Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 16 — A and B share the same y-coordinate, so the distance between them is the horizontal difference between their x-coordinates: 8 − (−8) = 16, giving a chord of length 16. Choosing 8 gives only the x-coordinate of one point, not the full distance between the two points. Choosing 34 is the diameter of the circle (2 × 17), not the length of this particular chord. Choosing 17 is the radius — the distance from the centre to A or to B, not from A to B.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (a) (n − 5)/2 — Method: do the subtraction first, keep it together as a single bracket, then divide that whole bracket by 2. Working: 'subtract 5 from n' is (n − 5); 'divide the result by 2' means the whole bracket goes over 2, giving (n − 5)/2. Answer: (n − 5)/2. n/2 − 5 comes from dividing n by 2 first and only then subtracting 5, the wrong order. 2(n − 5) comes from multiplying by 2 instead of dividing. (5 − n)/2 comes from subtracting n from 5 instead of subtracting 5 from n, the wrong way round.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (b) (−5, −2) — Both points have the same y-coordinate, so the midpoint lies on the same horizontal line: y = −2. The x-coordinate is the average of −9 and −1: (−9 + (−1)) ÷ 2 = −10 ÷ 2 = −5, giving (−5, −2). (−10, −2) comes from adding the x-coordinates but forgetting to divide by 2. (−4, −2) comes from a sign error on the second x-coordinate, treating −1 as +1: (−9 + 1) ÷ 2 = −4. (5, −2) comes from dropping the negative sign on the x-coordinate.
- (b) (−4, 3) — Method: in a rectangle whose sides are parallel to the axes only two different x-coordinates and two different y-coordinates appear, and each of them is shared by a pair of vertices, so the missing vertex takes the x-coordinate and the y-coordinate that so far appear only once. Working: the x-coordinates given are −4, 2 and 2, so 2 is already used twice and −4 is used once; the y-coordinates given are −1, −1 and 3, so −1 is already used twice and 3 is used once; the fourth vertex therefore has x = −4 and y = 3. Answer: (−4, 3). The distractors: (3, −4) comes from picking the two unpaired coordinates correctly and then writing them in the wrong order; (−4, −5) comes from matching the 4-unit vertical side but measuring it downwards from (−4, −1) instead of upwards; (8, 3) comes from carrying on round the shape with the horizontal step used earlier, adding 6 to the x-coordinate of (2, 3) instead of closing the rectangle.
- (a) −8 — −f(x) means take the output value from the table and change its sign, without changing which x-value is looked up. From the table, f(1) = 8, so −f(1) = −8. Reading f(1) = 8 from the table but forgetting to apply the negative sign gives 8. Misreading the row and using f(0) = 5 instead of f(1) = 8, then negating it, gives −5. Confusing −f(x) with f(x) − 1 — taking f(1) = 8 and subtracting 1 instead of negating — gives 7.
- (c) 3 — Gradient = (change in y) ÷ (change in x) = (11 − 5) ÷ (4 − 2) = 6 ÷ 2 = 3. A candidate who puts the change in x over the change in y instead would get 2 ÷ 6 = 1/3. A candidate who subtracts the y-coordinates in the reverse order, but not the x-coordinates, would get (5 − 11) ÷ (4 − 2) = −3. A candidate who adds the coordinates instead of subtracting them would get (11 + 5) ÷ (4 + 2) = 16/6 = 8/3.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
- (d) Wrong — the correct solution is x < −3 or x > 3. — Squaring or unsquaring an inequality is not a safe one-step move: the solution must be split into two branches, since a number less than −3 also squares to more than 9. So x > 3 finds only half the solution set. The full answer is x < −3 or x > 3. Distractor routes: "Right — square rooting both sides gives x > 3" treats the square root of an inequality the same as the square root of an equation and misses the negative branch entirely. "Wrong — the correct solution is −3 < x < 3" applies the between-the-roots pattern that belongs to the opposite inequality, x² < 9. "Right, but x = −3 and x = 3 should also work" treats the inequality as if it also allowed equality, when x² > 9 is strict and excludes both x = 3 and x = −3.
- (b) s = d / t — Method: undo the multiplication by t by dividing both sides by t. Working: d = st, so dividing both sides by t gives s = d / t. The value s = dt comes from multiplying by t instead of dividing. The value s = t / d comes from inverting the fraction, dividing t by d instead of d by t. The value s = d − t comes from subtracting t instead of dividing by it.
- (c) 8n + 7 — Method: find the weekly increase, then find the constant by adjusting the week 1 total. Working: the total goes up by £8 each week (23 − 15 = 8), so the coefficient of n is 8. The constant is the week 1 total minus the common difference: 15 − 8 = 7. Answer: the nth term is 8n + 7. 8n + 15 comes from using the week 1 total, 15, as the constant without subtracting the common difference. 8n − 1 comes from a slip in working out the constant, subtracting the common difference twice (15 − 8 − 8 = −1) instead of once. 7n + 8 comes from swapping the weekly increase and the constant.
- (c) y = 3x + 7 — Method: the gradient is the change in y divided by the change in x with both taken in the same order, and a point whose x-coordinate is 0 gives the constant straight away because it lies on the y-axis. Working: m = (7 − 1) ÷ (0 − (−2)) = 6 ÷ 2 = 3; the point (0, 7) lies on the y-axis, so c = 7 and the line is y = 3x + 7. Answer: y = 3x + 7. The distractors: y = −3x + 7 comes from taking the y-difference as 1 − 7 while taking the x-difference as 0 − (−2), so the two subtractions run in opposite orders; y = 3x + 1 comes from using the y-coordinate of (−2, 1) as the constant instead of the point that actually lies on the y-axis; y = (1/3)x + 7 comes from writing the gradient upside down as the change in x over the change in y, 2 ÷ 6.
- (b) k = 6 — Method: two simultaneous linear equations have no solution when the lines they describe are parallel, so write each equation in the form y = mx + c and make the gradients equal. Working: kx + 2y = 4 rearranges to y = −(k/2)x + 2, so its gradient is −k/2, and 3x + y = 5 rearranges to y = −3x + 5, so its gradient is −3; setting −k/2 = −3 gives k = 6, and the first equation is then 6x + 2y = 4, which simplifies to 3x + y = 2 and can never agree with 3x + y = 5. Answer: k = 6. The distractors: k = −6 comes from reading the gradient of kx + 2y = 4 as +k/2 and solving k/2 = −3; k = 3 comes from making the x terms identical instead of making the gradients equal; k = 2/3 comes from writing the gradient of 3x + y = 5 upside down as −1/3 and solving −k/2 = −1/3.
Build your own mix at the worksheet builder.