Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) x = 3, y = 4 — −x² + 6x − 5 = −(x² − 6x) − 5 = −[(x − 3)² − 9] − 5 = −(x − 3)² + 9 − 5 = −(x − 3)² + 4. Because the coefficient of x² is negative, −(x − 3)² is at most zero, so this turning point is a maximum. Substituting x = 3 gives (x − 3)² = 0, so y = 4, confirming the maximum value 4 at x = 3: turning point (3, 4). Using 6 instead of half of 6 inside the bracket — forgetting to halve before completing the square — lands on turning point (6, 31), wrong, because only half the coefficient belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−3, 4) — wrong, because (x − 3)² is zero at x = 3, not x = −3. Computing 5 − 9 = −4 instead of 9 − 5 = 4 flips the sign of the constant, giving (3, −4) — wrong, since the constant must be evaluated as 9 minus 5, not 5 minus 9. Whenever the leading coefficient is negative, the turning point is a maximum, not a minimum — check by substituting back into the original equation.
- (b) 235 litres — The flow rate at t = 10 is the gradient of the tangent: change in volume ÷ change in time = (190 − 130) ÷ (12 − 8) = 60 ÷ 4 = 15 litres per minute. Treating this rate as roughly constant for a short interval, the volume 5 minutes after t = 10 is estimated as 160 + 5 × 15 = 235 litres. Using the tangent's own point spacing — 2 minutes, from t = 10 to t = 12 — instead of the 5 minutes actually asked for gives 160 + 2 × 15 = 190, which is just the volume already given at one of the tangent's own points, not an answer to the question asked. Multiplying the gradient by the time WITHOUT adding the starting volume, 5 × 15 = 75, forgets that a rate estimates a CHANGE, which must be added to the starting volume, not given as the answer on its own. Subtracting instead of adding, 160 − 5 × 15 = 85, extrapolates backward in time rather than forward.
- (a) 1.36 — Method: put the starting value into the right-hand side to get x₁, feed that value back in to get x₂, and round only once the second value has been found. Working: x₁ = 5 ÷ (1 + 2) = 5 ÷ 3 = 1.66666…; x₂ = 5 ÷ (1.66666… + 2) = 5 ÷ 3.66666… = 1.36363…. The digit in the third decimal place is 3, so x₂ = 1.36 correct to 2 decimal places. Answer: 1.36. The distractors: 1.67 is x₁, the value after a single use of the formula, given by a candidate who counts the starting value itself as x₁; 1.49 is x₃ = 1.48648…, one use of the formula too many; 1.37 comes from writing x₁ down as 1.66, truncating the display instead of keeping it in full, and then working out 5 ÷ 3.66 = 1.36612…, which rounds up to 1.37.
- (a) −1/3 — The gradient of L is 3, the coefficient of x in y = mx + c form. The gradient of a line perpendicular to a line of gradient m is the negative reciprocal, −1/m. So the perpendicular gradient is −1/3. Distractor routes: 3 gives the gradient of L itself, forgetting to change it at all — that is the gradient of a PARALLEL line. 1/3 takes the reciprocal of 3 but keeps the same sign, missing the negative sign a perpendicular gradient requires. −3 negates the gradient of L but does not take its reciprocal, giving the gradient of a line with the opposite slope rather than a perpendicular one.
- (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
- (b) n² + 2n + 3 — First differences: 5, 7, 9, 11. Second differences: 2, 2, 2, so a = 2 ÷ 2 = 1. Subtracting n² (1, 4, 9, 16, 25) from the terms (6, 11, 18, 27, 38) leaves 5, 7, 9, 11, 13, which is the linear expression 2n + 3. So the nth term is n² + 2n + 3. Using the second difference itself as a, without halving it, gives 2n² + 2n + 3. Finding a = 1 correctly but then dropping the linear part 2n, keeping only the constant, gives n² + 3. Finding a = 1 correctly but dropping the constant +3 gives n² + 2n.
