correctly finds the distance OQ = √221 ≈ 14.87, but then compares that DISTANCE with r² = 169 instead of with r = 13 — comparing two different kinds of quantity gives a meaningless, and here wrong, verdict. 'Inside: OQ² = 221 < (2r)² = 676' confuses the radius with the diameter: it compares OQ² with the diameter squared, (2 × 13)² = 676, instead of with r² = 169.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (d) The graph never crosses either axis — Since x ≠ 0, there is no point on the graph where x = 0, so it cannot cross the y-axis; likewise 1/x is never equal to 0 for any x, so it cannot cross the x-axis either — the graph never touches either axis. A candidate who forgets the restriction x ≠ 0 might think the graph behaves like other graphs and passes through the origin, (0, 0). A candidate who correctly rules out the x-axis but forgets that x = 0 is also excluded might say the graph crosses the y-axis but never the x-axis. A candidate who only pictures the branch where x and y are both positive might say the graph has only one branch, in quadrant 1, forgetting the second branch where x and y are both negative.
- (d) n/2 + 5 — Half of n is n ÷ 2, which is written as the fraction n/2. 'More than' means add, and the addition happens after the halving, so the expression is n/2 + 5. Writing (n + 5)/2 halves the 5 as well, because everything inside a bracket is divided; writing 2n + 5 doubles n instead of halving it; writing 5n/2 multiplies half of n by 5 instead of adding 5 to it.
- (c) −0.5 — fg(x) = f(g(x)) = f(x²) = x² + 2. gf(x) = g(f(x)) = g(x + 2) = (x + 2)² = x² + 4x + 4. Setting fg(x) = gf(x): x² + 2 = x² + 4x + 4. Subtract x² from both sides: 2 = 4x + 4. Subtract 4 from both sides: −2 = 4x, so x = −0.5. Writing 1.5 comes from adding the 4 instead of subtracting it: 4x = 2 + 4 = 6, giving x = 1.5. Writing 'no solution' comes from expanding (x + 2)² as x² + 4 using (a + b)² = a² + b², losing the middle term — the equation then reads x² + 2 = x² + 4, which has no solution, but the expansion itself is wrong. Writing 0 comes from treating gf(x) as g(x) + f(x) instead of g(f(x)): x² + (x + 2) = x² + 2 gives x = 0, but that adds the two functions rather than composing them.
- (d) 7n + 5 — Method: find the rate charged per extra chair, then find the fixed part of the cost that fits hiring 1 chair. Working: the cost rises by £7 for each extra chair (19 − 12 = 7, 26 − 19 = 7, 33 − 26 = 7), so the cost has the form 7n + c. Substituting n = 1: 7(1) + c = 12, so c = 5. Answer: the cost in pounds is 7n + 5. The value 7n comes from ignoring the fixed part of the charge entirely. The value 7n + 12 comes from using the cost of 1 chair as the fixed part directly, without subtracting the per-chair rate first. The value 12n + 7 comes from swapping the roles of the cost of hiring 1 chair, £12, and the rate per extra chair, £7 — using the total for one chair as the coefficient of n and the rate as the fixed part.
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
Build your own mix at the worksheet builder.