Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 18 — The common ratio is 2√3 ÷ 2 = √3. Checking: 6 ÷ 2√3 = √3 and 6√3 ÷ 6 = √3, so the ratio is consistent throughout. The next term is 6√3 × √3 = 6 × 3 = 18, since √3 × √3 = 3. Looking only at the coefficients 2, 2, 6, 6 and continuing them by doubling the last one gives 6 × 2 = 12, which is wrong because the step from each term to the next is a multiplication by √3, not a pattern in the coefficients alone. Doubling the previous term instead of multiplying by the surd ratio √3 gives 6√3 × 2 = 12√3, which is wrong because the common ratio is √3, not 2. Using 3 instead of √3 as the common ratio — squaring the true ratio by mistake — gives 6√3 × 3 = 18√3, which is wrong because 3 is the SQUARE of the common ratio, not the ratio itself.
- (b) 235 litres — The flow rate at t = 10 is the gradient of the tangent: change in volume ÷ change in time = (190 − 130) ÷ (12 − 8) = 60 ÷ 4 = 15 litres per minute. Treating this rate as roughly constant for a short interval, the volume 5 minutes after t = 10 is estimated as 160 + 5 × 15 = 235 litres. Using the tangent's own point spacing — 2 minutes, from t = 10 to t = 12 — instead of the 5 minutes actually asked for gives 160 + 2 × 15 = 190, which is just the volume already given at one of the tangent's own points, not an answer to the question asked. Multiplying the gradient by the time WITHOUT adding the starting volume, 5 × 15 = 75, forgets that a rate estimates a CHANGE, which must be added to the starting volume, not given as the answer on its own. Subtracting instead of adding, 160 − 5 × 15 = 85, extrapolates backward in time rather than forward.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (d) 44 m — The trapezium rule between t = 2 and t = 5 uses only the speeds at t = 2, 3, 4 and 5 — 12, 15, 16 and 14 — with three strips of width 1: adding the first and last readings and twice the sum of the middle readings gives 12 + 14 + 2 × (15 + 16) = 88, and half of that is 44 m. Writing 68.5 m comes from applying the trapezium rule to the whole table, from t = 0 to t = 6, instead of restricting it to the interval t = 2 to t = 5 that the question asks for. Writing 28.5 m comes from forgetting to double the two middle readings, 15 and 16, in the trapezium rule formula. Writing 39 m comes from averaging only the first and last speeds in the interval, 12 and 14, and multiplying by the 3-second interval, ignoring the readings at t = 3 and t = 4 in between.
- (c) a formula — A statement that shows how to calculate one quantity from others, using an equals sign, is a formula. P = 2l + 2w tells us how to work out the perimeter, P, from the length and width, so it is a formula. Distractor origins: 'an equation' confuses a formula linking several letters with an equation solved for one unknown value; 'an identity' confuses a formula with a statement that is true for every value of a single variable; 'an expression' forgets that an expression has no equals sign at all.
- (a) 3 — y = f(x + 2) is f(x) translated 2 units to the LEFT (inside the bracket, adding moves the graph in the negative x-direction). The root moves with the whole graph: 5 − 2 = 3. Moving right instead of left gives 7; assuming a bracket shift leaves the root unchanged gives 5; writing down the shift amount 2 itself skips the translation altogether.
- (a) 5p + 7q — Tom's total spend combines like terms: (2p + 6q) + (3p + q) = 5p + 7q, adding the notebook terms (2p + 3p = 5p) and the pencil terms (6q + q = 7q) separately. Answering 12pq adds every coefficient together (2 + 6 + 3 + 1 = 12) and multiplies the letters, combining unlike terms as though notebooks and pencils were the same item. Answering 5p + 6q correctly combines the notebook terms but forgets to add Tuesday's extra pencil to the 6q. Answering 2p + 7q correctly combines the pencil terms but forgets to add Tuesday's 3 extra notebooks to the 2p. The total amount Tom has spent is 5p + 7q pence.
- (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
- (b) (2, 4) and (−2, −4) — Substitute y = 2x into x² + y² = 20: x² + (2x)² = 20, which gives x² + 4x² = 20, so 5x² = 20, x² = 4, and x = 2 or x = −2. Using y = 2x for each x-value: x = 2 gives y = 4; x = −2 gives y = −4. The path meets the pond's edge at (2, 4) and (−2, −4). Distractor routes: (2, −4) and (−2, 4) swaps the sign pairing, matching each x-value with the wrong sign of y instead of keeping each x with its own correctly-signed y. (2, 1) and (−2, −1) comes from using y = x/2 instead of y = 2x when finding the y-coordinates. (2, 4) alone stops after the positive square root of x² = 4 and never finds the second point from x = −2.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (d) 7 — Method: set up the equation 2.50 + 1.80m = 15.10, then subtract the booking fee and divide by the cost per mile. Working: 1.80m = 15.10 − 2.50 = 12.60; m = 12.60 ÷ 1.80 = 7. Answer: 7 miles. 8.39 comes from dividing the whole £15.10 by £1.80 without first subtracting the booking fee: 15.10 ÷ 1.80 ≈ 8.39. 5.32 comes from swapping the two amounts round, subtracting £1.80 and dividing by £2.50: (15.10 − 1.80) ÷ 2.50 ≈ 5.32. 9.78 comes from adding the booking fee instead of subtracting it: (15.10 + 2.50) ÷ 1.80 ≈ 9.78.
- (a) It is 2(w + (w + 3)) = 4w + 6, not 2w + 3. — The perimeter of a rectangle is twice the width plus twice the length: 2 × w + 2 × (w + 3) = 2w + 2w + 6 = 4w + 6, so the gardener's 2w + 3 is wrong. Writing w + (w + 3) = 2w + 3 forgets to double the sides at all, only adding one width and one length once. Writing 4(w + 3) = 4w + 12 wrongly treats all four sides as equal to the length, as if the garden were a square. Writing 3w + 6 comes from doubling the length correctly but adding the width only once instead of doubling it too.
- (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
Build your own mix at the worksheet builder.