- (b) One turning point. — Every quadratic graph, one with an x² term and no higher power of x, has exactly one turning point, since it is a single U-shaped or n-shaped curve. Saying two turning points describes a cubic graph, which can rise, turn, then turn again. Saying no turning points describes a straight line, which has none. Saying four turning points greatly overestimates how many times a simple quadratic curve changes direction — that would need a much higher power of x.
- (a) It has a solution between x = 2.6 and x = 2.7 — f(2.6) is negative and f(2.7) is positive, so the graph of f crosses the x-axis between x = 2.6 and x = 2.7, meaning the equation has a solution there. Choosing 'x = 2.6 is a solution' reads an end of the interval as the root itself, but f(2.6) = −1.424, which is not zero — the change of sign locates a root between the two values, it does not land on either of them. Choosing 'between x = −2.6 and x = −2.7' confuses the negative f-VALUE at 2.6 with a negative x-value. Choosing 'no root in this interval' misapplies the rule, which needs a CHANGE of sign — and a change of sign is exactly what these two values show.
- (a) It is 2(w + (w + 3)) = 4w + 6, not 2w + 3. — The perimeter of a rectangle is twice the width plus twice the length: 2 × w + 2 × (w + 3) = 2w + 2w + 6 = 4w + 6, so the gardener's 2w + 3 is wrong. Writing w + (w + 3) = 2w + 3 forgets to double the sides at all, only adding one width and one length once. Writing 4(w + 3) = 4w + 12 wrongly treats all four sides as equal to the length, as if the garden were a square. Writing 3w + 6 comes from doubling the length correctly but adding the width only once instead of doubling it too.
- (a) An identity, true for every value of x — Expanding the bracket on the left gives 3x + 12, which matches the right-hand side exactly, so the statement is true for every value of x — this makes it an identity. A candidate who reasons that any statement with an equals sign must be an equation picks that option, missing that an equation is only true for particular value(s) of x, not all of them. A candidate who confuses an identity with a formula, because both relate two expressions, picks the formula option — but a formula connects two different quantities, such as area and side length, not two equivalent forms of the same expression. A candidate who assumes it can be solved for a single value of x, as with a normal equation, picks that option, not realising there is no single solution here.
- (a) y = −2x + 3 — Method: find the step in the outputs for each step of 1 in the input — falling outputs mean a negative multiplier — then read off the output when the input is 0, because that is the number added on. Working: the outputs 5, 3, 1, −1 fall by 2 each time x rises by 1, so x is multiplied by −2; the output at x = 0 is 3, so 3 is added. Answer: y = −2x + 3, checked at x = 2 by −2 × 2 + 3 = −1. The distractors: y = 2x + 3 comes from taking the size of the step, 2, as the multiplier and ignoring the fact that the outputs are falling; y = −2x − 3 comes from using the correct multiplier but writing the number added on as −3 instead of the output 3 listed at x = 0; y = −x + 4 comes from taking the multiplier as −1, its size read from the step of 1 in the inputs instead of the step of 2 in the outputs and its sign from the fact that the outputs fall, and then fitting the number added on to the pair x = −1, y = 5.
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (d) (6, 6) — y = f(x − 4) + 1 combines two translations: the −4 inside the brackets moves the graph 4 units to the RIGHT, and the +1 outside the brackets moves it 1 unit UP. Applying both to (2, 5): add 4 to the x-coordinate 2, and add 1 to the y-coordinate 5, giving (6, 6). Moving left instead of right, as the minus sign inside the bracket might suggest, gives (−2, 6) or (−2, 4); forgetting the horizontal shift altogether and only applying the vertical one gives (2, 6).
- (a) 7 — Subtract 4 from both sides: 3h ≤ 21. Divide both sides by 3: h ≤ 7, so the greatest whole number of hours is 7. A candidate who forgets the £4 fixed fee solves 3h ≤ 25, getting h ≤ 8.33, rounded down to 8. A candidate who adds the £4 instead of subtracting it solves 3h ≤ 29, getting h ≤ 9.67, rounded down to 9. A candidate who reaches h ≤ 7 but wrongly assumes the boundary value cannot be used, thinking that spending the whole £25 is not allowed, answers 6.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
Build your own mix at the worksheet builder.