Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
- (a) y = −x³ + 5x — Reflecting a graph in the y-axis replaces every x in the equation with −x: y = (−x)³ − 5(−x) = −x³ + 5x. Writing y = −x³ − 5x comes from substituting −x into the x³ term only and leaving the −5x term as it was. Writing y = x³ + 5x comes from substituting −x into the −5x term only and leaving the x³ term as it was. Writing y = x³ − 5x is the original equation with no reflection applied at all — every term needs the substitution, not just one of them.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (a) 1 — a² − 2b = (−3)² − 2(4) = 9 − 8 = 1. A candidate who squares −3 but keeps the negative sign gets −9 − 8 = −17. A candidate who forgets to square a and substitutes it as −3 gets −3 − 8 = −11. A candidate who adds instead of subtracting 2b gets 9 + 8 = 17.
- (c) Week 16, £37,000 — y = f(x − 6) − 8000 combines a horizontal translation of 6 units RIGHT (subtracting 6 inside the brackets) with a vertical translation of £8000 DOWN (subtracting 8000 outside). Applying both to the maximum (10, 45000): 10 + 6 = 16, so the new maximum is in week 16. And 45000 − 8000 = 37000, so the maximum weekly profit is £37,000.
- (d) $y = x^2 - 2x - 3$ — Method: read the two x-intercepts (roots) from the graph, write the quadratic as the product of the corresponding factors, then expand. Working: the curve crosses the x-axis at x = −1 and x = 3, so the equation factorises as (x + 1)(x − 3), which expands to x² − 2x − 3. Answer: y = x² − 2x − 3. Distractor refutation: y = x² − x − 6 comes from misreading the left-hand crossing point as x = −2 instead of x = −1, giving factors (x + 2)(x − 3). y = x² − x − 2 comes from misreading the right-hand crossing point as x = 2 instead of x = 3, giving factors (x + 1)(x − 2). y = x² + 2x − 3 comes from writing the factors as (x − 1)(x + 3), swapping which root gets the plus sign and which gets the minus sign, giving the wrong sign on the x term.
- (b) y decreases towards zero but never reaches it — Method: as x gets larger, dividing 20 by a bigger number gives a smaller result, so y decreases; because 20/x can never be exactly zero for any positive x, the curve gets closer to zero without ever reaching it, so y decreases towards zero but never reaches it. Distractor origins: 'y increases towards a limit but never reaches it' has the relationship backwards, treating y as increasing when it is actually decreasing; 'y decreases at a steady rate and reaches zero' wrongly assumes the graph behaves like a straight line that eventually hits zero; 'y stays the same however large x becomes' wrongly assumes there is no change in y at all.
- (a) (4, −8), a minimum point — The transformation x → x + 1 inside f translates the graph 1 unit to the LEFT, so the x-coordinate becomes 5 − 1 = 4. The minus sign in front of f reflects the graph in the x-axis, so the y-coordinate becomes −8, and a reflection in the x-axis turns every maximum into a minimum, so (4, −8) is a minimum point. Writing '(4, −8), a maximum point' gets the coordinates right but forgets that a reflection in the x-axis swaps maximum and minimum points. Writing '(6, −8), a minimum point' comes from translating 1 unit to the RIGHT instead of the left — f(x + 1) always moves the graph in the negative x-direction. Writing '(4, 8), a minimum point' gets the x-coordinate and the type right, but forgets to actually negate the y-coordinate, even though it does correctly reclassify the point as a minimum.
- (b) 6x + 6 — Perimeter = 2[(2x + 5) + (x − 2)] = 2(3x + 3) = 6x + 6. A candidate who adds the length and width but forgets to double for the perimeter gets 3x + 3. A candidate who makes a sign error and adds 2 instead of subtracting it before doubling gets 2[(2x + 5) + (x + 2)] = 6x + 14. A candidate who multiplies the length and width instead of adding them, confusing the perimeter formula with the area formula, and then doubles that product, gets 2(2x + 5)(x − 2) = 4x² + 2x − 20.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.
- (c) x = 0, y = 3 and x = 3, y = 0 — Substitute y = 3 − x into x² + y² = 9: x² + (3 − x)² = 9. Expanding (3 − x)² = 9 − 6x + x² gives x² + 9 − 6x + x² = 9, which simplifies to 2x² − 6x = 0, or 2x(x − 3) = 0, so x = 0 or x = 3. Using y = 3 − x: x = 0 gives y = 3; x = 3 gives y = 0. Distractor routes: x = 0, y = 3 alone stops after the factor 2x = 0 and never checks the second factor, x − 3 = 0. x = 0, y = 3 and x = −3, y = 6 comes from factorising 2x² − 6x as 2x(x + 3), a sign error that gives a second root of −3 instead of 3. x = 0, y = 3 and x = 6, y = −3 comes from expanding (3 − x)² as 9 − 6x, dropping the x² term, which changes the quadratic to x² − 6x = 0 and its second root to 6.
- (b) n² + 2n + 3 — First differences: 5, 7, 9, 11. Second differences: 2, 2, 2, so a = 2 ÷ 2 = 1. Subtracting n² (1, 4, 9, 16, 25) from the terms (6, 11, 18, 27, 38) leaves 5, 7, 9, 11, 13, which is the linear expression 2n + 3. So the nth term is n² + 2n + 3. Using the second difference itself as a, without halving it, gives 2n² + 2n + 3. Finding a = 1 correctly but then dropping the linear part 2n, keeping only the constant, gives n² + 3. Finding a = 1 correctly but dropping the constant +3 gives n² + 2n.
- (d) −2 — y = f(x) − 6 is f(x) shifted down by 6, so every y-value on the graph decreases by 6. At x = 0, f(0) = 4, so the new y-value is 4 − 6 = −2. Adding 6 instead of subtracting gives 10; writing down the shift itself, −6, or leaving the original value 4 unchanged both skip the translation altogether.
Build your own mix at the worksheet builder.