Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
- (b) £2.00 — Subtracting the second equation from the first eliminates the pastries: (3c + 2p) − (2c + 2p) = 9.60 − 7.60, so c = 2.00. A candidate who divides the first total by the number of coffees alone, ignoring the pastries, would get 9.60 ÷ 3 = £3.20. A candidate who finds the price of a pastry instead of a coffee — using c = 2.00 in 2c + 2p = 7.60 to get p = 1.80 — would answer £1.80. A candidate who reaches the correct difference of £2.00 but then mistakenly divides again or misplaces the decimal point would get £0.20.
- (b) 3.38 — r₁ = √(300 ÷ (π × 8)) = √11.9366 = 3.4550. r₂ = √(300 ÷ (π × 8.4550)) = √11.2947 = 3.3608. r₃ = √(300 ÷ (π × 8.3608)) = √11.4232 = 3.3798, which rounds to 3.38. Choosing 3.36 stops at r₂, one iteration too early. Choosing 4.82 leaves out the '+ 5' inside the bracket, dividing by π × rₙ instead of π × (rₙ + 5). Choosing 3.45 comes from using π ≈ 3 instead of the calculator's π key throughout.
- (a) 48 litres — Split the area into three sections. The rectangle (t = 0 to 2) has area 2 × 12 = 24. The first trapezium (t = 2 to 5, parallel sides 12 and 3, width 3) has area 1/2 × (12 + 3) × 3 = 22.5. The second trapezium (t = 5 to 6, parallel sides 3 and 0, width 1) has area 1/2 × (3 + 0) × 1 = 1.5. Total volume: 24 + 22.5 + 1.5 = 48 litres. Forgetting the rectangle and adding only the two trapeziums gives 22.5 + 1.5 = 24 litres. Using a single trapezium across the whole 6 minutes, with parallel sides 12 and 0, ignoring that the first 2 minutes are constant, gives 1/2 × (12 + 0) × 6 = 36 litres. Correctly finding the rectangle and the first trapezium but forgetting to halve the second trapezium, using (3 + 0) × 1 = 3 instead of 1.5, gives 24 + 22.5 + 3 = 49.5 litres.
- (c) 22 — p² means p × p. Substitute p = 2.5: p² = 6.25, so 4p² = 4 × 6.25 = 25, and 25 − 3 = 22. 97 comes from squaring 4p together instead of just p, (4 × 2.5)² − 3 = 10² − 3 = 97. 7 comes from using p instead of p², 4 × 2.5 − 3. 1 comes from squaring the 3 instead of the p, 4 × 2.5 − 3².
- (b) 1.6 m/s² — Acceleration is the change in velocity divided by the time taken: (11 − 3) ÷ 5 = 8 ÷ 5 = 1.6 m/s². Forgetting to subtract the initial velocity and dividing the final velocity by the time instead gives 11 ÷ 5 = 2.2 m/s². Inverting the fraction, dividing the time by the change in velocity, gives 5 ÷ 8 = 0.625 m/s². Finding the change in velocity, 8 m/s, but stopping without dividing by the time gives 8 m/s².
- (b) Translate +5 in x, then reflect in the x-axis. — Translating y = x² by 5 units in the positive x-direction gives y = (x − 5)². Reflecting this in the x-axis, which replaces y with −y, gives y = −(x − 5)², matching the target. Using a translation of −5 in x instead gives y = (x + 5)², and reflecting that in the x-axis gives y = −(x + 5)² — the sign inside the bracket is wrong. Reflecting in the y-axis first does nothing to y = x², since (−x)² = x², so translating afterwards only reaches y = (x − 5)² with no negative sign at all. Translating by 5 units in y instead of x gives y = x² + 5, and reflecting that in the x-axis gives y = −x² − 5, a different curve altogether — a vertical shift does not create the (x − 5)² term the target equation needs.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (a) x = −1.8 and x = 2.8 — Method: the solutions of x² − x − 2 = 3 are the x-coordinates of the points where the curve y = x² − x − 2 meets the line y = 3, read off the grid to 1 decimal place. Working: the curve meets the line y = 3 at approximately x = −1.8 and at x = 2.8. Answer: x ≈ −1.8 and x ≈ 2.8. Distractor refutation: x = −1.0 and x = 2.0 comes from reading where the curve crosses the x-axis (y = 0), solving x² − x − 2 = 0, instead of where it meets the line y = 3. x = −3.0 and x = 4.0 comes from taking the two ends of the drawn curve as the intersection points, instead of finding where it actually crosses the line y = 3. x = 1.8 and x = 2.8 comes from a sign slip on the left-hand intersection, reading it as positive instead of negative.
- (b) (2x + 14)/((x − 1)(x + 3)) — To subtract these fractions, write them over the common denominator (x − 1)(x + 3): the numerator becomes 4(x + 3) − 2(x − 1). Expanding gives 4x + 12 − 2x + 2, which simplifies to 2x + 14, so the answer is (2x + 14)/((x − 1)(x + 3)). Writing (2x + 11)/((x − 1)(x + 3)) comes from not distributing the minus sign fully across the second bracket, treating −2(x − 1) as −2x − 1 instead of −2x + 2. Writing 2/((x − 1)(x + 3)) comes from subtracting the two original numerators directly, 4 − 2 = 2, the same mistake as subtracting fractions without a common denominator. Writing (2x − 10)/((x − 1)(x + 3)) comes from swapping which numerator multiplies which bracket, forming 4(x − 1) − 2(x + 3) instead of 4(x + 3) − 2(x − 1).
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (c) x = 2y + 10 — Method: undo the operations done to x in reverse order — add 5, then multiply by 2. Working: y = x/2 − 5, so y + 5 = x/2, so x = 2(y + 5) = 2y + 10. Answer: x = 2y + 10. x = 2y + 5 comes from multiplying only the x/2 term by 2 and forgetting to multiply the 5 as well. x = 2y − 10 comes from a sign error, subtracting 5 instead of adding it before multiplying by 2. x = (y + 5)/2 comes from dividing by 2 instead of multiplying, the wrong operation to undo a division.
- (c) −4 — f(2) = 7, and y = f(x) + a passing through (2, 3) means f(2) + a = 3, so 7 + a = 3, giving a = 3 − 7 = −4. Writing a = 4 comes from subtracting the wrong way round, 7 − 3 instead of 3 − 7. Writing a = 10 comes from adding the two y-values instead of subtracting one from the other. Writing a = 3 comes from taking the new y-coordinate as the value of a directly, without accounting for the original y-value of 7 at all.
Build your own mix at the worksheet builder.