Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (b) 40 — The differences between consecutive terms are 3, 5, 7, 9, increasing by 2 each time, so the next difference is 11, giving 29 + 11 = 40. A candidate who reuses the last difference of 9 without increasing it gets 29 + 9 = 38. A candidate who increases the difference by only 1 instead of 2 gets 29 + 10 = 39. A candidate who reuses the first difference of 3 instead of the pattern gets 29 + 3 = 32.
- (c) 2.61 — The limit L satisfies L = 12 ÷ (L + 2), so L(L + 2) = 12, giving L² + 2L − 12 = 0 and L = (−2 + √52) ÷ 2 = 2.6056, which is 2.61 to 2 decimal places (the early iterates 4, 2, 3, 2.4, 2.73, ... oscillate around this value before settling). Choosing 3.00 reads off x₃, one of the early oscillating values, before the sequence has settled close to the limit. Choosing 4.00 reads off x₁, the very first iterate, not the value the sequence approaches. Choosing 6.00 comes from writing the limit equation as L = 12 ÷ 2, leaving L itself out of the denominator.
- (a) 45 — The ratio between the two given points, one power of x apart, gives b: 405 ÷ 135 = 3, so b = 3. Substituting back, at x = 1, y = A × b, so 135 = A × 3, giving A = 45. Giving the common ratio b itself instead of A confuses which unknown was asked for and produces 3 — wrong, because the question asks for A, not b. Giving 135 instead treats the first given point as the y-intercept and reads A off it directly — wrong, because that point is at x = 1, not x = 0, so 135 is A × b, not A. Assuming A equals b⁰ = 1 by itself, rather than substituting a known point to solve for A, gives 1 — wrong, because b⁰ is always 1 regardless of A; A must be found using an actual (x, y) pair from the graph.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (b) y = f(−x) — y = f(−x) reflects the graph of y = f(x) in the y-axis: every x-coordinate changes sign. The x-intercepts −3 and 7 become 3 and −7, matching the second graph's intercepts −7 and 3. A point already on the y-axis is unaffected, since −0 = 0, so the y-intercept (0, 21) stays exactly where it is — matching the second graph as well. y = −f(x) leaves the x-intercepts unchanged at −3 and 7, since f(x) = 0 exactly where −f(x) = 0, which does not match; it also sends the y-intercept to (0, −21), a second mismatch. y = −f(−x) does send the x-intercepts to the right places, −7 and 3, but it sends the y-intercept to (0, −21) instead of (0, 21), so it fails the second clue. y = f(x) − 4 moves every point down 4, sending the y-intercept to (0, 17) instead of (0, 21), so it fails the y-axis clue. Test each option against BOTH clues — the pair of x-intercepts and the point on the y-axis — because more than one option gets only one of the two right.
- (d) 6n + 3 — Method: find the price per passenger, then find the booking fee that fits a booking for 1 passenger. Working: the cost rises by £6 for each extra passenger (15 − 9 = 6, 21 − 15 = 6, 27 − 21 = 6), so the cost has the form 6n + c. Substituting n = 1: 6(1) + c = 9, so c = 3. Answer: the cost in pounds is 6n + 3. 6n ignores the booking fee altogether. 6n + 9 uses the cost of one passenger, £9, as the fee without first subtracting the £6 per-passenger price. 9n + 6 swaps the two numbers, using the first cost as the price per passenger and the difference as the fee.
- (b) the first and the third — Method: the sign of a product depends only on the signs of the two numbers multiplied: like signs give a positive product and unlike signs a negative one, so look for the quadrants in which both coordinates carry the same sign. Working: in the first quadrant x and y are both positive, and positive times positive is positive; in the third quadrant both are negative, and negative times negative is positive as well; in the second quadrant x is negative while y is positive, and in the fourth x is positive while y is negative, so each of those gives a negative product. Answer: the first and the third. The distractors: 'the second and the fourth' comes from applying the rule for a NEGATIVE product, unlike signs, to a positive one; 'the first and the second' comes from testing only the y-coordinate and keeping the quadrants where the height is positive; 'the first and the fourth' comes from testing only the x-coordinate in the same way.
- (c) 37 — The first differences are 3, 5, 7, 9 — they increase by 2 each time (the second difference), so the next first difference is 11, giving 26+11=37. A candidate who repeats the last first difference (9) instead of increasing it would reach 26+9=35. A candidate who increases the difference by 4 instead of 2 would reach 26+13=39. A candidate who adds only the second difference (2) to the last term, instead of the next first difference, would reach 26+2=28.
- (d) 30° and 150° — The first solution is x = 30°, since sin 30° = 0.5. The graph of y = sin x is symmetrical about x = 90° between 0° and 180°, so the second solution is 180° − 30° = 150°. Adding 180° to the first solution instead of subtracting it from 180° gives 30° and 210°, but sin 210° = −0.5, not 0.5. Reflecting the first solution about x = 90° by adding 30° to 90° instead of subtracting from 180° gives 30° and 120°, but sin 120° = √3/2, not 0.5. Misremembering the standard value and using sin 45° = 0.5 instead of sin 30° = 0.5 gives 45° and 135°, but sin 45° = √2/2, not 0.5.
- (a) y = (4/3)x + 25/3 — The radius from (0, 0) to (−4, 3) has gradient 3 ÷ (−4) = −3/4. The tangent is perpendicular to the radius, so its gradient is the negative reciprocal, 4/3. Using y − y₁ = m(x − x₁) with the point (−4, 3): y − 3 = (4/3)(x + 4), so y = (4/3)x + 16/3 + 3 = (4/3)x + 25/3. Using the radius's own gradient, −3/4, instead of taking the perpendicular gradient, gives y − 3 = (−3/4)(x + 4), which simplifies to y = −(3/4)x once the −3 and +3 in the constant cancel out. Taking the reciprocal of the radius's gradient but keeping the wrong sign, using −4/3 instead of 4/3, gives y = −(4/3)x − 7/3. Correctly finding the gradient 4/3 and expanding the bracket, but forgetting to add the y-coordinate 3 at the end, gives y = (4/3)x + 16/3.
- (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (b) y = −(1/3)x + 2 — Method: two lines are perpendicular when the product of their gradients is −1, so the gradient of a line perpendicular to one of gradient m is the negative reciprocal, −1 divided by m. Working: reading m from y = 3x + 1 gives a gradient of 3, so the perpendicular gradient is −1 ÷ 3 = −1/3, and the line carrying that gradient is y = −(1/3)x + 2; the check 3 × (−1/3) = −1 confirms it. Answer: y = −(1/3)x + 2. The distractors: y = 3x − 4 comes from using an equal gradient, which is the test for parallel lines rather than perpendicular ones; y = (1/3)x + 2 comes from turning the gradient upside down but leaving out the change of sign, giving a product of 1 instead of −1; y = −3x + 2 comes from changing the sign of the gradient without turning it upside down, giving a product of −9.
Build your own mix at the worksheet builder.