Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (c) The sequence diverges, moving away from x = 3 — Starting from x₀ = 2.9: x₁ = 2.9² − 6 = 2.41, x₂ = 2.41² − 6 = −0.19, x₃ = (−0.19)² − 6 = −5.96, x₄ = (−5.96)² − 6 = 29.56 — the values swing away from 3 and grow rapidly, so the sequence diverges rather than settling anywhere. Choosing 'settles towards x = 3' assumes that starting close to a root is enough for a rearrangement to converge to it, which is not always true — this rearrangement changes values too steeply near x = 3 to stay there. Choosing 'settles towards x = −2' assumes a diverging sequence must eventually land on the other root; instead it runs away to increasingly large values. Choosing 'stays constant at 2.9' ignores that applying the formula changes the value at every step.
- (c) y = 2x + 1 — Method: the gradient of the line through two points is the change in y divided by the change in x, and the constant is then found by substituting one of the points into y = mx + c. Working: m = (5 − 3) ÷ (2 − 1) = 2 ÷ 1 = 2, so the line is y = 2x + c; substituting x = 1 and y = 3 gives 3 = 2 × 1 + c, so c = 3 − 2 = 1. Answer: y = 2x + 1. The distractors: y = x + 2 comes from taking the gradient as the change in x, 2 − 1 = 1, and then substituting (1, 3) to reach a constant of 2; y = 2x − 1 comes from working out the constant as mx − y, 2 × 1 − 3 = −1, instead of y − mx; y = 2x + 3 comes from using the y-coordinate of (1, 3) as the constant without substituting at all.
- (b) 118 m — Width = 840 ÷ 35 = 24 m. Perimeter = 2 × (length + width) = 2 × (35 + 24) = 2 × 59 = 118 m. The option 59 m gives the sum of the length and width but forgets to double it for the perimeter. The option 70 m doubles only the length (2 × 35 = 70) and leaves out the width entirely. The option 48 m doubles only the width (2 × 24 = 48) and leaves out the length entirely.
- (d) 3.425 — x₁ = ∛(6 × 3 + 20) = ∛38 = 3.3620 (unrounded, 3.36198...). x₂ = ∛(6 × 3.3620 + 20) = ∛40.172 = 3.425 (3 d.p.). Choosing 3.362 stops at x₁ instead of continuing to x₂. Choosing 2.722 leaves out the '+ 20' inside the root, working out ∛(6 × 3.3620) = ∛20.172 = 2.722. Choosing 0.556 subtracts 20 instead of adding it, working out ∛(6 × 3.3620 − 20) = ∛0.172 = 0.556.
- (b) k = 6 — Method: two simultaneous linear equations have no solution when the lines they describe are parallel, so write each equation in the form y = mx + c and make the gradients equal. Working: kx + 2y = 4 rearranges to y = −(k/2)x + 2, so its gradient is −k/2, and 3x + y = 5 rearranges to y = −3x + 5, so its gradient is −3; setting −k/2 = −3 gives k = 6, and the first equation is then 6x + 2y = 4, which simplifies to 3x + y = 2 and can never agree with 3x + y = 5. Answer: k = 6. The distractors: k = −6 comes from reading the gradient of kx + 2y = 4 as +k/2 and solving k/2 = −3; k = 3 comes from making the x terms identical instead of making the gradients equal; k = 2/3 comes from writing the gradient of 3x + y = 5 upside down as −1/3 and solving −k/2 = −1/3.
- (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
- (a) An identity, true for every value of x — Expanding the bracket on the left gives 3x + 12, which matches the right-hand side exactly, so the statement is true for every value of x — this makes it an identity. A candidate who reasons that any statement with an equals sign must be an equation picks that option, missing that an equation is only true for particular value(s) of x, not all of them. A candidate who confuses an identity with a formula, because both relate two expressions, picks the formula option — but a formula connects two different quantities, such as area and side length, not two equivalent forms of the same expression. A candidate who assumes it can be solved for a single value of x, as with a normal equation, picks that option, not realising there is no single solution here.
