Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (d) It crosses the x-axis at x = 3 and x = −3. — y = x² − 9 factorises as (x − 3)(x + 3), since 9 = 3², so the curve crosses the x-axis at x = 3 and x = −3. Saying it crosses once at x = 9 mistakes the constant term for a root directly, without taking its square root. Saying it crosses at x = 9 and x = −9 makes the same mistake but adds a sign either way. Saying it does not cross the x-axis confuses the y-intercept, which is negative at (0, −9), with the number of times the curve meets the x-axis — a negative y-intercept combined with an upward-opening curve guarantees it crosses the x-axis twice.
- (b) xₙ₊₁ = (xₙ² + 3) ÷ 5 — Starting from x² = 5x − 3, add 3 to both sides: x² + 3 = 5x. Divide both sides by 5: x = (x² + 3) ÷ 5. Writing this as an iteration gives xₙ₊₁ = (xₙ² + 3) ÷ 5. xₙ₊₁ = (xₙ² − 3) ÷ 5 comes from a sign error when moving the −3 across the equals sign — it should become +3, not stay as −3. xₙ₊₁ = 5(xₙ² + 3) comes from multiplying by 5 instead of dividing by 5 when isolating x. xₙ₊₁ = (xₙ + 3) ÷ 5 comes from dropping the index on x², using xₙ instead of xₙ².
- (b) 6x − 3 = 4x + 9 — Method: multiply every term inside the bracket by the number outside it; the right-hand side stays as it is given. Working: 3 × 2x = 6x and 3 × (−1) = −3, so 3(2x − 1) = 6x − 3. Answer: 6x − 3 = 4x + 9. 6x − 1 = 4x + 9 comes from multiplying only the 2x by 3 and leaving the −1 unchanged. 5x − 3 = 4x + 9 comes from adding the 3 to the 2 instead of multiplying, treating 3 × 2x as (3 + 2)x = 5x. 6x − 4 = 4x + 9 comes from working out 3 × (−1) as −1 − 3 = −4 instead of 3 × (−1) = −3.
- (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (b) 20 — 3x² − 4x = 3(−2)² − 4(−2) = 3(4) − (−8) = 12 + 8 = 20. A candidate who makes a sign error on −4x, treating −4 × −2 as −8 instead of +8, gets 12 − 8 = 4. A candidate who squares −2 but keeps the result negative, using 3 × (−4) = −12 for the first term, but correctly works out −4x = −4 × (−2) = 8, gets −12 + 8 = −4. A candidate who squares the whole term 3x, working out (3 × −2)² − 4 × (−2), gets (−6)² + 8 = 36 + 8 = 44.
- (c) 7n − 1 — Method: find the common difference, then find the constant that fits the first term. Working: 13 − 6 = 7, 20 − 13 = 7, 27 − 20 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 6, so c = −1. Answer: the nth term is 7n − 1. The value 7n comes from leaving out the constant altogether. The value 7n + 6 comes from using the first term as the constant directly, without subtracting the common difference first. The value 6n + 1 comes from using the first term, 6, as the coefficient of n instead of the common difference, and then attaching +1 with the sign of the constant flipped.
- (b) x = −3, y = −7 — x² + 6x + 2 = (x + 3)² − 3² + 2 = (x + 3)² − 7. Substituting x = −3: (−3)² = 9, 6 × (−3) = −18, so 9 − 18 + 2 = −7, confirming the minimum value −7 at x = −3: turning point (−3, −7). Using 6 instead of half of 6 inside the bracket gives (x + 6)² − 34, turning point (−6, −34) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (3, −7) — wrong, because (x + 3)² is zero at x = −3, not x = 3. Computing 9 − 2 = 7 instead of 2 − 9 = −7 flips the sign of the constant, giving (−3, 7) — wrong, since the completed square's constant must be evaluated as 2 minus 9, not 9 minus 2. Always check a turning point by substituting its x-value back into the original equation.
- (b) 10 — Check n = 9: a₉ = 3 × 2⁸ = 3 × 256 = 768, below 1,000. Check n = 10: a₁₀ = 3 × 2⁹ = 3 × 512 = 1,536, above 1,000. So the first term greater than 1,000 is at position n = 10. Answering 9 comes from forgetting the −1 shift and using the formula as 3 × 2ⁿ instead of 3 × 2ⁿ⁻¹: checking 3 × 2⁹ = 1,536 (which exceeds 1,000) but then reporting the position as n = 9, the exponent used, instead of n = 10 — wrong, because the exponent in the real formula is n − 1, not n. Answering 11 comes from going one term too far: correctly finding that a₁₀ already exceeds 1,000, but then checking one position further and reporting n = 11 instead of stopping at the first position that already works — wrong, because n = 11 is not the FIRST term greater than 1,000. Answering 1,536 gives the VALUE of the term (a₁₀ itself) rather than its position — wrong, because the question asks which term it is (the value of n), not what that term is worth.
- (a) y = 2ˣ + 3 — A translation of 3 units in the positive y-direction shifts the whole graph up, which means adding to the output: y = f(x) + k with k = 3, so the image is y = 2ˣ + 3. Adding the 3 inside the power instead of outside it, which translates the graph horizontally instead of vertically, gives y = 2ˣ⁺³. Using a negative 3, which moves the graph down instead of up, gives y = 2ˣ − 3. Mistaking 2ˣ for the linear expression 2x and adding 3 inside brackets gives y = 2(x + 3).
- (d) 12√2 — The nth term of a geometric sequence is a × rⁿ⁻¹. Here a = 3, r = √2, n = 6, so the 6th term is 3 × (√2)⁵. Since (√2)² = 2, (√2)⁴ = (2)² = 4, so (√2)⁵ = (√2)⁴ × √2 = 4√2. The 6th term is 3 × 4√2 = 12√2. 15√2 comes from treating (√2)⁵ as 5√2 — multiplying the index by the surd instead of raising √2 to that power — then multiplying by 3 gives 3 × 5√2 = 15√2, which is wrong because powers of a surd do not scale linearly with the index. 24√2 comes from miscalculating (√2)⁴ as 8 instead of 4 (a squaring slip, since (√2)² = 2 but (√2)⁴ should be 2² = 4, not 2 × 4), giving 3 × 8√2 = 24√2. 4√2 comes from forgetting to multiply by the first term a = 3, leaving just (√2)⁵ = 4√2.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (b) 4 — Adding the two equations: the y-terms, −2y and +2y, cancel, and the x-terms combine to 5x + 3x = 8x; the right-hand sides add to 16 + 16 = 32. This gives 8x = 32, so x = 4. A candidate who adds only one of the right-hand sides, instead of both, would get 8x = 16, so x = 2. A candidate who divides 32 by 4 instead of 8 would get x = 8. A candidate who subtracts the equations instead of adding them, getting 2x − 4y = 0, and then wrongly assumes y = 0, would get x = 0.
Build your own mix at the worksheet builder.