Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (d) An equation, true for one value of x — 2x + 5 = 17 is only true when x = 6, so it is an equation. A candidate who ignores the equals sign and focuses only on the x terms and numbers present picks the expression option. A candidate who sees an equals sign and assumes it must relate two different quantities, as a formula does, picks that option, missing that there is only one quantity, x, involved here. A candidate who wrongly checks whether both sides look similar in structure rather than testing specific values picks the identity option, missing that the two sides are not equal for every value of x.
- (b) 4 — Method: form the equation 30 + 25h = 130, where h is the number of hours, then solve for h. Working: subtract the call-out fee from the total bill: 25h = 130 − 30 = 100. Divide by the hourly rate: h = 100 ÷ 25 = 4. Answer: 4 hours. 5.2 comes from dividing the whole bill by the hourly rate without subtracting the fixed fee first, 130 ÷ 25. 3.5 comes from swapping the fee and the rate, subtracting the rate from the bill and dividing by the fee, (130 − 25) ÷ 30. 6.4 comes from adding the call-out fee to the bill instead of subtracting it, before dividing by the rate, (130 + 30) ÷ 25.
- (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
- (a) 0 — the line does not intersect the circle — Substitute y = 2x + 7 into x² + y² = 4: x² + (2x + 7)² = 4, which expands to x² + 4x² + 28x + 49 = 4, giving 5x² + 28x + 45 = 0. The discriminant is b² − 4ac = 28² − 4 × 5 × 45. Since 28² = 784 and 4 × 5 × 45 = 900, the discriminant is 784 − 900 = −116. Since the discriminant is negative, the quadratic has no real solutions, so the line does not meet the circle at all: 0 intersection points. Distractor routes: "1 — the line is a tangent" confuses a negative discriminant with a zero one; a discriminant of exactly zero gives one point, a tangent, but −116 is not zero. "2 — the line crosses the circle at two points" assumes a positive discriminant without actually working it out. "It cannot be found without solving the quadratic" is the whole point the discriminant exists to avoid — its sign alone, without finding x, tells you the number of real solutions.
- (a) It touches the x-axis once, only at x = 4. — (x − 4)² is a square, so it equals zero only when x − 4 = 0, that is at x = 4 — the curve just touches the x-axis there rather than crossing it, since a square cannot be negative on either side to cross through. Saying it crosses at x = 4 and x = −4 wrongly introduces a plus-or-minus, as if taking a square root of x, rather than recognising the bracket is already squared and only zero once. Saying it never touches the x-axis forgets that a squared term CAN equal zero, even though it can never be negative. Saying it crosses at x = 2 and x = −2 confuses (x − 4)² with the different expression x² − 4.
- (b) k = 9 — Method: complete the square, because a squared bracket is equal to zero for exactly one value of x. Working: x² − 6x = (x − 3)² − 9, so the equation becomes (x − 3)² − 9 + k = 0, that is (x − 3)² = 9 − k; there is exactly one solution when 9 − k = 0, so k = 9 and the equation reads x² − 6x + 9 = 0 with the repeated solution x = 3. Answer: k = 9. The distractors: k = 3 comes from halving the 6 and not squaring the result; k = 36 comes from squaring the whole of 6 instead of half of it; k = −9 comes from solving 9 − k = 0 with the sign of k the wrong way round.
- (b) x = (y − 3)/5 — To make x the subject of y = 5x + 3, first subtract 3 from both sides to get y − 3 = 5x, then divide both sides by 5: x = (y − 3)/5. Writing x = (y + 3)/5 keeps the division correct but does not change the sign of the 3 when moving it across. Writing x = y/5 − 3 divides only the y term by 5 and leaves the 3 as a separate subtraction, instead of subtracting first and dividing the whole expression. Writing x = 5(y − 3) applies the correct order of subtracting 3 first, but then multiplies by 5 instead of dividing — the inverse of 5x is division, not multiplication. The correct rearrangement is x = (y − 3)/5.
- (d) 7 — Method: substitute both values, work out the two multiplications first, and only then subtract. Working: 3a = 3 × 5 = 15 and 2b = 2 × 4 = 8, so the expression becomes 15 − 8 = 7. Answer: 7. The distractors: 23 comes from adding the two products instead of subtracting, giving 15 + 8; −7 comes from subtracting the wrong way round and working out 8 − 15; 52 comes from working from left to right instead of following the order of operations, giving 3 × 5 = 15, then 15 − 2 = 13, then 13 × 4.