- (b) x = 2, y = −5 — 2x² − 8x + 3 rewrites as 2(x² − 4x) + 3, then as 2[(x − 2)² − 4] + 3, which simplifies to 2(x − 2)² − 5, since −2 × 4 + 3 = −5. Substituting x = 2: 2 × 2² = 8, 8 × 2 = 16, so 8 − 16 + 3 = −5, confirming the minimum value −5 at x = 2: turning point x = 2, y = −5. Halving b instead of halving b/a — using 4 as the shift instead of 2 — lands on turning point x = 4, y = −29, which is wrong because when a ≠ 1 the shift inside the bracket is b/(2a), not b/a alone. Reading the bracket's sign directly as the turning point's x-coordinate gives x = −2, y = −5 — wrong, because (x − 2)² is zero at x = 2, not x = −2. Computing 8 − 3 = 5 instead of 3 − 8 = −5 flips the sign of the constant, giving x = 2, y = 5 — wrong, since the completed square's constant must be evaluated as 3 minus 8, not 8 minus 3. Whenever a ≠ 1, factor a out of the x² and x terms first, and always check a turning point by substituting back into the original equation.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (a) Yes — the gradients multiply to −2 × 1/2 = −1. — Rearrange Q into the form y = mx + c: 2y = x + 6 gives y = (1/2)x + 3, so Q has gradient 1/2. P has gradient −2. Two lines are perpendicular exactly when the product of their gradients is −1: −2 × 1/2 = −1. Since this holds, P and Q are perpendicular. Distractor routes: "the product is −1, but perpendicular needs 1" works out the product correctly but misremembers the condition — the perpendicular test is a product of exactly −1, and parallel lines are spotted by their gradients being equal, not by a product of 1. "Q's gradient is 2, and −2 × 2 = −4" comes from reading the 2 in front of y in 2y = x + 6 as the gradient, instead of dividing the whole equation by 2 first to reach y = (1/2)x + 3, where the gradient is 1/2. "Both equations have a negative x-term" is not a valid test at all — P's equation does have a negative x-term, but Q's, once rearranged, does not, and matching signs say nothing about the actual gradients.
- (d) 6 — Method: collect the x-terms on one side and the constants on the other, then divide by the remaining coefficient of x. Working: 6x − 3x = 13 + 5, so 3x = 18, x = 18 ÷ 3 = 6. Answer: x = 6. 2.67 comes from a sign error when moving the 5, subtracting instead of adding: 3x = 13 − 5 = 8, x = 8 ÷ 3 ≈ 2.67. 2 comes from a sign error when moving the x-term, adding instead of subtracting: 9x = 18, x = 2. 18 comes from correctly finding 3x = 18 but forgetting to divide by 3.
- (d) x₂ closer: f(x₂) = 0.0225, nearer to 0 — f(2.6) = 2.6² − 7 = 6.76 − 7 = −0.24, and f(2.65) = 2.65² − 7 = 7.0225 − 7 = 0.0225. The closer a value of x is to the root, the closer f(x) is to zero — regardless of sign. Since |0.0225| = 0.0225 is much smaller than |−0.24| = 0.24, x₂ = 2.65 is closer to the root. 'x₁ closer: −0.24 is the smaller value' comes from comparing the SIGNED values of f(x) rather than their distances from zero — −0.24 is indeed less than 0.0225 as a number, but that does not mean x₁ is closer to the root. 'x₁ closer: f(x₁) negative ⇒ nearer root' invents a rule that a negative f(x) means x is closer to the root; the sign of f(x) only tells you which side of the root x is on, not how close it is. 'x₂ is the exact root, since f(x₂) ≈ 0' misreads f(x₂) = 0.0225 as zero; the true root is √7 ≈ 2.6458, so f(2.65) is close to zero but not equal to it, and x₂ is an approximation, not the exact root.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (b) 0.458 — x₁ = (0.4² + 3) ÷ 7 = 3.16 ÷ 7 = 0.4514 (unrounded, 0.451428...). x₂ = (x₁² + 3) ÷ 7 = (0.2038 + 3) ÷ 7 = 3.2038 ÷ 7 = 0.458 (3 d.p.). Choosing 0.632 divides only the 3 by 7 instead of dividing the whole sum x₁² + 3 by 7. Choosing 0.451 repeats the calculation for x₁ instead of moving on to x₂. Choosing 0.493 uses x₁ itself instead of x₁² inside the formula.
Build your own mix at the worksheet builder.