Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 6 — Method: write an expression for each person's savings after w weeks, and set them equal. Working: 40 + 6w = 10 + 11w. Subtract 6w from both sides: 40 = 10 + 5w. Subtract 10: 30 = 5w, so w = 6. Answer: 6 weeks. 0 comes from setting only the weekly amounts equal, 6w = 11w, and ignoring the different starting amounts entirely. 10 comes from adding the two starting amounts and dividing by the difference in weekly amounts, (40 + 10) ÷ (11 − 6), instead of forming and solving the correct equation. 1.76 comes from adding the two weekly amounts instead of subtracting them when rearranging, (40 − 10) ÷ (11 + 6).
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (d) Below y = x + 1, below x + y = 5, above y = 0 — For y ≤ x + 1, R lies on or below the line y = x + 1. For x + y ≤ 5 (that is, y ≤ 5 − x), R lies on or below that line too. For y ≥ 0, R lies on or above the x-axis. Combining all three: R is below y = x + 1, below x + y = 5, and above y = 0. Distractor routes: "Above y = x + 1" flips the first inequality, describing the wrong side of that line. "Above x + y = 5" flips the second inequality, describing the wrong side of that line. "Below y = 0" flips the third inequality, describing the wrong side of the x-axis.
- (c) 4.30 — Method: substitute the starting value into the right-hand side to get x₁, then feed each value back in, keeping the whole display and respecting the order of operations, which divides before it subtracts. Working: x₁ = 5 − 3 ÷ 2.5 = 5 − 1.2 = 3.8; x₂ = 5 − 3 ÷ 3.8 = 5 − 0.78947… = 4.21052…; x₃ = 5 − 3 ÷ 4.21052… = 5 − 0.7125 = 4.2875; x₄ = 5 − 3 ÷ 4.2875 = 5 − 0.69970… = 4.30029…, which is 4.30 correct to 3 significant figures. Answer: 4.30. The distractors: 4.29 is x₃ = 4.2875 rounded, reached by counting the starting value itself as the first iterate and so stopping one use of the formula early; 3.80 is x₁, the value after a single use of the formula; 2.50 comes from working out (5 − 3) ÷ xₙ instead of 5 − (3 ÷ xₙ), subtracting before dividing, which produces the sequence 0.8, 2.5, 0.8, 2.5 and lands on 2.5 at the fourth step.
- (c) Wrong — the product is −4/25, not −1. — The student's rearrangement is correct: 5y = −2x + 15 gives y = −(2/5)x + 3, gradient −2/5. But the test for perpendicularity is that the product of the two gradients equals exactly −1, not merely that it is negative. Here 2/5 × (−2/5) = −4/25, which is not −1, so the lines are NOT perpendicular. Distractor routes: "a negative product always means perpendicular" states a rule that does not exist — many pairs of lines have a negative gradient product without being perpendicular, as this pair shows. "The rearrangement is incorrect" wrongly blames a correct step; 5y = −2x + 15 does rearrange to y = −(2/5)x + 3. "2/5 and −2/5 are negatives of each other" notices a true but irrelevant fact — being negatives of each other is not the perpendicularity condition; an exact product of −1 is.
- (d) 12 — Since a₃ = a₂ + a₁, rearranging gives a₂ = a₃ − a₁ = 17 − 5 = 12. 22 comes from adding instead of subtracting: a₃ + a₁ = 17 + 5 = 22. 11 comes from treating the sequence as if it were arithmetic and averaging the two given terms: (5 + 17) ÷ 2 = 11 — but a Fibonacci-type sequence isn't arithmetic, so this doesn't apply. −12 comes from subtracting in the wrong order: a₁ − a₃ = 5 − 17 = −12.
- (c) 3 — Gradient = (change in y) ÷ (change in x) = (11 − 5) ÷ (4 − 2) = 6 ÷ 2 = 3. A candidate who puts the change in x over the change in y instead would get 2 ÷ 6 = 1/3. A candidate who subtracts the y-coordinates in the reverse order, but not the x-coordinates, would get (5 − 11) ÷ (4 − 2) = −3. A candidate who adds the coordinates instead of subtracting them would get (11 + 5) ÷ (4 + 2) = 16/6 = 8/3.
- (c) (2, 5) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: Q = (2, 5). (−2, −5) comes from reflecting in the y-axis instead, which changes the sign of the x-coordinate. (−2, 5) comes from reflecting in both axes. (2, −5) comes from not applying the reflection at all.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (d) The cost increases by about £10 per extra item — Gradient = change in cost ÷ change in items = (800 − 400) ÷ (70 − 30) = 400 ÷ 40 = 10. The units of the gradient are £ per item, so the cost is increasing by about £10 for every extra item produced, near x = 50. Subtracting in the wrong order, (400 − 800) ÷ (70 − 30) = −10, gives the right size but the wrong sign — check which point comes first each time. Leaving out the division by 40 gives £400 per item; dividing the wrong way round, 40 ÷ 400 = 0.1, gives £0.10 per item.
- (d) 11 — f⁻¹(x) = 5 means x = f(5), since applying f to both sides undoes the inverse. f(5) = 2 × 5 + 1 = 11. Writing 2 comes from confusing f⁻¹(x) = 5 with f(x) = 5, and solving 2x + 1 = 5 instead: 2x = 4, x = 2. Writing 9 comes from finding f⁻¹(x) with a sign error, f⁻¹(x) = (x + 1)/2 instead of (x − 1)/2, then setting this equal to 5: x + 1 = 10, x = 9. Writing 6 comes from finding f⁻¹(x) without dividing by 2 at all, f⁻¹(x) = x − 1, then setting this equal to 5: x = 6.
- (c) x + 3 — Expand the bracket: 0.5(4x + 6) = 2x + 3. Then subtract the x: 2x + 3 − x = x + 3. The option 2x + 3 comes from expanding the bracket correctly but then forgetting to subtract the x at all. The option x + 6 comes from forgetting to multiply the 6 inside the bracket by 0.5 (treating it as 2x + 6), then subtracting x. The option 3x + 3 comes from adding the x instead of subtracting it: 2x + 3 + x = 3x + 3.
- (a) 23 — The number of logs increases by 4 for each layer down, starting from 3 in the top layer, so the nth layer has 3+(n−1)×4 logs. For the 6th layer: 3+5×4=3+20=23. A candidate who adds the difference of 4 six times instead of five, treating the top layer as needing an addition too, would compute 3+6×4=27. A candidate who uses 4n instead of 4n−1, omitting the adjustment for the first layer, would compute 4×6=24. A candidate who subtracts the common difference, 4, instead of 1 when adjusting the multiplier would compute 4×6−4=20.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
Build your own mix at the worksheet builder.