Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) Yes: the 8th term is 50 − 8 × 7 = −6, which is negative. — Method: find the 8th term by subtracting 8 a total of 7 times from the first term, since the 1st term itself needs 0 subtractions. Working: 8th term = 50 − 8 × 7 = 50 − 56 = −6, which is negative, so Priya is correct. Answer: Yes, the 8th term is 50 − 8 × 7 = −6, which is negative. The "50 − 8 × 6 = 2" option subtracts 8 only six times instead of seven, an off-by-one error in counting the steps. The "50 − 8 × 8 = −14" option subtracts 8 eight times instead of seven, the opposite off-by-one error. The claim that repeated subtraction "can never go negative" ignores that subtracting enough times from any starting value eventually gives a negative result.
- (b) 10 km — Method: find the constant speed from the graph (distance ÷ time for any point on the line), then multiply that speed by 20 minutes. Working: the line passes through (4 minutes, 2 km), so the speed is 2 ÷ 4 = 0.5 km per minute; in 20 minutes the cyclist travels 0.5 × 20 = 10 km. Answer: 10 km. Distractor refutation: 3 km comes from reading off the distance shown at the end of the plotted section (6 minutes) and stopping there, instead of extending the line to 20 minutes. 20 km comes from misreading the speed as 1 km per minute instead of 0.5 km per minute, doubling the true rate. 40 km comes from dividing 20 by the speed instead of multiplying by it, a reciprocal mix-up.
- (d) 300 m — For a constant speed, the speed-time graph is a horizontal line, and the area underneath is a rectangle: distance = speed × time = 15 × 20 = 300 m. Adding the two numbers instead of multiplying gives 35 m; dividing instead of multiplying gives 1.33 m; halving the product, as you would for a triangle, gives 7.5 m — but this section of the graph is a rectangle, not a triangle, so there is no halving to do.
- (b) y = 1/x — A graph with two separate curved branches must have a value of x that is excluded from it, creating a break in the curve. For y = 1/x, x = 0 is excluded, so the graph splits into one branch where x and y are both positive, and one where x and y are both negative. y = x² is a single U-shaped curve with no break, even though it has two 'arms'. y = x³ is one continuous curve that passes through the origin without any break. y = 2x + 1 is a single straight line; even though it passes through regions where x and y share the same sign, it is one continuous line, not two separate branches.
- (a) (−6, −3) — Reflecting in the y-axis changes the sign of the x-coordinate and keeps the y-coordinate the same: (−6, −3). (6, 3) comes from reflecting in the x-axis instead, which changes the sign of the y-coordinate. (−6, 3) comes from reflecting in both axes. (6, −3) comes from not applying the reflection at all.
- (c) x = 3, y = 1 — Method: the y terms are +y and −y, so adding the two equations removes y and leaves an equation in x alone. Working: adding 2x + y = 7 and x − y = 2 gives 3x = 9, so x = 3; substituting x = 3 into x − y = 2 gives 3 − y = 2, so y = 1. Answer: x = 3, y = 1, which also satisfies 2 × 3 + 1 = 7. The distractors: x = 1, y = 3 comes from finding the two values correctly and then writing them against the wrong letters; x = 3, y = 2 comes from substituting x = 3 into 2x + y = 7 as 2 + 3 + y = 7, adding the coefficient instead of multiplying by it; x = 3, y = −1 comes from substituting into x − y = 2 as though it read x + y = 2.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
- (b) (3, 3) and (−1, −5) — Set the two expressions for y equal: x² − 6 = 2x − 3, which rearranges to x² − 2x − 3 = 0. Factorise: (x − 3)(x + 1) = 0, so x = 3 or x = −1. Substitute into the linear equation, y = 2x − 3: x = 3 gives y = 3; x = −1 gives y = −5. The points are (3, 3) and (−1, −5). Distractor routes: (3, 3) and (1, −1) comes from mis-factorising x² − 2x − 3 as (x − 3)(x − 1), giving a second root of 1 instead of −1. (3, 9) and (−1, 1) comes from finding the y-coordinate from y = x² instead of substituting back into the given line equation y = 2x − 3. (3, 3) alone stops after finding only the first root of the quadratic.
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
- (d) 6 — Method: rearrange the formula to make d the subject, then substitute C = 133. Working: C = 25 + 18d, so subtracting 25 from both sides gives C − 25 = 18d, then dividing by 18 gives d = (C − 25) / 18. Substituting C = 133: d = (133 − 25) / 18 = 108 / 18 = 6. The value 7.4 comes from dividing 133 by 18 without subtracting the fixed £25 first (133 / 18 ≈ 7.4). The value 4.6 comes from pairing the numbers the wrong way round, working out (133 − 18) / 25 = 4.6. The value 90 comes from subtracting both 25 and 18 from 133 instead of dividing by 18.
- (b) 319 — Substitute n = 10: 3 × 10² + 2 × 10 − 1 = 3 × 100 + 20 − 1 = 300 + 20 − 1 = 319. A sign error on the +2n term, treating it as −2n, gives 300 − 20 − 1 = 279. Working out 3 × 10² + 2 × 10 but forgetting to subtract the final 1 gives 300 + 20 = 320. Using n = 9 instead of n = 10 gives 3 × 81 + 18 − 1 = 243 + 18 − 1 = 260.
- (a) 3x = 12 — Adding the two equations: the y-terms, +y and −y, have opposite signs, so they cancel; the x-terms combine to 2x + x = 3x; and the right-hand sides add to 11 + 1 = 12. This gives 3x = 12. A candidate who forgets that the y-terms cancel, and instead adds them as if they had the same sign, would write 3x + 2y = 12. A candidate who subtracts the right-hand sides instead of adding them would get 3x = 10. A candidate who correctly reaches 3x = 12 but then treats 12 itself as the value of x, skipping the final division, would write x = 12.
Build your own mix at the worksheet builder.