Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 3 — 2x² − 12x + 7 rewrites as 2(x² − 6x) + 7, then as 2[(x − 3)² − 9] + 7, which simplifies to 2(x − 3)² − 11, since −2 × 9 + 7 = −11. The bracket (x − 3)² is zero when x = 3, so the minimum occurs at x = 3. Treating the shift as b/a instead of b/(2a) — using 6 instead of 3 — gives x = 6, which is wrong. Reading the bracket's sign directly without negating it gives x = −3, wrong, because (x − 3)² is zero at x = 3, not x = −3. Reading off the coefficient of x itself, −12, and calling that the answer skips the completing-the-square process entirely and gives x = −12, which is wrong because b is not the turning point's x-coordinate under any circumstance. Always check: substituting your value of x should make the bracketed term equal to zero, and nothing else.
- (d) 3x² + 4x − 7 — Method: the minus sign in front of the second bracket changes the sign of every term inside it; then collect like terms. Working: removing the brackets gives 5x² + 3x − 2 − 2x² + x − 5; the squared terms give 5x² − 2x² = 3x², the x terms give 3x + x = 4x, and the number terms give −2 − 5 = −7. Answer: 3x² + 4x − 7. The distractors: 7x² + 2x + 3 comes from adding the two brackets instead of subtracting, giving 5x² + 2x², 3x − x and −2 + 5; 3x² + 2x + 3 comes from applying the minus sign to 2x² only, leaving −x and +5 unchanged so that 3x − x = 2x and −2 + 5 = 3; 3x² + 4x + 3 comes from changing the signs of the terms with letters but leaving +5 as it stood, so the number terms give −2 + 5 = 3.
- (d) 13 — Method: the numbers of matchsticks form a sequence with a term-to-term rule, so count the first square in full and then add the repeated amount once for every extra square. Working: one square uses 4 matchsticks; a row of 4 squares has 3 extra squares after the first, and each of those adds 3 matchsticks, giving 3 × 3 = 9 to add on to the 4. Answer: 13. The distractors: 16 comes from counting each square as a separate set of 4 matchsticks, 4 × 4, and ignoring the shared sides; 12 comes from using 3 matchsticks for all four squares, 3 × 4, and forgetting that the first square needs a fourth side; 10 comes from adding the 3 only twice, as though a row of four squares had two extra squares rather than three.
- (c) A reflection in the y-axis — Replacing x with −x reflects the graph in the y-axis: each point (x, y) maps to (−x, y). Reflecting the OUTPUT instead, y = −f(x), gives a reflection in the x-axis — that is a different function. Combining both reflections gives a rotation of 180° about the origin, and reflecting in the line y = x swaps the x- and y-values, which is what produces the inverse function, not f(−x). Check first which side of f the minus sign sits on.
- (a) 6x + 12 — A regular hexagon has 6 equal sides, so the perimeter is 6(x + 2) = 6x + 12. A candidate who multiplies only the x-term by 6 and forgets to multiply the 2 gets 6x + 2. A candidate who multiplies only the number term by 6 and forgets to multiply the x gets x + 12. A candidate who adds 6 and 2 to make a single coefficient of x instead of expanding the brackets gets 8x.
- (b) 5 — Set n² + 4n = 45, so n² + 4n − 45 = 0. This factorises as (n + 9)(n − 5) = 0, giving n = −9 or n = 5. Since a term number must be positive, n = 5. Taking the magnitude of the rejected negative solution, 9, instead of discarding it, gives 9. Dividing 45 by the coefficient of n and ignoring the n² term entirely, 45 ÷ 4 = 11.25, rounded to the nearest whole number, gives 11. Dropping the linear term 4n and solving n² = 45 instead, the nearest whole number to √45 = 6.708 is 7.
- (a) 4(x + 3) = 20 and 4x + 3 = 11 when x = 2, so the two expressions are not equivalent, because the bracket means the 3 must be added before multiplying by 4. — Substituting x = 2: 4(x + 3) = 4 × 5 = 20, and 4x + 3 = 8 + 3 = 11. The two values are different, and expanding 4(x + 3) algebraically gives 4x + 12, which can never equal 4x + 3 (that would require 12 = 3) — so the two expressions are never equivalent, for any value of x. The option claiming they become equal for a larger x is wrong: 4x + 12 = 4x + 3 has no solution at all. The option claiming they are equivalent because they share the terms 4x and 3 ignores that the bracket changes the constant term. The option that calculates 4(x + 3) as 11 ignores the bracket completely, applying the 4 only to the x term.
