Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) Below y = x + 1, below x + y = 5, above y = 0 — For y ≤ x + 1, R lies on or below the line y = x + 1. For x + y ≤ 5 (that is, y ≤ 5 − x), R lies on or below that line too. For y ≥ 0, R lies on or above the x-axis. Combining all three: R is below y = x + 1, below x + y = 5, and above y = 0. Distractor routes: "Above y = x + 1" flips the first inequality, describing the wrong side of that line. "Above x + y = 5" flips the second inequality, describing the wrong side of that line. "Below y = 0" flips the third inequality, describing the wrong side of the x-axis.
- (b) 85 — Substitute n = 10: 10² − 2 × 10 + 5 = 100 − 20 + 5 = 85. A sign error on the −2n term, treating it as +2n, gives 100 + 20 + 5 = 125. Using n = 9 instead of n = 10 gives 81 − 18 + 5 = 68. Working out 10² − 2 × 10 but forgetting to add the final +5 gives 80.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (c) 7n − 1 — Method: find the common difference, then find the constant that fits the first term. Working: 13 − 6 = 7, 20 − 13 = 7, 27 − 20 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 6, so c = −1. Answer: the nth term is 7n − 1. The value 7n comes from leaving out the constant altogether. The value 7n + 6 comes from using the first term as the constant directly, without subtracting the common difference first. The value 6n + 1 comes from using the first term, 6, as the coefficient of n instead of the common difference, and then attaching +1 with the sign of the constant flipped.
- (b) (−5, −2) — Both points have the same y-coordinate, so the midpoint lies on the same horizontal line: y = −2. The x-coordinate is the average of −9 and −1: (−9 + (−1)) ÷ 2 = −10 ÷ 2 = −5, giving (−5, −2). (−10, −2) comes from adding the x-coordinates but forgetting to divide by 2. (−4, −2) comes from a sign error on the second x-coordinate, treating −1 as +1: (−9 + 1) ÷ 2 = −4. (5, −2) comes from dropping the negative sign on the x-coordinate.
- (d) line 2 — Line 1 correctly represents three consecutive integers using n. Line 2 adds them: n + (n + 1) + (n + 2). Collecting terms: the n-terms give 3n, and the constants give 1 + 2 = 3, so the correct sum is 3n + 3, not 3n + 2 as Line 2 states — this is the first error, an arithmetic slip in collecting the constant terms. Lines 3 and 4 both follow correctly from Line 2's incorrect result, but that result itself is wrong: the true sum, 3n + 3 = 3(n + 1), is a multiple of 3 for every whole number n. Check the working of each line against what came before it, in order, rather than judging whether the final conclusion feels right — an error that flips the conclusion can sit several lines before the line that states it.
- (b) Translate −90° in x, then translate −2 in y. — cos(x + 90°) translates the graph 90° in the NEGATIVE x-direction, since a positive shift inside the bracket moves a graph left, not right, and subtracting 2 afterwards translates it 2 units in the negative y-direction (down). So the sequence is: translate −90° in x, then translate −2 in y. Using +90° in x reverses the direction of the horizontal shift — the sign inside the bracket moves the graph the opposite way to what it looks like. Using +2 in y reverses the direction of the vertical shift; subtracting 2 outside the function moves the graph down, not up. Describing the −2 as a reflection in the x-axis is wrong because a reflection turns positive y-values negative and vice versa, whereas here every y-value is simply reduced by the fixed amount 2, which is what a translation does, not a reflection.
- (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (c) 2.61 — The limit L satisfies L = 12 ÷ (L + 2), so L(L + 2) = 12, giving L² + 2L − 12 = 0 and L = (−2 + √52) ÷ 2 = 2.6056, which is 2.61 to 2 decimal places (the early iterates 4, 2, 3, 2.4, 2.73, ... oscillate around this value before settling). Choosing 3.00 reads off x₃, one of the early oscillating values, before the sequence has settled close to the limit. Choosing 4.00 reads off x₁, the very first iterate, not the value the sequence approaches. Choosing 6.00 comes from writing the limit equation as L = 12 ÷ 2, leaving L itself out of the denominator.
