Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) x = 2, y = 3 — Method: no letter cancels straight away, so make one letter the subject of one equation and substitute that expression into the other. Working: 2x + y = 7 gives y = 7 − 2x, so x + 2y = 8 becomes x + 2(7 − 2x) = 8, that is x + 14 − 4x = 8, so −3x = −6 and x = 2; substituting back gives y = 7 − 4 = 3. Answer: x = 2, y = 3, which checks in 2 + 6 = 8. The distractors: x = 3, y = 2 comes from adding the equations to x + y = 5 and then subtracting them the wrong way round, writing x − y = 1 instead of x − y = −1; x = 2, y = 5 comes from substituting x = 2 into 2x + y = 7 as 2 + y = 7, dropping the coefficient; x = −2, y = 11 comes from dividing −3x = −6 as though two minus signs gave a negative answer.
- (c) 3 — Gradient = (change in y) ÷ (change in x) = (11 − 5) ÷ (4 − 2) = 6 ÷ 2 = 3. A candidate who puts the change in x over the change in y instead would get 2 ÷ 6 = 1/3. A candidate who subtracts the y-coordinates in the reverse order, but not the x-coordinates, would get (5 − 11) ÷ (4 − 2) = −3. A candidate who adds the coordinates instead of subtracting them would get (11 + 5) ÷ (4 + 2) = 16/6 = 8/3.
- (a) 8 — Method: rate = height gained ÷ time taken. Working: height gained = 52 − 20 = 32 m, time taken = 4 minutes, so rate = 32 ÷ 4 = 8 metres per minute. Answer: the rate is 8 metres per minute. 32 comes from working out the height gained but forgetting to divide by the time taken. 13 comes from dividing the final height, 52, by the time taken instead of the height gained. 5 comes from dividing the starting height, 20, by the time taken instead of the height gained.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (b) x = 3, y = 4 — −x² + 6x − 5 = −(x² − 6x) − 5 = −[(x − 3)² − 9] − 5 = −(x − 3)² + 9 − 5 = −(x − 3)² + 4. Because the coefficient of x² is negative, −(x − 3)² is at most zero, so this turning point is a maximum. Substituting x = 3 gives (x − 3)² = 0, so y = 4, confirming the maximum value 4 at x = 3: turning point (3, 4). Using 6 instead of half of 6 inside the bracket — forgetting to halve before completing the square — lands on turning point (6, 31), wrong, because only half the coefficient belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−3, 4) — wrong, because (x − 3)² is zero at x = 3, not x = −3. Computing 5 − 9 = −4 instead of 9 − 5 = 4 flips the sign of the constant, giving (3, −4) — wrong, since the constant must be evaluated as 9 minus 5, not 5 minus 9. Whenever the leading coefficient is negative, the turning point is a maximum, not a minimum — check by substituting back into the original equation.
- (d) L/6 − 4 — Method: find the length of one equal piece first (divide by 6), then apply the later change (subtract 4) to that piece. Working: one piece is L/6 metres; removing 4 metres from it gives L/6 − 4. Answer: L/6 − 4. L/6 + 4 comes from adding the 4 metres instead of removing it. (L − 4)/6 comes from removing the 4 metres from the whole rope before cutting it into pieces, the wrong order. 4 − L/6 comes from subtracting the piece length from 4 instead of the other way round.
- (c) 6 km/h — Total distance = 8 + 4 = 12 km. Total time = 1 hour + 0.5 hours resting + 0.5 hours = 2 hours. Average speed = total distance ÷ total time = 12 ÷ 2 = 6 km/h. A speed of 8 km/h comes from leaving the resting time out of the total time: 12 ÷ 1.5 = 8. A speed of 4 km/h comes from dividing by too much time, such as double-counting the rest period: 12 ÷ 3 = 4. A speed of 12 km/h simply gives the total distance and forgets to divide by the total time at all.
- (c) Translate +1 in y; new range 0 ≤ y ≤ 2 — Adding 1 to sin x translates the graph 1 unit in the positive y-direction, and every y-value on the range increases by 1: −1 + 1 = 0 and 1 + 1 = 2, giving a new range of 0 ≤ y ≤ 2. A translation in the x-direction would not add anything to the y-values, so 'Translate +1 in x; range unchanged' correctly leaves the range at −1 ≤ y ≤ 1 for that (wrong) transformation, but the transformation itself is not what y = sin x + 1 shows. 'Translate +1 in y; new range −2 ≤ y ≤ 0' correctly spots the translation but subtracts 1 from each bound instead of adding it. 'Reflect in the x-axis' mistakes the transformation for a reflection rather than a translation; reflecting sin x in the x-axis does leave the range at −1 ≤ y ≤ 1 unchanged in size, but that is not the transformation y = sin x + 1 actually applies.
- (b) −2, −1, 0, 1, 2, 3, 4 — Factorise x² − 2x − 8 = (x − 4)(x + 2), giving roots x = 4 and x = −2. Since the coefficient of x² is positive and the inequality is ≤ 0, the solution is the closed interval between the roots, −2 ≤ x ≤ 4, with the roots included because the inequality is not strict. The integers in this interval are −2, −1, 0, 1, 2, 3, 4. Distractor routes: −1, 0, 1, 2, 3 drops both endpoints, treating ≤ as if it were the strict inequality <. −2, −1, 0, 1, 2, 3, 4, 5 comes from mis-factorising as (x − 5)(x + 2), giving an upper root of 5 instead of 4. −3, −2, −1, 0, 1, 2, 3 comes from mis-factorising as (x − 4)(x + 3), giving a lower root of −3 instead of −2.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
- (d) k < 4 — Method: the number of real solutions of ax² + bx + c = 0 is decided by the discriminant b² − 4ac, and two different real solutions need it to be greater than zero. Working: here a = 1, b = −4 and c = k, so b² − 4ac = 16 − 4k; the condition is 16 − 4k > 0, which gives 16 > 4k and then k < 4. Answer: k < 4; for example k = 3 gives x² − 4x + 3 = 0, whose solutions are 1 and 3. The distractors: k ≤ 4 comes from using b² − 4ac ≥ 0, which also allows the single repeated solution at k = 4; k > 4 comes from dividing −4k > −16 by −4 without reversing the inequality sign; k < 16 comes from leaving the factor 4 out of 4ac and solving 16 − k > 0.
- (a) −2 m/s² — The gradient of a line through two points is the change in the y-value divided by the change in the x-value: (6 − 22)/(16 − 8) = −16/8 = −2 m/s². The negative sign confirms the deceleration mentioned in the question. Writing 2 m/s² comes from subtracting the velocities in the wrong order, using (22 − 6) instead of (6 − 22), which loses the sign that shows the car is slowing down. Writing −0.5 m/s² comes from inverting the fraction, dividing the change in time by the change in velocity instead of the other way round. Writing −16 m/s² comes from finding the change in velocity, −16, but forgetting to divide by the change in time, 8 seconds.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (d) x = 2 — Method: expand the bracket by multiplying both terms inside it by 2, then undo the addition and the multiplication in turn. Working: expanding gives 2x + 6 = 10; subtracting 6 from both sides gives 2x = 4; dividing both sides by 2 gives x = 2. Answer: x = 2. The distractors: x = 5 comes from dividing both sides by 2 first, reaching x + 3 = 5 and writing 5 without taking the 3 away; x = 8 comes from adding 6 to both sides instead of subtracting it, giving 2x = 16; x = 3.5 comes from expanding 2(x + 3) as 2x + 3, multiplying only the x by the 2, which leads to 2x = 7.
Build your own mix at the worksheet builder.