- (d) L/6 − 4 — Method: find the length of one equal piece first (divide by 6), then apply the later change (subtract 4) to that piece. Working: one piece is L/6 metres; removing 4 metres from it gives L/6 − 4. Answer: L/6 − 4. L/6 + 4 comes from adding the 4 metres instead of removing it. (L − 4)/6 comes from removing the 4 metres from the whole rope before cutting it into pieces, the wrong order. 4 − L/6 comes from subtracting the piece length from 4 instead of the other way round.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
- (c) y = 3x + 7 — Method: the gradient is the change in y divided by the change in x with both taken in the same order, and a point whose x-coordinate is 0 gives the constant straight away because it lies on the y-axis. Working: m = (7 − 1) ÷ (0 − (−2)) = 6 ÷ 2 = 3; the point (0, 7) lies on the y-axis, so c = 7 and the line is y = 3x + 7. Answer: y = 3x + 7. The distractors: y = −3x + 7 comes from taking the y-difference as 1 − 7 while taking the x-difference as 0 − (−2), so the two subtractions run in opposite orders; y = 3x + 1 comes from using the y-coordinate of (−2, 1) as the constant instead of the point that actually lies on the y-axis; y = (1/3)x + 7 comes from writing the gradient upside down as the change in x over the change in y, 2 ÷ 6.
- (a) y = (x − 2)² + 3 — Since (x − 2)² is never negative, (x − 2)² + 3 is always at least 3, so y can never equal 0 and the graph never crosses the x-axis. The other three graphs are all given in a factorised or difference-of-squares form that shows two real roots: y = (x − 2)(x + 3) crosses at x = 2 and x = −3; y = x² − 9 = (x − 3)(x + 3) crosses at x = 3 and x = −3; y = (x + 4)(x − 1) crosses at x = −4 and x = 1.
- (b) Translate +5 in x, then reflect in the x-axis. — Translating y = x² by 5 units in the positive x-direction gives y = (x − 5)². Reflecting this in the x-axis, which replaces y with −y, gives y = −(x − 5)², matching the target. Using a translation of −5 in x instead gives y = (x + 5)², and reflecting that in the x-axis gives y = −(x + 5)² — the sign inside the bracket is wrong. Reflecting in the y-axis first does nothing to y = x², since (−x)² = x², so translating afterwards only reaches y = (x − 5)² with no negative sign at all. Translating by 5 units in y instead of x gives y = x² + 5, and reflecting that in the x-axis gives y = −x² − 5, a different curve altogether — a vertical shift does not create the (x − 5)² term the target equation needs.
- (b) −23 — Expand two of the three brackets first: (x + 5)(x − 2) = x² + 3x − 10. Then multiply this by the remaining bracket: (2x − 1)(x² + 3x − 10) = 2x³ + 6x² − 20x − x² − 3x + 10, which simplifies to 2x³ + 5x² − 23x + 10, so the coefficient of x is −23. Writing −13 comes from a sign slip in the first expansion, combining 5x − 2x as −5x − 2x = −7x instead of +3x, which carries through to a wrong final coefficient. Writing −20 comes from forgetting to distribute the −1 across every term of x² + 3x − 10, dropping the −1 × 3x = −3x contribution. Writing 10 comes from reading off the constant term of the expansion instead of the coefficient of x.
- (a) P — A sequence is geometric when consecutive terms share a constant ratio. For P: 6 ÷ 3 = 2, 12 ÷ 6 = 2, 24 ÷ 12 = 2 — the ratio is constant at 2, so P is geometric. Q is the square numbers (1², 2², 3², 4²), a quadratic sequence: its ratios are 4, 2.25, 1.78, … — not constant. R looks geometric at first (2, 4, 8 doubles each time), but the pattern breaks: 8 to 14 is a ratio of 1.75, not 2. Its first differences are 2, 4, 6 — a constant second difference of 2 — so R is a quadratic sequence, not geometric. S has a constant DIFFERENCE of 5 (it is arithmetic), but its ratios (2, 1.5, 1.33, …) are not constant, so it is not geometric.
Build your own mix at the worksheet builder.