- (c) y = (5/12)x − 169/12 — The gradient of the radius to (5, −12) is (−12 − 0) ÷ (5 − 0) = −12/5. A tangent is perpendicular to the radius at that point, so its gradient is the negative reciprocal, 5/12. Using y − y₁ = m(x − x₁) with (5, −12): y + 12 = (5/12)(x − 5), which gives y = (5/12)x − 169/12. y = −(12/5)x comes from using the radius's own gradient, −12/5, instead of turning it into the perpendicular gradient, and building the line through the origin (as the radius itself does). y = −(5/12)x − 119/12 comes from taking the reciprocal of −12/5 correctly as a size but keeping the wrong sign, using −5/12 instead of 5/12. y = (5/12)x − 25/12 comes from using the correct gradient 5/12 but building the line through (5, 0) instead of (5, −12) — dropping the point's y-coordinate.
- (a) 2(3x + 1) = 6x + 2 — Expanding 2(3x + 1) = 6x + 2 gives an expression that matches the right-hand side exactly for every value of x — it is an identity. 4x − 3 = 3x + 5 is an ordinary equation with one solution, x = 8. 7 − x = x − 7 is also an ordinary equation with one solution, x = 7. 5x + 1 = 5(x + 1) never holds for any value of x at all, since expanding the right-hand side gives 5x + 5, and 5x + 1 = 5x + 5 would require 1 = 5, which is impossible.
- (b) 12.7 m/s — Find the total distance from the area under the graph, then divide by the total time. Break the graph into its four straight sections: a triangle from (0, 0) to (5, 20), where 5 × 20 = 100 gives an area of 50 m when halved; a rectangle from (5, 20) to (12, 20), area 7 × 20 = 140 m; a trapezium from (12, 20) to (16, 4), where (20 + 4) × 4 = 96 gives an area of 48 m when halved; and a rectangle from (16, 4) to (20, 4), area 4 × 4 = 16 m — a total distance of 50 + 140 + 48 + 16 = 254 m. Dividing by the 20 seconds gives an average speed of 254 ÷ 20 = 12.7 m/s. Writing 15.1 m/s comes from forgetting to halve the trapezium area for the third section, using 96 instead of 48: a total of 302 m, and 302 ÷ 20 = 15.1 m/s. Writing 11.9 m/s comes from leaving out the final section, from (16, 4) to (20, 4), entirely: a total of 238 m, and 238 ÷ 20 = 11.9 m/s. Writing 12.1 m/s comes from dividing the correct total distance by 21 instead of 20 — a fencepost slip, counting the whole seconds from t = 0 to t = 20 inclusive as 21 seconds of travel rather than reading the journey as a duration of 20 seconds: 254 ÷ 21 = 12.1 m/s (1 d.p.).
- (d) n and n + 1 are consecutive integers, so one of them must be even; this makes n(n + 1) even, so 4n(n + 1) is 4 × an even number, which is a multiple of 8. — The proof needs a reason why n(n + 1) is even, not just an assertion. n and n + 1 are consecutive integers, so exactly one of them is even; multiplying by that even number keeps n(n + 1) even, so 4n(n + 1) = 4 × (an even number), and 4 × an even number always has a further factor of 2 hidden inside it, making the whole product a multiple of 8. The option 'is a multiple of 4, and because n and n + 1 are consecutive integers, it must be a multiple of 8' asserts the multiple-of-8 conclusion directly from 'multiple of 4' and 'consecutive integers' without ever showing that n(n + 1) itself is even — the missing step is exactly what earns the mark. The option '4n is always a multiple of 4 ... which means it is a multiple of 8' mistakes 4n being a multiple of 4 for the whole product 4n(n + 1) being a multiple of 8; that extra factor of 2 only comes from n(n + 1) being even, not from 4n alone. The option that expands to 4n² + 4n and calls it 'clearly a multiple of 8' never checks for a factor of 2 beyond the 4 already there — the word 'clearly' is standing in for a missing argument.
Build your own mix at the worksheet builder.