Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) (0, 7) and (0, −7) — A tangent is horizontal where the radius to that point is vertical, i.e. where the point lies on the y-axis. On x² + y² = 49, setting x = 0 gives y² = 49, so y = 7 or y = −7. The points are (0, 7) and (0, −7). (7, 0) and (−7, 0) comes from swapping the condition — these are the points where the tangent is VERTICAL, not horizontal (the radius there is horizontal). (0, 7) only comes from finding one valid point but forgetting that y² = 49 also gives the negative root, y = −7. (7, 0) only combines both mistakes: the wrong axis, and only one of the two roots.
- (d) P lies outside the circle — The squared distance from the origin to P is 8² + 9² = 64 + 81 = 145, which is greater than 100, so P lies outside the circle. Choosing 'P lies inside the circle' comes from adding the coordinates directly (8 + 9 = 17) instead of squaring and adding them, and comparing 17 with 100. Choosing 'P lies on the circle' comes from squaring 9 incorrectly as 36 (as if it were 6²) instead of 81, giving 64 + 36 = 100, equal to the right-hand side. Choosing 'Cannot be determined' wrongly assumes the equation of the line itself is needed, when the radius and the distance from the origin to P are already enough.
- (a) (3, 7) — y = f(x) + 5 is a vertical translation of y = f(x) by 5 units up — the translation vector is (0, 5) — so only the y-coordinate of any point changes. Turning point (3, 2) → (3, 2 + 5) = (3, 7). Adding the 5 to the x-coordinate, or treating it as a horizontal shift like y = f(x + 5), moves the wrong coordinate — check first whether the number sits inside or outside the brackets.
- (a) 4 — The gradient of a straight line through two points is the change in y divided by the change in x. Change in y = 21 − 5 = 16. Change in x = 6 − 2 = 4. Gradient = 16 ÷ 4 = 4. Dividing x by y instead of y by x gives 0.25; forgetting to divide by the change in x at all leaves 16; dividing by only one of the two x-coordinates, 16 ÷ 2 = 8, uses the wrong denominator.
- (d) 23 — Method: let the smallest integer be n, so the three consecutive integers are n, n + 1 and n + 2. Form the equation n + (n + 1) + (n + 2) = 72. Working: simplify the left side: 3n + 3 = 72, so 3n = 69, giving n = 23. Answer: 23. 24 comes from dividing 72 by 3 directly, 72 ÷ 3 = 24, which finds the middle integer rather than realising the three numbers differ. 25 comes from correctly finding n = 23 but reading off the largest integer, n + 2, instead of the smallest as asked. 21 comes from dividing first and subtracting after, (72 ÷ 3) − 3, instead of subtracting 3 before dividing by 3.
- (c) 2 < x < 3 — Factorise x² − 5x + 6 = (x − 2)(x − 3), giving roots x = 2 and x = 3. Since the coefficient of x² is positive, the graph is a U-shape that dips below the x-axis between its roots. So x² − 5x + 6 < 0 for 2 < x < 3. Distractor routes: x < 2 or x > 3 takes the region OUTSIDE the roots, where the graph is above the x-axis, the opposite of what is wanted. 2 ≤ x ≤ 3 uses ≤ instead of the strict < the question asks for, wrongly including the roots themselves, where the expression equals zero, not less than zero. −3 < x < −2 comes from factorising as (x + 2)(x + 3), reversing the sign of both roots.
- (d) x = −4, y = −19 — x² + 8x − 3 = (x + 4)² − 4² − 3 = (x + 4)² − 19. Substituting x = −4: (−4)² = 16, 8 × (−4) = −32, so 16 − 32 − 3 = −19, confirming the minimum value −19 at x = −4: turning point (−4, −19). Using 8 instead of half of it inside the bracket gives (x + 8)² − 67, turning point (−8, −67) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (4, −19) — wrong, because (x + 4)² is zero at x = −4, not x = 4. Computing 16 + 3 = 19 instead of −3 − 16 = −19 flips the sign of the constant, giving (−4, 19) — wrong, since the completed square's constant must be evaluated as −3 minus 16, not 16 plus 3. Check by substitution whenever the sign of a constant feels uncertain.
