Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) £9.70 — F = 2.50 + 1.20 × 6 = 2.50 + 7.20 = £9.70. £7.20 comes from forgetting to add the £2.50 fixed charge. £10.20 comes from adding the 2.50 to the number of miles before multiplying by 1.20, 1.20 × (6 + 2.50). £22.20 comes from adding the fixed charge and the rate together first and then multiplying by the miles, (2.50 + 1.20) × 6.
- (a) (0, 7) and (0, −7) — A tangent is horizontal where the radius to that point is vertical, i.e. where the point lies on the y-axis. On x² + y² = 49, setting x = 0 gives y² = 49, so y = 7 or y = −7. The points are (0, 7) and (0, −7). (7, 0) and (−7, 0) comes from swapping the condition — these are the points where the tangent is VERTICAL, not horizontal (the radius there is horizontal). (0, 7) only comes from finding one valid point but forgetting that y² = 49 also gives the negative root, y = −7. (7, 0) only combines both mistakes: the wrong axis, and only one of the two roots.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (b) 4.39 — x₁ = ∛(150 − 3 × 4²) = ∛(150 − 48) = ∛102 = 4.672 (unrounded). x₂ = ∛(150 − 3 × 4.672²) = ∛(150 − 65.49) = ∛84.51 = 4.39 (2 d.p.). Choosing 4.67 stops after only one iteration, giving x₁ instead of x₂. Choosing 84.51 finds the value inside the cube root for x₂ but never takes the cube root. Choosing 6.32 comes from adding 3xₙ² instead of subtracting it inside the root, which does not match the given formula.
- (d) 5n + 4 — Method: find the common difference, then find the constant that fits the first term. Working: 14 − 9 = 5, 19 − 14 = 5, 24 − 19 = 5, so the terms increase by 5 each time and the nth term has the form 5n + c. Substituting n = 1: 5(1) + c = 9, so c = 4. Answer: the nth term is 5n + 4. The value 5n comes from leaving out the constant. The value 5n + 9 comes from using the first term as the constant directly, without subtracting the common difference first. The value 9n + 5 comes from swapping the roles of the first term and the common difference — using the first term, 9, as the coefficient of n and the difference, 5, as the constant.
- (a) 19 — Each time x increases by 1, y increases by 3 (4, 7, 10, 13 — a constant difference of 3). So at x = 4, y = 13 + 3 = 16, and at x = 5, y = 16 + 3 = 19. A candidate who stops one step early, giving the value for x = 4 instead of x = 5, answers 16. A candidate who overcounts and adds three steps of 3 instead of two from x = 3 gets 13 + 9 = 22. A candidate who mistakes the y-intercept (4) for the common difference and adds 4 twice from x = 3 gets 13 + 8 = 21.
- (d) It diverges, growing rapidly without limit. — x₁ = 2³ − 2 = 8 − 2 = 6. x₂ = 6³ − 2 = 216 − 2 = 214. x₃ = 214³ − 2 = 9800344 − 2 = 9800342. The values 6, 214, 9800342, … grow far larger at every step, so the sequence diverges rather than settling anywhere. Checking whether the sequence converges to a fixed value near 2 fails, since the terms grow enormously instead of levelling off. Checking for a repeating pair of values also fails, since 6, 214 and 9800342 are all different, with no sign of a return to 6. x₀ = 2 is a fixed point only if 2³ − 2 = 2, but 2³ − 2 = 6, not 2, so the sequence does not stay constant.
- (d) 2x² − 4x + 3 — fg(x) means f(g(x)): substitute g(x) into f in place of x. g(x) = x − 1, so fg(x) = f(x − 1) = 2(x − 1)² + 1. Expanding (x − 1)² = x² − 2x + 1, so fg(x) = 2(x² − 2x + 1) + 1 = 2x² − 4x + 2 + 1 = 2x² − 4x + 3. Writing 2x² comes from working out gf(x) instead — g(f(x)) = f(x) − 1 = (2x² + 1) − 1 = 2x², which applies the functions in the wrong order. Writing 2x² − 1 comes from expanding (x − 1)² as x² − 1, dropping the middle term, so f(x − 1) becomes 2(x² − 1) + 1 = 2x² − 2 + 1 = 2x² − 1. Writing 2x² − 4x + 2 comes from expanding correctly but forgetting the final + 1 from f, stopping at 2(x² − 2x + 1) = 2x² − 4x + 2.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (c) 3 — Method: a point that lies on a graph makes its equation true, so substituting the coordinates into y = mx + 6 leaves an equation in m alone. Working: substituting x = −2 and y = 0 gives 0 = m × (−2) + 6, which rearranges to −2m = −6, so m = (−6) ÷ (−2) = 3. Answer: 3. The distractors: −3 comes from dividing −6 by 2 and keeping the minus sign, overlooking that the divisor is negative too, so the two signs cancel; −2 comes from writing down the x-coordinate of the given point in place of the gradient; 6 comes from reading the constant in y = mx + 6 as the gradient, confusing m with c.
- (d) 68, and it is a formula — Substituting C = 20 gives F = 1.8 × 20 + 32 = 36 + 32 = 68. The statement F = 1.8C + 32 is a formula because it expresses a general relationship between F and C that holds for any value of C, not just C = 20. A candidate who gets the correct value but calls it an equation is confusing "has an equals sign" with "is an equation" — an equation is only true for particular value(s) of the unknown, whereas this relationship is used to calculate rather than to be solved. A candidate who forgets to multiply C by 1.8 and just adds 32 to 20 gets 52. A candidate who multiplies correctly but forgets to add 32 gets 36.
- (a) (6, 8) — Method: a point lies on the circle x² + y² = 100 exactly when the squares of its two coordinates add to 100, so square both coordinates of each point and add them. Working: for (6, 8), 6² + 8² = 36 + 64 = 100, which matches the right-hand side of the equation. Answer: (6, 8) lies on the circle. The distractors: (3, 4) is the 3, 4, 5 right-angled triangle recalled but never scaled up to a radius of 10, and 3² + 4² = 25, so it lies on the far smaller circle x² + y² = 25; (5, 5) has coordinates adding to 10, which compares the sum of the coordinates with the radius instead of the sum of their squares with r², and 5² + 5² = 50; (10, 10) takes each coordinate separately to equal the radius, and 10² + 10² = 200, which is twice too big.
- (c) 7 — To reverse the rule, subtract the constant then divide by the coefficient: 30−2=28, then 28÷4=7, so n=7. A candidate who adds the constant instead of subtracting it, a sign error when rearranging, would compute (30+2)÷4=32÷4=8. A candidate who subtracts the constant correctly but then forgets to divide by the coefficient would stop at 30−2=28. A candidate who treats 4n+2 as a single term 6n, adding the coefficient and constant together, would compute 30÷6=5.
Build your own mix at the worksheet builder.