Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 5.8 — The horizontal distance is 3 and the vertical distance is 5, so using Pythagoras' theorem the distance is √(3² + 5²) = √34 = 5.8 (1 d.p.). A candidate who adds the two differences instead of using Pythagoras gets 3 + 5 = 8.0. A candidate who works out 3² + 5² = 34 but forgets to take the square root gets 34.0. A candidate who subtracts the squares instead of adding them gets √(5² − 3²) = √16 = 4.0.
- (a) 33 — Substitute n=4 into 2n²+1: 2×4²+1=2×16+1=33. A candidate who computes n² as 2×n instead of n×n would compute 2×(2×4)+1=2×8+1=17. A candidate who correctly finds 2×16 but forgets to add the constant 1 would stop at 32. A candidate who squares the whole term 2n, rather than squaring n before multiplying by 2, would compute (2×4)²+1=64+1=65.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (b) 12.7 m/s — Find the total distance from the area under the graph, then divide by the total time. Break the graph into its four straight sections: a triangle from (0, 0) to (5, 20), where 5 × 20 = 100 gives an area of 50 m when halved; a rectangle from (5, 20) to (12, 20), area 7 × 20 = 140 m; a trapezium from (12, 20) to (16, 4), where (20 + 4) × 4 = 96 gives an area of 48 m when halved; and a rectangle from (16, 4) to (20, 4), area 4 × 4 = 16 m — a total distance of 50 + 140 + 48 + 16 = 254 m. Dividing by the 20 seconds gives an average speed of 254 ÷ 20 = 12.7 m/s. Writing 15.1 m/s comes from forgetting to halve the trapezium area for the third section, using 96 instead of 48: a total of 302 m, and 302 ÷ 20 = 15.1 m/s. Writing 11.9 m/s comes from leaving out the final section, from (16, 4) to (20, 4), entirely: a total of 238 m, and 238 ÷ 20 = 11.9 m/s. Writing 12.1 m/s comes from dividing the correct total distance by 21 instead of 20 — a fencepost slip, counting the whole seconds from t = 0 to t = 20 inclusive as 21 seconds of travel rather than reading the journey as a duration of 20 seconds: 254 ÷ 21 = 12.1 m/s (1 d.p.).
- (d) h = 2A / (a + b) — Method: undo the multiplication by 1/2 by multiplying both sides by 2, then undo the multiplication by (a + b) by dividing both sides by it. Working: A = (a + b)h / 2, so multiplying both sides by 2 gives 2A = (a + b)h, then dividing both sides by (a + b) gives h = 2A / (a + b). The value h = A / (a + b) comes from forgetting to multiply by 2 to clear the 1/2 first. The value h = 2A / a + b comes from dividing only by a and leaving b outside the fraction, instead of dividing by the whole bracket (a + b). The value h = (a + b) / (2A) comes from inverting the fraction.
- (d) 5 — Method: rearrange the formula to make m the subject, then substitute F = 15.50. Working: F = 3 + 2.5m, so subtracting 3 from both sides gives F − 3 = 2.5m, then dividing by 2.5 gives m = (F − 3) / 2.5. Substituting F = 15.50: m = (15.50 − 3) / 2.5 = 12.50 / 2.5 = 5. The value 6.2 comes from dividing 15.50 by 2.5 without subtracting the fixed £3 first. The value 3.2 comes from dividing first and subtracting afterwards, in the wrong order: (15.50 / 2.5) − 3 = 3.2. The value 7.4 comes from adding £3 instead of subtracting it before dividing: (15.50 + 3) / 2.5 = 7.4.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
- (d) x = 0 or x = 6 — Method: factorise by taking out the common factor x: x(x − 6) = 0, so x = 0 or x − 6 = 0, giving x = 0 or x = 6. Distractor origins: x = 6 comes from dividing both sides by x, which loses the solution x = 0; x = 0 stops after finding only one factor; x = 3 comes from halving the coefficient of x instead of factorising.
- (b) 4x − 4 = 20 — Method: subtract 2x from both sides of the equation, and simplify each side separately. Working: left side: 6x − 4 − 2x = 4x − 4. Right side: 2x + 20 − 2x = 20. Answer: 4x − 4 = 20. 4x = 20 drops the −4 from the left side, as though subtracting 2x also removes the constant term. 8x − 4 = 20 comes from moving the 2x across to the left without changing its sign: it is taken off the right side correctly, leaving 20, but added to the left side instead of subtracted, giving 6x + 2x = 8x. 4x − 4 = 2x + 20 comes from subtracting 2x from the left-hand side only and leaving the right-hand side unchanged; whatever is done to one side must be done to the other.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (b) 8 — Method: a circle centred on the origin has equation x² + y² = r², where r is the radius, so the number on the right-hand side is the square of the radius and not the radius itself. Working: comparing x² + y² = 64 with x² + y² = r² gives r² = 64, so r = √64 = 8. Answer: the radius is 8. The distractors: 64 is r² read straight off the equation as though the right-hand side were the radius, which is the commonest error on this form; 32 comes from halving 64, treating the right-hand side as a diameter that has to be halved; 16 is the diameter, 2 × 8, quoted in place of the radius.
- (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
- (b) £47, and T=15+8h is a formula (relates T and h). — The charge is £15 fixed plus £8 for each hour: T=15+8h, so for h=4, T=15+8×4=15+32=47. Because T=15+8h relates two different quantities, the total charge T and the number of hours h, it is a formula, not an equation — an equation is solved for one particular value of an unknown, but this relationship holds for every value of h a job might last. A candidate who forgets to include the fixed £15 fee would compute only 8×4=32. A candidate who adds the three numbers in the formula together instead of multiplying the hourly rate by the number of hours would compute 15+8+4=27. A candidate who correctly finds the charge but mistakes the formula for an equation, treating it as something to be solved for one specific value of h rather than a general relationship between T and h, would pick the correct charge with the wrong classification.
- (d) 6 — Method: rearrange the formula to make d the subject, then substitute C = 133. Working: C = 25 + 18d, so subtracting 25 from both sides gives C − 25 = 18d, then dividing by 18 gives d = (C − 25) / 18. Substituting C = 133: d = (133 − 25) / 18 = 108 / 18 = 6. The value 7.4 comes from dividing 133 by 18 without subtracting the fixed £25 first (133 / 18 ≈ 7.4). The value 4.6 comes from pairing the numbers the wrong way round, working out (133 − 18) / 25 = 4.6. The value 90 comes from subtracting both 25 and 18 from 133 instead of dividing by 18.
- (c) Second and fourth — If x + y = 0 then y = −x, so x and y always have opposite signs, one positive and one negative. A point with a negative x and a positive y lies in the second quadrant, and a point with a positive x and a negative y lies in the fourth quadrant, so the point lies in the second or the fourth. A candidate who reads x + y = 0 as meaning x and y have the same sign picks First and third, which is where x × y is positive, not where x + y = 0. A candidate who decides that y must be the positive coordinate picks the two quadrants above the x-axis, First and second. A candidate who decides that y must be the negative coordinate picks the two quadrants below the x-axis, Third and fourth.
Build your own mix at the worksheet builder.