Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) −8 — −f(x) means take the output value from the table and change its sign, without changing which x-value is looked up. From the table, f(1) = 8, so −f(1) = −8. Reading f(1) = 8 from the table but forgetting to apply the negative sign gives 8. Misreading the row and using f(0) = 5 instead of f(1) = 8, then negating it, gives −5. Confusing −f(x) with f(x) − 1 — taking f(1) = 8 and subtracting 1 instead of negating — gives 7.
- (d) 12 m — Method: give the width a letter, write the length in terms of it and use length × width = area to form a quadratic. Working: with a width of x metres the length is x + 4, so x(x + 4) = 96, which rearranges to x² + 4x − 96 = 0; factorising gives (x + 12)(x − 8) = 0, and a width must be positive, so x = 8 and the length is 8 + 4 = 12. Answer: 12 m, and 12 × 8 = 96 as the area requires. The distractors: 8 m is the width rather than the length asked for; 16 m comes from taking the other root as 12 and adding 4 to it, ignoring that the root −12 cannot be a width; 24 m comes from dividing the area by the 4 in the question instead of forming an equation.
- (c) 8a + 2 — The perimeter of a rectangle is twice the length plus twice the width: P = 2(3a + 2) + 2(a − 1) = (6a + 4) + (2a − 2) = 8a + 2. Answering 5a adds the length and width once each but doubles only one of them, missing that a rectangle has two of each side. Answering 8a + 6 distributes the 2 into (a − 1) correctly as far as 2a, but then adds 2 instead of subtracting it, as though the bracket had been (a + 1). Answering 12a + 8 uses the length for all four sides instead of using the length twice and the width twice, as if the field were a square with side (3a + 2). The perimeter of the field is (8a + 2) metres.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (b) 1.50 — Substituting (0, 8) gives A = 8, since r⁰ = 1. Substituting (2, 18) gives 8 × r² = 18, so r² = 18 ÷ 8 = 2.25. Taking the square root of 2.25 gives r = 1.50 (2 d.p.). Stopping after finding r² and giving 2.25 as the final answer, without taking the square root, is wrong because r² is not the same as r. Dividing r² by the exponent 2 instead of taking its square root — treating the power as something you divide by rather than root — gives 2.25 ÷ 2 = 1.13 (2 d.p.), which is wrong. Inverting the ratio, working out 8 ÷ 18 instead of 18 ÷ 8, gives 0.44 (2 d.p.), which is wrong because the LATER value must be divided by the EARLIER one to find the growth multiplier, not the other way round.
- (b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (b) 2n + 3 — Method: multiply the cost per mile by the number of miles to get an expression, then add the fixed fee as a separate term. Working: n miles at £2 each is 2n; add the £3 fixed fee: 2n + 3. Answer: 2n + 3. 3n + 2 comes from swapping the fee and the rate round, treating £3 as the rate per mile and £2 as the fixed fee. 5n comes from adding the fee and the rate together first (3 + 2 = 5) and multiplying the result by n, instead of keeping the fixed fee as its own term. 2n − 3 comes from subtracting the fixed fee instead of adding it.
- (a) 2 — The common ratio is 54 ÷ 162 = 1/3, confirmed by 18 ÷ 54 = 1/3 and 6 ÷ 18 = 1/3. The next term is 6 × 1/3 = 2. A candidate who wrongly treats the sequence as arithmetic and subtracts the last difference (18 − 6 = 12) again gets 6 − 12 = −6. A candidate who multiplies by 3 instead of dividing, effectively reversing the sequence, gets 18. A candidate who guesses the ratio is 1/2 gets 6 × 1/2 = 3.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (b) (3, 3) and (−1, −5) — Set the two expressions for y equal: x² − 6 = 2x − 3, which rearranges to x² − 2x − 3 = 0. Factorise: (x − 3)(x + 1) = 0, so x = 3 or x = −1. Substitute into the linear equation, y = 2x − 3: x = 3 gives y = 3; x = −1 gives y = −5. The points are (3, 3) and (−1, −5). Distractor routes: (3, 3) and (1, −1) comes from mis-factorising x² − 2x − 3 as (x − 3)(x − 1), giving a second root of 1 instead of −1. (3, 9) and (−1, 1) comes from finding the y-coordinate from y = x² instead of substituting back into the given line equation y = 2x − 3. (3, 3) alone stops after finding only the first root of the quadratic.
- (b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (b) 20 — a²b means a² multiplied by b: a² = 2² = 4, and 4 × 5 = 20. Reading the expression as (ab)² instead of a²b gives (2 × 5)² = 100. Squaring b instead of a, 2 × 5² = 50, squares the wrong letter. Adding a² and b instead of multiplying them, 2² + 5 = 9, uses the wrong operation.
Build your own mix at the worksheet builder.