Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
- (b) 235 litres — The flow rate at t = 10 is the gradient of the tangent: change in volume ÷ change in time = (190 − 130) ÷ (12 − 8) = 60 ÷ 4 = 15 litres per minute. Treating this rate as roughly constant for a short interval, the volume 5 minutes after t = 10 is estimated as 160 + 5 × 15 = 235 litres. Using the tangent's own point spacing — 2 minutes, from t = 10 to t = 12 — instead of the 5 minutes actually asked for gives 160 + 2 × 15 = 190, which is just the volume already given at one of the tangent's own points, not an answer to the question asked. Multiplying the gradient by the time WITHOUT adding the starting volume, 5 × 15 = 75, forgets that a rate estimates a CHANGE, which must be added to the starting volume, not given as the answer on its own. Subtracting instead of adding, 160 − 5 × 15 = 85, extrapolates backward in time rather than forward.
- (c) 15 and 9 — Method: write the two facts as two equations in the same pair of letters and add them, because the letter with opposite signs cancels. Working: with x the larger number and y the smaller, x + y = 24 and x − y = 6; adding gives 2x = 30, so x = 15, and substituting into x + y = 24 gives y = 9. Answer: 15 and 9, which add to 24 and differ by 6. The distractors: 18 and 6 come from halving 24 to 12 and then adding and subtracting the whole difference of 6 instead of half of it, which leaves a difference of 12; 15 and 21 come from finding the larger number correctly and then adding 6 to it instead of subtracting; 15 and 6 come from finding the larger number and then taking the 6 in the question to be the smaller number itself.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (c) (x + 7)/4 — Method: dividing an expression by a number is written as a fraction, with the whole expression on top. Working: (x + 7) ÷ 4 = (x + 7)/4. Answer: (x + 7)/4. 4/(x + 7) comes from writing the numbers the wrong way round, putting 4 on top. 4(x + 7) comes from reading ÷ as ×, multiplying instead of dividing. (x + 7) − 4 comes from reading ÷ as −, subtracting instead of dividing.
- (b) 143 — fg(4) means f(g(4)): work out g(4) first, then substitute the result into f. g(4) = 3 × 4 = 12, then f(12) = 12² − 1 = 144 − 1 = 143. Working out gf(4) instead swaps the order: f(4) = 4² − 1 = 15, then g(15) = 3 × 15 = 45 — that is the wrong composition. Treating f(x) as x − 1 (forgetting to square the input) gives f(12) = 12 − 1 = 11. Applying g twice instead of applying g then f gives g(g(4)) = g(12) = 3 × 12 = 36, which mixes up which function should be applied second.
- (c) every value of x except x = −3 — Method: factorise the quadratic, then use the fact that a squared bracket is never negative to decide where the expression is strictly greater than zero. Working: x² + 6x + 9 factorises as (x + 3)², and a square is greater than or equal to 0 for every value of x; (x + 3)² is equal to 0 only when x + 3 = 0, that is when x = −3, so it is strictly greater than 0 at every other value. Answer: every value of x except x = −3. The distractors: 'every value of x, with no exceptions' comes from remembering that a square cannot be negative but forgetting that it can be zero, which a strict > rules out; 'x > −3 only' comes from taking the square root of both sides to get x + 3 > 0 and keeping only that branch; 'x < −3 only' comes from the same square-rooting followed by turning the sign round, as though the step had been a division by a negative number.
- (a) An identity, because it is true for every value of x — Expanding the brackets multiplies both terms inside by 4, giving 4x + 12, which is exactly the right-hand side. The two sides are therefore equal whatever x is, and a statement true for every value of the letter is an identity. An equation is true only for particular values, and trying to solve this one leads to 0 = 0, which places no restriction on x at all. Being able to expand brackets is not what makes a statement an identity, since any equation with brackets can be expanded. Nor is it a formula: a formula links two different quantities, and only one letter appears here.
- (c) L/5 − 3 — Each of the 5 equal pieces is L/5 metres long, and removing 3 metres from one piece gives L/5 − 3. Subtracting the 3 metres before dividing by 5, (L − 3)/5, divides the removed length between all 5 pieces instead of taking it from just one. Dividing only the 3 by 5 instead of dividing L by 5, L − 3/5, divides the wrong number. Writing 5/L − 3 inverts the fraction, swapping which number is the numerator.
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
- (a) It touches the x-axis once, only at x = 4. — (x − 4)² is a square, so it equals zero only when x − 4 = 0, that is at x = 4 — the curve just touches the x-axis there rather than crossing it, since a square cannot be negative on either side to cross through. Saying it crosses at x = 4 and x = −4 wrongly introduces a plus-or-minus, as if taking a square root of x, rather than recognising the bracket is already squared and only zero once. Saying it never touches the x-axis forgets that a squared term CAN equal zero, even though it can never be negative. Saying it crosses at x = 2 and x = −2 confuses (x − 4)² with the different expression x² − 4.
- (d) 68, and it is a formula — Substituting C = 20 gives F = 1.8 × 20 + 32 = 36 + 32 = 68. The statement F = 1.8C + 32 is a formula because it expresses a general relationship between F and C that holds for any value of C, not just C = 20. A candidate who gets the correct value but calls it an equation is confusing "has an equals sign" with "is an equation" — an equation is only true for particular value(s) of the unknown, whereas this relationship is used to calculate rather than to be solved. A candidate who forgets to multiply C by 1.8 and just adds 32 to 20 gets 52. A candidate who multiplies correctly but forgets to add 32 gets 36.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (b) x = 3, y = 4 — −x² + 6x − 5 = −(x² − 6x) − 5 = −[(x − 3)² − 9] − 5 = −(x − 3)² + 9 − 5 = −(x − 3)² + 4. Because the coefficient of x² is negative, −(x − 3)² is at most zero, so this turning point is a maximum. Substituting x = 3 gives (x − 3)² = 0, so y = 4, confirming the maximum value 4 at x = 3: turning point (3, 4). Using 6 instead of half of 6 inside the bracket — forgetting to halve before completing the square — lands on turning point (6, 31), wrong, because only half the coefficient belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−3, 4) — wrong, because (x − 3)² is zero at x = 3, not x = −3. Computing 5 − 9 = −4 instead of 9 − 5 = 4 flips the sign of the constant, giving (3, −4) — wrong, since the constant must be evaluated as 9 minus 5, not 5 minus 9. Whenever the leading coefficient is negative, the turning point is a maximum, not a minimum — check by substituting back into the original equation.
Build your own mix at the worksheet builder.