- (c) 4 years — The yearly multiplier is 1 − 0.12 = 0.88. After 1 year: 2400 × 0.88 = 2112. After 2 years: 2112 × 0.88 = 1858.56. After 3 years: 1858.56 × 0.88 = 1635.5328. After 4 years: 1635.5328 × 0.88 = 1439.27 (2 d.p.), which is the first value below £1,500 — so it takes 4 complete years. Stopping after 3 years, where the value is still £1,635.53, above £1,500, gives 3 years — wrong, because the threshold has not been crossed yet at that point. Continuing for one year longer than needed gives 5 years — wrong, because the value has already fallen below £1,500 by year 4, so year 5 overcounts. Multiplying by the percentage itself instead of by the multiplier — using 0.12 in place of 0.88 — gives 2400 × 0.12 = £288 after a single year, apparently below £1,500 straight away, so 1 year — wrong, because 12% is the part lost each year, and the part left is 88%, so the multiplier is 0.88.
- (b) x = (y − 3)/5 — To make x the subject of y = 5x + 3, first subtract 3 from both sides to get y − 3 = 5x, then divide both sides by 5: x = (y − 3)/5. Writing x = (y + 3)/5 keeps the division correct but does not change the sign of the 3 when moving it across. Writing x = y/5 − 3 divides only the y term by 5 and leaves the 3 as a separate subtraction, instead of subtracting first and dividing the whole expression. Writing x = 5(y − 3) applies the correct order of subtracting 3 first, but then multiplies by 5 instead of dividing — the inverse of 5x is division, not multiplication. The correct rearrangement is x = (y − 3)/5.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
- (c) x = 3 or x = 1/2 — Method: factorise into two brackets whose x terms multiply to 2x² and whose numbers multiply to 3, checking that they produce the middle term −7x, then set each bracket equal to zero. Working: (2x − 1)(x − 3) expands to 2x² − 6x − x + 3 = 2x² − 7x + 3, so (2x − 1)(x − 3) = 0; then 2x − 1 = 0 gives x = 1/2 and x − 3 = 0 gives x = 3. Answer: x = 3 or x = 1/2. The distractors: x = 3/2 or x = 1 comes from factorising as (2x − 3)(x − 1), whose middle term is −5x and not −7x; x = −3 or x = −1/2 comes from reading the roots straight out of (2x − 1)(x − 3) without changing the signs; x = 6 or x = 1 comes from using the quadratic formula with the denominator written as a instead of 2a, dividing 7 ± 5 by 2.
- (a) (n − 5)/2 — Method: do the subtraction first, keep it together as a single bracket, then divide that whole bracket by 2. Working: 'subtract 5 from n' is (n − 5); 'divide the result by 2' means the whole bracket goes over 2, giving (n − 5)/2. Answer: (n − 5)/2. n/2 − 5 comes from dividing n by 2 first and only then subtracting 5, the wrong order. 2(n − 5) comes from multiplying by 2 instead of dividing. (5 − n)/2 comes from subtracting n from 5 instead of subtracting 5 from n, the wrong way round.
- (b) (x + 2)/3 — Start with y = 3x − 2 and swap x and y: x = 3y − 2. Add 2 to both sides: x + 2 = 3y. Divide both sides by 3: y = (x + 2)/3, so f⁻¹(x) = (x + 2)/3. Writing x/3 + 2 comes from dividing only the 3y term by 3 and leaving the +2 outside the division — the 2 must be added before you divide, not after. Writing (x − 2)/3 comes from keeping the subtraction sign instead of flipping it to addition when the −2 is moved across the equals sign. Writing 3x + 2 comes from swapping x and y but never actually solving for y — just changing the sign of the constant term.
- (b) The total volume of water, in litres, that has flowed in. — On a rate-time graph, the y-axis is in litres per minute and the x-axis is in minutes; multiplying a rate by a time gives litres per minute × minutes = litres, a total volume. So the area under the graph represents the total volume of water that has flowed in. Thinking the area itself represents the rate, rather than what the rate accumulates to, gives the wrong claim about the average rate of flow. Confusing the area with the gradient of the graph — which measures how the rate is changing — gives the wrong claim about litres per minute squared. Ignoring the flow-rate axis and focusing only on the time axis gives the wrong claim that the area is simply the total time.
- (c) Wrong — the product is −4/25, not −1. — The student's rearrangement is correct: 5y = −2x + 15 gives y = −(2/5)x + 3, gradient −2/5. But the test for perpendicularity is that the product of the two gradients equals exactly −1, not merely that it is negative. Here 2/5 × (−2/5) = −4/25, which is not −1, so the lines are NOT perpendicular. Distractor routes: "a negative product always means perpendicular" states a rule that does not exist — many pairs of lines have a negative gradient product without being perpendicular, as this pair shows. "The rearrangement is incorrect" wrongly blames a correct step; 5y = −2x + 15 does rearrange to y = −(2/5)x + 3. "2/5 and −2/5 are negatives of each other" notices a true but irrelevant fact — being negatives of each other is not the perpendicularity condition; an exact product of −1 is.
Build your own mix at the worksheet builder.