Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 3 and 4 — f(3) = 3³ − 3 × 3² − 4 = 27 − 27 − 4 = −4, and f(4) = 4³ − 3 × 4² − 4 = 64 − 48 − 4 = 12. Since f(3) is negative and f(4) is positive, there is a change of sign, so the solution lies between 3 and 4. A sign slip when expanding −3x², treating it as +3x², gives f(3) = 27 + 27 − 4 = 50, a positive value; taken with the correctly negative f(2) = 8 − 12 − 4 = −8, this reads as a change of sign between 2 and 3. The same sign slip applied at x = 1 gives f(1) = 1 + 3 − 4 = 0, read as the point the sign changes, against f(0) = 0 + 0 − 4 = −4, giving 0 and 1. Shifting the correctly found interval up by one integer, an indexing slip, reports the change as lying between 4 and 5 instead of 3 and 4.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (c) 8a + 2 — The perimeter of a rectangle is twice the length plus twice the width: P = 2(3a + 2) + 2(a − 1) = (6a + 4) + (2a − 2) = 8a + 2. Answering 5a adds the length and width once each but doubles only one of them, missing that a rectangle has two of each side. Answering 8a + 6 distributes the 2 into (a − 1) correctly as far as 2a, but then adds 2 instead of subtracting it, as though the bracket had been (a + 1). Answering 12a + 8 uses the length for all four sides instead of using the length twice and the width twice, as if the field were a square with side (3a + 2). The perimeter of the field is (8a + 2) metres.
- (d) 2.7 — The height after 3 years of 10% compound growth is 2 × 1.1³ = 2.662 m, which rounds to 2.7 m. A candidate who adds 10% of the original height (0.2 m) in each of the 3 years, instead of compounding on the new height each time, would reach 2 + 3×0.2 = 2.6 m. A candidate who compounds for only 2 years would reach 2 × 1.1² = 2.42 m, rounding to 2.4 m. A candidate who compounds for 4 years instead of 3 would reach 2 × 1.1⁴ = 2.928 m, rounding to 2.9 m.
- (d) x > 4 — Method: collect the x terms on one side and the numbers on the other, then divide by the coefficient of x; dividing by a positive number leaves the sign as it is. Working: subtracting 2x from both sides of 4x + 1 > 2x + 9 gives 2x + 1 > 9; subtracting 1 from both sides gives 2x > 8; dividing both sides by 2 gives x > 4. Answer: x > 4. The distractors: x < 4 comes from turning the sign round while dividing by 2; x > 5 comes from adding the 1 to the 9 instead of subtracting it, giving 2x > 10; x < 5 comes from making both of those mistakes together.
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (a) 130 — Method: substitute the total bill into the formula, then subtract the fixed charge and divide by the cost per text message. Working: 24.50 = 18 + 0.05t, so 0.05t = 24.50 − 18 = 6.50, t = 6.50 ÷ 0.05 = 130. Answer: 130 extra text messages. 490 comes from dividing the whole bill by 0.05 without first subtracting the £18 fixed charge: 24.50 ÷ 0.05 = 490. 13 comes from dividing the £6.50 by 0.5 instead of 0.05, moving the decimal point one place too far: 6.50 ÷ 0.5 = 13. 65 comes from dividing the £6.50 by 0.1 instead of 0.05.
- (b) f(1) = −3 and f(2) = 3 — f(1) = 1³ − 1 − 3 = 1 − 1 − 3 = −3. f(2) = 2³ − 2 − 3 = 8 − 2 − 3 = 3. Since f(1) is negative and f(2) is positive, there is a change of sign, so a solution lies between x = 1 and x = 2. Dropping the −x term entirely gives f(1) = 1 − 3 = −2 and f(2) = 8 − 3 = 5. Using x² instead of x³ throughout gives f(1) = 1 − 1 − 3 = −3, which happens to coincide with the correct value at x = 1, but f(2) = 4 − 2 − 3 = −1, which does not show a change of sign at all. Working out −f(x) instead of f(x), a sign-flip error, gives f(1) = 3 and f(2) = −3, the correct sizes but with both signs reversed.
- (c) 27 days — The campaign starts at d = 3 and ends at d = 30, so it runs for 30 − 3 = 27 days. Getting 33 days comes from adding the two values, 3 + 30 = 33, instead of subtracting them. Getting 30 days uses only the end day and ignores that the campaign did not start at day 0. Getting 24 days comes from subtracting the start day twice, 30 − 3 − 3 = 24, instead of once.
- (d) −2 — y = f(x) − 6 is f(x) shifted down by 6, so every y-value on the graph decreases by 6. At x = 0, f(0) = 4, so the new y-value is 4 − 6 = −2. Adding 6 instead of subtracting gives 10; writing down the shift itself, −6, or leaving the original value 4 unchanged both skip the translation altogether.
- (c) y = 3x + 2 — Method: divide the change in the outputs by the change in the inputs to find the multiplier, then put one pair of values into the rule to find the number added on. Working: the output rises by 11 − 5 = 6 while the input rises by 3 − 1 = 2, so the multiplier is 6 ÷ 2 = 3; with an input of 1, 3 × 1 = 3 and the output is 5, so 2 is added. Answer: y = 3x + 2, checked against the second pair by 3 × 3 + 2 = 11. The distractors: y = 3x − 2 comes from finding the multiplier 3 and then subtracting the 2 instead of adding it; y = 2x + 3 comes from swapping the multiplier and the number added on; y = x + 4 comes from assuming the input is multiplied by 1 and using 5 − 1 = 4 as the number added on.
- (a) (4, 1) — y = −f(x) reflects the graph of y = f(x) in the x-axis: every point (x, y) maps to (x, −y). Applying this to (4, −1): the x-coordinate stays 4, and the y-coordinate −1 becomes its negative, 1. Leaving the y-coordinate unchanged skips the reflection entirely, giving (4, −1); reflecting the x-coordinate instead, or reflecting both, mixes this up with a reflection in the y-axis or a rotation, giving (−4, −1) or (−4, 1).
- (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
Build your own mix at the worksheet builder.