Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) L/5 − 3 — Each of the 5 equal pieces is L/5 metres long, and removing 3 metres from one piece gives L/5 − 3. Subtracting the 3 metres before dividing by 5, (L − 3)/5, divides the removed length between all 5 pieces instead of taking it from just one. Dividing only the 3 by 5 instead of dividing L by 5, L − 3/5, divides the wrong number. Writing 5/L − 3 inverts the fraction, swapping which number is the numerator.
- (a) 18 cm² — Method: substitute the width into the formula, applying the index to the letter before multiplying by the 2 in front of it. Working: x² = 3 × 3 = 9, and then A = 2 × 9 = 18, so the area is 18 cm². Answer: 18 cm². The distractors: 36 cm² comes from multiplying 2 by 3 first and squaring afterwards, giving (2 × 3)²; 12 cm² comes from doubling instead of squaring, so that x² is replaced by 2x and the calculation becomes 2 × 2 × 3; 6 cm² comes from working out 2 × 3 and never applying the index at all.
- (b) 4 — Adding the two equations: the y-terms, −2y and +2y, cancel, and the x-terms combine to 5x + 3x = 8x; the right-hand sides add to 16 + 16 = 32. This gives 8x = 32, so x = 4. A candidate who adds only one of the right-hand sides, instead of both, would get 8x = 16, so x = 2. A candidate who divides 32 by 4 instead of 8 would get x = 8. A candidate who subtracts the equations instead of adding them, getting 2x − 4y = 0, and then wrongly assumes y = 0, would get x = 0.
- (c) 4 — x² + 12x + 40 = (x + 6)² − 6² + 40 = (x + 6)² + 4, so a = 6 and b = 4. Since (x + 6)² can never be negative, y = (x + 6)² + 4 is smallest when the bracket is zero, so the minimum value of y is 4. Giving 40 instead reads off the ORIGINAL constant term and ignores the completing-the-square step entirely — wrong, because 40 is the value of y when x = 0, not the minimum value. Giving −6 instead answers with the x-coordinate of the turning point (where the bracket is zero) rather than the minimum y-value itself — wrong, because the question asks for the minimum value of y, not the value of x that produces it. Giving 36 instead stops after squaring half the coefficient, 6² = 36, without combining it with the 40 already in the expression — wrong, because the minimum value is 40 minus 36, not 36 on its own.
- (a) 12.5 — Method: the tangent at A is perpendicular to the radius OA, so find the gradient of OA, take its negative reciprocal, write the equation of the tangent and find where it meets the y-axis; the length of OB is then the distance of that crossing from the origin. Working: OA runs from (0, 0) to (−6, 8), so its gradient is 8 ÷ (−6), which cancels to −4/3; the negative reciprocal of −4/3 is 3/4. Substituting into y − 8 = 3/4(x + 6) gives y = 0.75x + 4.5 + 8, so y = 0.75x + 12.5 and B is (0, 12.5). The length OB is therefore 12.5. Answer: 12.5. The distractors: 10 is the radius of the circle, quoted on the assumption that the tangent always meets an axis one radius from the centre, which is only true when the radius itself lies along that axis; 8 is the y-coordinate of A, quoted by treating the tangent as horizontal so that it keeps the height of A; 3.5 comes from turning the gradient of OA upside down without changing its sign, which gives y = −0.75x + 3.5.
- (d) 300 m — For a constant speed, the speed-time graph is a horizontal line, and the area underneath is a rectangle: distance = speed × time = 15 × 20 = 300 m. Adding the two numbers instead of multiplying gives 35 m; dividing instead of multiplying gives 1.33 m; halving the product, as you would for a triangle, gives 7.5 m — but this section of the graph is a rectangle, not a triangle, so there is no halving to do.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (a) −3/4 — Method: the tangent at a point on a circle is perpendicular to the radius drawn to that point, so find the gradient of the radius and then take its negative reciprocal. Working: the radius joins (0, 0) to (6, 8), so its gradient is 8 ÷ 6, which cancels to 4/3. Turning 4/3 upside down gives 3/4, and changing the sign gives −3/4. Answer: the gradient of the tangent is −3/4. The distractors: 4/3 is the gradient of the radius itself, quoted without taking the perpendicular at all; −4/3 changes the sign but leaves the fraction the same way up, so the two gradients do not multiply to give −1; 3/4 turns the fraction upside down but keeps it positive, which is the other half of the same rule left undone.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (b) (n + 1)² − n² = 2n + 1 — (n + 1)² = n² + 2n + 1, so (n + 1)² − n² = n² + 2n + 1 − n² = 2n + 1, which is odd because it is one more than the even number 2n. Expanding (n + 1)² as n² + 1 uses the false rule (a + b)² = a² + b², and subtracting n² from that leaves just 1 — always expand (a + b)² as a² + 2ab + b². Writing n² + 2n + 1 expands correctly but never carries out the subtraction of n². Writing 2n forgets the constant term left after subtracting.
- (a) (4, 1) — y = −f(x) reflects the graph of y = f(x) in the x-axis: every point (x, y) maps to (x, −y). Applying this to (4, −1): the x-coordinate stays 4, and the y-coordinate −1 becomes its negative, 1. Leaving the y-coordinate unchanged skips the reflection entirely, giving (4, −1); reflecting the x-coordinate instead, or reflecting both, mixes this up with a reflection in the y-axis or a rotation, giving (−4, −1) or (−4, 1).
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
- (b) 5 cm³ — When P = 32, V = 480 ÷ 32 = 15 cm³. When P = 24, V = 480 ÷ 24 = 20 cm³. The increase in volume is 20 − 15 = 5 cm³. Giving only the second volume, 20 cm³, forgets to subtract the first volume. Giving only the first volume, 15 cm³, answers the wrong part of the question. Subtracting the two pressures instead of the two volumes, 32 − 24 = 8, mixes up which quantity the question asks for.
Build your own mix at the worksheet builder.