- (c) Statement (ii) — Statement (ii) opens with 'Since n(n + 1) is even', treating the very fact the proof is meant to establish as if it were already known — that is circular reasoning, assuming the conclusion to help derive itself. Statement (i) only names the two consecutive integers as n and n + 1; it makes no claim about whether their product is even, so it introduces nothing circular. Statement (iii) states the conclusion, and would be a valid final step if statement (ii) had reached 'one of n and n + 1 is even' by a genuine argument, such as considering the cases where n is even or odd separately. Saying the proof assumes nothing circular is wrong, because statement (ii)'s opening clause is exactly that assumption.
- (a) Positive x-direction, 90°; image is y = sin x. — Writing cos(x − 90°) as cos(x − a) with a = 90 shows this is a horizontal translation, y = f(x − a), which moves the graph 90° in the positive x-direction; the identity cos(x − 90°) = sin x confirms the image is y = sin x. Choosing the negative x-direction reverses the sign inside the bracket — subtracting inside the bracket always translates in the positive x-direction, not the negative one, so that statement is wrong on direction. Getting the direction right but conflating the subtraction inside the bracket with an extra reflection of the output flips the sign of the resulting graph, wrongly giving y = −sin x. Treating the subtraction as if it changed the output directly, rather than the input, wrongly calls this a vertical translation even while still correctly recalling that the image simplifies to y = sin x.
- (b) x ≤ −2 — Method: take the number term off both sides, then divide by the coefficient of x; the sign turns round only when you divide BY a negative number, and here you divide by 3. Working: subtracting 6 from both sides of 3x + 6 ≤ 0 gives 3x ≤ −6; dividing both sides by 3, which is positive, gives x ≤ −2. Answer: x ≤ −2. The distractors: x ≥ −2 comes from turning the sign round because the right-hand side has become negative, which is not the rule; it is the sign of the divisor that matters; x ≤ 2 comes from moving the 6 across without changing its sign, giving 3x ≤ 6; x ≤ −18 comes from multiplying both sides by 3 instead of dividing by it.
- (a) 2.55 — x₁ = 20 ÷ (2 + 5) = 20 ÷ 7 = 2.857142857. x₂ = 20 ÷ (2.857142857 + 5) = 20 ÷ 7.857142857 = 2.545454545, which rounds to 2.55. Reporting x₁ instead of x₂ gives 2.857142857, which rounds to 2.86. Dropping the +5 in the denominator, using xₙ₊₁ = 20 ÷ xₙ, gives x₁ = 20 ÷ 2 = 10 and x₂ = 20 ÷ 10 = 2, which is 2.00. A sign error in the denominator, using xₙ₊₁ = 20 ÷ (xₙ − 5), gives x₁ = 20 ÷ (2 − 5) = −6.666666667 and x₂ = 20 ÷ (−6.666666667 − 5) = −1.714285714, which rounds to −1.71.
- (a) k = 3 — Method: a solution of an equation makes both sides balance, so substitute it in and solve the equation in k that is left. Working: putting x = 3 gives 3² − (k + 1) × 3 + k = 0, that is 9 − 3k − 3 + k = 0, so 6 − 2k = 0 and k = 3; the equation is then x² − 4x + 3 = 0, whose solutions are 3 and 1. Answer: k = 3. The distractors: k = −3 comes from solving 6 − 2k = 0 as though it gave 2k = −6; k = 4 comes from expanding −3(k + 1) as −3k − 1, multiplying only the k by 3; k = 1.5 comes from working 3² as 3 × 2 = 6, which leaves 3 − 2k = 0.
- (b) (−2, 0) — Method: a graph meets the x-axis where the y-value is 0, so setting y = 0 turns the equation into a linear equation in x. Working: 0 = 3x + 6 gives 3x = −6, so x = (−6) ÷ 3 = −2 and the meeting point is (−2, 0). Answer: (−2, 0). The distractors: (2, 0) comes from solving 3x = −6 and then dropping the minus sign from the result; (0, 6) is the y-axis crossing, found by substituting x = 0 instead of y = 0; (6, 0) comes from reading the constant 6 straight off as the x-coordinate, without dividing by 3 and without changing its sign.
Build your own mix at the worksheet builder.