Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (c) 2(x + 4) ≡ 2x + 8 — 2(x + 4) ≡ 2x + 8 is an identity because expanding the bracket on the left gives exactly the right-hand side for every value of x — try any number and both sides match. 2(x + 4) = 20 is an equation: expanding gives 2x + 8 = 20, which is only true for the single value x = 6. 2(x + 4) = 2x + 4 is not true for any value of x at all: expanding the left side gives 2x + 8, which can never equal 2x + 4 since 8 ≠ 4. x + 4 = 2x is also an equation, true only for the single value x = 4. The identity is 2(x + 4) ≡ 2x + 8.
- (d) 36 — (2n)² means the whole of 2n is squared, so with n = 3: (2n)² = (2 × 3)² = 6² = 36. Answering 18 instead works out 2n² — squaring only the n and then multiplying by 2 — which is a different expression because the brackets around 2n are missing. Answering 12 squares only the coefficient, treating (2n)² as 2² × n = 4 × 3 = 12, and forgets to square the n as well. Answering 9 ignores the coefficient of 2 altogether and works out n² on its own. The value of (2n)² when n = 3 is 36.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (b) 6 — 3n + 4.5 = 22.5, so 3n = 18 and n = 6. A candidate who divides 22.5 by 3 first and ignores the 4.5 gets n = 7.5. A candidate who makes a sign error and forms the equation 3n − 4.5 = 22.5 gets 3n = 27 and n = 9. A candidate who divides by 3 before subtracting the 4.5, working out 22.5 ÷ 3 + 4.5, gets n = 12.
- (c) x ≤ 4 — Subtract 9 from both sides: −2x ≥ 1 − 9 = −8. Divide both sides by −2, flipping the inequality: x ≤ 4. A candidate who divides by −2 but forgets to flip the inequality gets x ≥ 4. A candidate who divides −8 by −2 but keeps a negative sign gets x ≤ −4. A candidate who miscalculates 1 − 9 as −10 gets x ≤ 5.
- (a) 120 m — The gradient of the second line is (0 − V)/(9 − 6) = −V/3, and this equals −8, so V = 24. The distance from t = 0 to t = 6 is the area of a trapezium with parallel sides 4 and 24 and width 6: 1/2 × (4 + 24) × 6 = 84. The distance from t = 6 to t = 9 is the area of a triangle with base 3 and height 24: 1/2 × 3 × 24 = 36. The total distance is 84 + 36 = 120 m. Using V = 8, treating the gradient's number as the missing velocity itself rather than solving −V/3 = −8 for V, gives a trapezium area of 1/2 × (4 + 8) × 6 = 36 and a triangle area of 1/2 × 3 × 8 = 12, a total of 48 m. Leaving out the 1/2 in the trapezium formula, (4 + 24) × 6 = 168, plus the correct triangle of 36, gives 204 m. Using the full 6 seconds as the triangle's base instead of the 3 seconds the second line actually lasts, 1/2 × 6 × 24 = 72, plus the correct trapezium of 84, gives 156 m.
- (c) y = 2x + 1 — Method: the gradient of the line through two points is the change in y divided by the change in x, and the constant is then found by substituting one of the points into y = mx + c. Working: m = (5 − 3) ÷ (2 − 1) = 2 ÷ 1 = 2, so the line is y = 2x + c; substituting x = 1 and y = 3 gives 3 = 2 × 1 + c, so c = 3 − 2 = 1. Answer: y = 2x + 1. The distractors: y = x + 2 comes from taking the gradient as the change in x, 2 − 1 = 1, and then substituting (1, 3) to reach a constant of 2; y = 2x − 1 comes from working out the constant as mx − y, 2 × 1 − 3 = −1, instead of y − mx; y = 2x + 3 comes from using the y-coordinate of (1, 3) as the constant without substituting at all.
- (a) An identity, because it is true for every value of x — Expanding the brackets multiplies both terms inside by 4, giving 4x + 12, which is exactly the right-hand side. The two sides are therefore equal whatever x is, and a statement true for every value of the letter is an identity. An equation is true only for particular values, and trying to solve this one leads to 0 = 0, which places no restriction on x at all. Being able to expand brackets is not what makes a statement an identity, since any equation with brackets can be expanded. Nor is it a formula: a formula links two different quantities, and only one letter appears here.
- (a) y = 2ˣ + 3 — A translation of 3 units in the positive y-direction shifts the whole graph up, which means adding to the output: y = f(x) + k with k = 3, so the image is y = 2ˣ + 3. Adding the 3 inside the power instead of outside it, which translates the graph horizontally instead of vertically, gives y = 2ˣ⁺³. Using a negative 3, which moves the graph down instead of up, gives y = 2ˣ − 3. Mistaking 2ˣ for the linear expression 2x and adding 3 inside brackets gives y = 2(x + 3).
- (c) r = √(A/π) — A = πr² means r has been squared and then multiplied by π. To make r the subject, first divide both sides by π to get A/π = r², then take the square root of both sides: r = √(A/π). Writing r = A/π stops after dividing by π and forgets that r is still squared — it never undoes the square. Writing r = √A/π takes the square root before dividing by π, which square-roots only the A and not the whole of A/π. Writing r = (A/π)² squares A/π instead of taking its square root — the opposite of what is needed to undo r². The correct rearrangement is r = √(A/π).
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
- (a) y = (x − 2)² + 3 — Since (x − 2)² is never negative, (x − 2)² + 3 is always at least 3, so y can never equal 0 and the graph never crosses the x-axis. The other three graphs are all given in a factorised or difference-of-squares form that shows two real roots: y = (x − 2)(x + 3) crosses at x = 2 and x = −3; y = x² − 9 = (x − 3)(x + 3) crosses at x = 3 and x = −3; y = (x + 4)(x − 1) crosses at x = −4 and x = 1.
- (c) −4 — f(2) = 7, and y = f(x) + a passing through (2, 3) means f(2) + a = 3, so 7 + a = 3, giving a = 3 − 7 = −4. Writing a = 4 comes from subtracting the wrong way round, 7 − 3 instead of 3 − 7. Writing a = 10 comes from adding the two y-values instead of subtracting one from the other. Writing a = 3 comes from taking the new y-coordinate as the value of a directly, without accounting for the original y-value of 7 at all.
Build your own mix at the worksheet builder.